Find the current in the mian branch and V. AB

Q: Q18 Find the expression for the output of the logic circuits shown in Figure below. A B D - F

A: We need to find out Boolean expression for given logic diagram.

Q: .: Find the transfer function of the following block diagrams R(s) + G₁ G₂₁ + H₂ H₂ H₁ G₂ H₁ G₁ Y(s)

A: Given:a system, To find:System transfer function using block diagram reduction.

Q: A string of Suspension Insulators consists of 8 units. If the Voltage across the string is 44 KV and…

A:

Q: 14. For the RLC circuit shown L₁ 103mH, R₁ = 13602, C₁= 16.7μF, Em = 6.78V, = L₂= 203mH, R₂ = 10002,…

A: Given Data:An RLC circuit with,Input peak voltage Supply frequency To Find:The expression of .The…

Q: V Calculate R1 and R2 (a) = 0.05 (b) R = 40k eq (a) vo/vs = 0.05 (b) Req = 40kN R₁ ww Vs Req R₂ + Vo…

A: Given circuit,Asked to find the values of

Q: What’s a complex example of an Inverting Amplifier

A: An inverting op amp is an operational amplifier circuit with output voltage and input voltage are…

Q: A 100 kVA, 2500/125V, 50Hz, step down transformer has the following parameters: RH = 1.5 Ω, Χμ = 2.8…

A: Given information,Rated output  kVA.Induced EMF ratio  Volts.So turns ratio is .Supply frequency…

Q: The voltage vo is? 6 V OV 6V 1V 3V 4V 12V 2V + 4 ΚΩ www 2 ΚΩ + Vo 10

A: We need to find out output voltage for the given circuit.

Q: Find the node voltages & calledor current. Which Region is the BJT operating in? -15/02 5105 P=100…

A: The question is about finding node voltages, collector current and operating region of the…

Q: Build the OR gate and label the inputs and outputs. This needs to be done in Logism, or can be hand…

A: The OR gate truth table needs to be derived and the same has to be designed in the logisim…

Q: 2. Calculate the IB, IC, le and the VCE for a common-emitter circuit. (VBB = 4 V, RB = 220 k2, Rc =…

A: In this question, we need to determine the currents and voltage VCE  for common emitter circuit.

Q: In the circuit given below, R= 15 Q. Find the current io. 492 60 V www R www 2Ω 3io 8 Ω The value of…

A:

Q: configuration. Given the following function, F (a, b, c, d) -Em (0,1,2,5,6,7), find the alternate…

A: The given problem is with digital circuits The problem can be solved by using k-map. The detailed…

Q: 3. Find the Thevenin equivalent circuit between the output terminals A and B of the given circuit.…

A: Find the voltage across the A-B terminal: There is no current in the resistor of 100 ohm (R4) .

Q: VI 12V OV 1k0 1k0 RS R3 1k0 Figure 1: Circuit 1. 140 R2 1. Determine the total equivalent resistance…

A:

Q: The switch in the circuit below has been in the left for a long time before moving right t = 0 and…

A: Since you have posted a question with multiple subparts, we will provide the solution only to the…

Q: 4. Derive the transfer function, H(f) = Vou / Vin and draw the asymptotic(approximate) Bode…

A: For the given circuit the transfer function of the circuit needs to be calculated, type of filter…

Q: Determine the voltage dropped across R₂, given: E₁=194 V, R₁ = 17 Q, R₂ = 41 Q₁ R²₂ = 36 , and R₁ =…

A: For the given circuit the value of the voltage drop across the resistor R3 needs to be calculated.

Q: Simplify the following logic function using Quine-McCluskey method (tabulation method). Then draw…

A: The given logic function is F(A,B,C,D)=Π(0,2,3,5,7,11,15) & 1,9,10 are don't cares. (Max terms…

Q: Find the transfer function of the following block diagrams. R(s) G₁ H₁ G₂ H₂ Hs GA G3 G5 'Y(s)

A: Given block diagram,Asked to find the transfer function of the above block diagram

Q: Find the closed loop poles and the natural frequency of the following system R(S) E(s) (5+1) 1 (5+3)…

A:

Q: Simplify the following logic function using Quine-McCluskey method (tabulation method). Then draw…

A:

Q: Derive the equation? -12 over Shoot = A VT-4²

A:

Q: What’s a complex example of a Non-Inverting Amplifier?

A: According to the question, we need to discuss a complex example of a non-inverting amplifier.

