Find the charge on the capacitor in an RLC series circuit where L = 2 H, R = 24Ω, C = 0.005 F, and E(t) = 12sin10t V. Assume the initial charge on the capacitor is 0.001 C and the initial current is 0 A.

Find the charge on the capacitor in an RLC series circuit where L = 2 H, R = 24Ω, C = 0.005 F, and E(t) = 12sin10t V. Assume the initial charge on the capacitor is 0.001 C and the initial current is 0 A.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 15RQ: A postage stamp capacitor has the following color marks starting at the upper-left dot: black,...

See similar textbooks

Related questions

Q: Q3) Design a three-section binomial transformer to match a 40N load to al502 transmission line, and ...

Q: 1. Kirchhoff's Current Law is a restatement of conservation of charge & Kirchhoff's Voltage Law is a...

A: Given circuit shown

Q: A 3.phase, star.connected,50HZ alternatorhas 96 conductorsperphase and a flux/pole 0.1 Wb.The altern...

A: It is given that: Frequency=f=50 HzConductors per phase=Zph=96 Flux/pole=ϕ=0.1Xs=5 Ω/phRL=10 Ω/phDis...

Q: Partial shading is a problem that affects the performance of solar modules. Lets imagine a solar mod...

A: Given Cell open circuit voltage =0.62 V Cell short circuit current =8.8 A total cell=8 (4 x 2)

Q: Calculate Total Resistance

A: This question belongs to circuit theory . It is based on the calculation of equivalent resistance of...

Q: 24.) Using Thevenin's Theorem, determine the equivalent resistance as viewed through the terminals B...

Q: A certain current lags the voltage by 36 electrical degrees. The voltage waveform is increasing posi...

A: We need to find out time and voltage for given condition .

Q: Rz Ri vina VX derive )

Q: Vx - vin i. RI Jwci VX -Ve R2 Vo = V2 = V de vive vi

Q: the parallel connection of a resistor and a capacitor takes 0.6 A rms from a 120 V rms voltage sourc...

Q: p 12 V 3 k2 470 k2 10 μ 20 µF B = 100 R, + 0.3 kΩ + Z, RL 4.7 k2

A: We need to find voltage gain and current gain for given circuit

Q: An N-channel JFET has IDSS = 16 mA and VP= -6 volts. Calculate the drain current and VDS (sat) when ...

A: JFET An N-Channel JFET consists of electrons as the charge carrier that constitutes the current flow...

Q: determine if its DELTA- DELTA CONNECTION OR WYE- WYE CONNECTION

Q: Solve the following system by any method 211 - 12 + 313 + 514 = 21 1 - 213 + I4 = -1 51 - 512 + 13 +...

A: This problem comes under basic electrical. It is about calculation of unknown variable by using give...

Q: Review | Constants Reset Help The three bulbs in (Figure 1) are identical. All are glowing. series S...

Q: 9. A 30 ohm resistor is connected in parallel with a 0.106 H inductor. The parallel combination is t...

Q: A 50 and 100 microfarad capacitors are connected in series and across 100sin(w+30) voltage. Write th...

Q: Not more than ____ ft of high-voltage cable shall be permitted in nonmetallic conduit from a high-vo...

A: The following is a list of some of the requirements for neon design by National Electric Code(NEC): ...

Q: Construct 2 to 4 line decoder using NOR gates with enable and truth table ?

A: 2 to 4-line decoder The A and B are 2 binary inputs decoded into 4 outputs is known as 2 to 4-line ...

Q: 10 V 8 kN 2.5 kN The variable resistor is to (+) be adjusted to transfen 20 kN maximum power to ho. ...

A: This question belongs to circuit theory . It is based on the concept of maximum power transfer theor...

Q: Solve the following system by any method 211 - 12 + 313 + 514 = 21 I - 213 + 14 = -1 511 - 512 + 13 ...

A: From second equation the value of I1 is given as: I1=-1+2I3-I4 (1) We will substitute the va...

Q: [5] The conductor becomes incandescent due to the thermal effect of the current. O the chemical effe...

A: The conductor becomes incantation due to given below method.

Q: A 4-kW, 110-Vrms load, as shown below, has a power factor of 0.82 lagging. Find the value of the par...

Q: Q3. Draw the output waveform for the circuit shown below. 20 V 20 V

Q: 3. Obtain the power factor of circuit.Specify the power factor as leading or lagging -j1N ww 10 j22 ...

Q: 1. A series circuit consisting of a 40-ohms resistor, a 100-μf capacitor, and a variable inductor is...

Q: 10 %3D r2 The potential equation is given by V =sin 0 cos p. (a) Find the electric flux density at (...

Q: 33.) Apply Kirchhoff's current law and voltage law to the circuit shown below to identify the branch...

A: Kirchhoff’s current law: In the circuit, the path is closed then at any point sum of current with th...

Q: dc power shall be supplied by a listed dc power supply with a maximum output of ____ volts

A: A DC supply of power is a form of electrical source that provides a device with direct current (DC) ...