Q: 50v Find 2052 ? ? Lc (t) ? T = RC Vects v8 w ¿ 2=72²3 20 Ec(t = ∞0) ? teo czam F

A:

Q: Find i (00). Express your answer to three significant figures and include the appropriate units.…

A: The given circuit isWe need to findE. io(∞).F. iL(∞).H. vL(0−).I. vL(0+).

Q: PROBLEM 4 6cos (106) [v] Acr 0TH FOIF 12 FIND: 1) Ze CORRESPONDING MAXIMUM TRANSER TO AVERAGE POWER…

A: Given Data:An AC circuit with,Supply voltage  or Angular frequency Inductance Capacitance To Find:…

Q: Consider a MOS device with a p-type silicon substrate with N₁ = 1 X 10¹4 cm-³. The oxide Na…

A:

Q: For the next four items, consider the circuit shown below that is assumed to be operating at 1 kHz.…

A:

Q: If the total resistance of the circuit is 124 ohms, determine the value of R₁, given: R₁ = 124, R₂ =…

A: Given an electrical circuit with the following data:asked to find the value of R1.

Q: Calculate the required Q of a filter to convert DSB to SSB, given that the two sidebands are…

A: We are given,Wherefc= Carrier frequencyΔf=sideband seerationS=sideband supression

Q: NOTE: You would have to clearly mark out the cut-off frequencies and the slopes of the magnitude…

A:

Q: (1) G(s) = 5-2 5+2

A: The question is about drawing a Bode plot of G(s).Given, G(s) = (s-2) / (s+2)

Q: Determine the energy stored in capacitors and inductors under DC conditions:  WL1, WL2, WC1, WC2

A: The given circuit isWe need to find the energy stored in capacitors and inductors under DC…

Q: You are given the following distribution of two point charges Q₁ and Q₂. Y [m] 7 6 5 Сл 4 3 2 1 Q₁:…

A:

Q: K Given G(s) = (s+1)(s+3)(s+6)² For this system, create a root locus plot. a. Find the value of gain…

A: The open-loop transfer function of a unity-feedback system H(s)=1, is given…

Q: Design a combinational circuit that compares two 2-bits numbers using a truth table according to: 1)…

A:

Q: 10. Using Ohm's law calculate a value for 11

A: In the given circuit the value of the current I1 needs to be calculated by using the ohm's law.

Q: This circuit represents a small signal amplifier.If C1= 1.5 µF, C2= 0.43 μF Assuming the transistor…

A: The amplifier circuit is given ashere

Q: Consider two equal point charges q, separated by a distance 2a. Construct the plane equidistant from…

A: To calculate the force-:We have  two equal point charges q. separated by a distance 2a. Construct…

Q: Find the current ix (in mA): 44 mA R ix 10ix

A:

Q: Problem 4. We need to allocate requirements to a parabolic antenna gimbal system and spacecraft. Our…

A: For a parabolic antenna, the following information is given:aperture size D=1 m,transmission…

Q: a. Find the value of L in millihenries if the resonant fre- quency is 1800 Hz. b. Calculate X₁ and…

A:

Q: Problem 1. For the linear transformer circuit assume v(t), = 1Vms cos(cot), operated at a frequency…

A: Given Data:A mutually coupled circuit with,Supply voltage Self inductances Mutual inductance Load…

Q: Question #10: The transfer function of a system is given by the following expression: TF (W) =…

A: The given transfer function is shown below..The input is shown below..The phasor form of the input…

Q: Derive the equation and find the equation of q ? MP-CXP [-X₂ / √₁-{²]

A:

Q: B. Derive an expression for the lower and upper threshold voltages of Schmit trigger. Sketch the…

A:

Q: In the circuit shown in Figure P4.a, the switch is closed at t = 0. The capacitor voltage is charged…

A:

Q: Question: If vs(t)= 0.01 sinot, calculate id (t) by using Modified Ideal Diode Model (V-0.7V) (n=1,…

A:

Q: a) Complete the following Table Q.1a. All numbers are 8 bits. + Decimal -103 Table Q.1a Signed…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Voltage Division Method

In the electronics branch, a voltage divider is required to produce a section of its input voltage as an output. This basic circuit may be prepared with two resistors or any passive elements along with the voltage source. The circuit resistors are attached in series and a voltage source is braced across these resistors. The input voltage can be transferred between the resistors in the circuit for the voltage division to occur. The SI unit of electrical resistance is ohm (Ω) or kilo-ohms (kΩ).