Q: 20 kΩ 60 kΩ 20 kΩ + 20 kΩ 100 kΩ 20 kΩ Vz 60 kΩ |Vy 20 kΩ Vw 20 kΩ 20 kΩ

Q: Modulation is the process of modifying a base signal with a carrier signal, and it is used mostly in...

A: Given, In frequency modulation Carrier frequency (fc) = 570 kHz Amplitude of carrier signal (Ac) =...

Q: Identify and explain the different notational methods for describing the behavior of gases and circu...

A: Gates: It is an electronic circuit and has logical decisions based on applied input.

Q: The maximum value of the sinusoidal voltage wave generated in one coil of an alternator is 25 volts....

A: Maximum value of alternator is, Vm=25 V Writing the voltage expression at any time t. Vt=Vmsinωt Vt=...

Q: single-pole portable cable connectors for a portable switchboard on stage, where used, shall be list...

A: single-pole portable cable connectors for a portable switchboard on stage, where used, shall be list...

Q: For the given network, calculate the resistance R3 if the current through it is 2A. R 12 n 120 V: 2 ...

Q: 20 kQ 60 kQ ww 20 kΩ + Vx 20 kQ 100 kQ 20 kQ Vz 60 k2 Vy 20 kQ Vw 20 kQ 20 k2

A: We need to find out output for given op amp circuit .

Q: The electric motor operation is based on:

Q: B1 A single-phase, 50 Hz transformer has 30 primary turns and 420 secondary turns. The cross- sectio...

Q: (2) A certain alternating voltage is described by the equation : v = 170 sin 628 t volts = Vp sin wt...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for ...

Q: to the primary side. Question # 3 The coils of the magnetic circuit shown in the figure are connecte...

Q: A sinusoidal current wave has an instantaneous value of -20 A at t = 0 and s increasing negatively. ...

Q: Identify three common simple electrical gadgets/devices at home after which: 1. propose a new/revise...

A: Nowadays, With the evolution of very compact power electronics devices and controllers, we are surro...

Q: A transmitter delivers 50 W into a 600 Ω lossless line that is terminated with an antenna that has a...

A: Brief description : Transmission line is a medium where we can transmit electromagnetic waves throug...

Q: 20 V 470 2 270 k2 VB B=125 180 VE 2.2 k2

A: We need to find out current and voltage for given circuit

Q: The current I in the circuit shown is 2V. 205 20 2V 2V

A: Given circuit:

Q: A 30 ohm resistor is connected in parallel with a 0.106 H inductor. The parallel combination is then...

Q: RI t R2 DiA

Q: V2 7 R3 R4 10 V1 5 R1 R2 20 15

A: We need to find out current through the given resistance

Q: An impedance of 12 – j7W, an inductor having a susceptance of 0.225 mho, a capacitor having a suscep...

A: In this question, impedance of 12 – j7W, an inductor having a susceptance of 0.225 mho, a capacitor...

Q: Design a 3 bit Binary Adder Subtractor and explain it with the help of an example.

A: Binary Adder and subtractor- It is a combination of 4 full adder. It is available for the both oper...

Question

Find the charge on the capacitor in an RLC series
circuit where
L = 2 H,
R = 24Ω,
C = 0.005 F, and
E(t) = 12sin10t V. Assume the initial charge on the
capacitor is 0.001 C and the initial current is 0 A.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

List the five capacitor replacement rules.
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
In an RLC parallel circuit, the resistor has a resistance of 60 , the inductor has a reactance of 180 , and the capacitor has a reactance of 80 . Find the circuit power factor.
An RLC parallel circuit has an apparent power of 400 VA. The inductor has a reactive power of 450 VARs, and the capacitor has a reactive power of 200 VARs. Find the true power or watts.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
You have a capacitor that's discharging through a resistor toward zero voltage. How many times RC must you wait for the capacitor to be more than 99% fully discharged?
The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW
In a circuit, there is a series connection of an ideal resistor and an ideal capacitor. The conduction current (in Amperes) through the resistor is 2sin(t+ n/2). The displacement current (in Amperes) through the capacitor is
B R-2000 Q Consider the following RC circuit with an unkown capacitance C. In this circuit, the capacitor charges when the switch is connected to B and discharges through the resistor when the switch is connected to А. The voltage across the capacitor decreases with time when the capacitor discharges. The following table shows the voltage across the capacitor from t = 1s to t= 10s during its discharge in an RC circuit experiment. t (s) 1 2 | 3 4 7 9 10 V(V) 9.4 7.31 5.15 3.55 2.81 2.04 1.26 0.97 0.74 0.58 Use Matlab/Octave to do the following: *In all graphs add title, legend and axis labels 1. Estimate the time at which the voltage V=5.0 V. 2. Estimate, using spline interpolation, the voltage V1 corresponding to 30 different values of time, t between 1 to 10s. 3. You can calculate the current in the circuit using Ohm’s law (I= V/R) at each time, 1 Using the interpolated voltage data in (2), calculate the current at each time. 4. From the current () versus time data in (3), calculate…
Problem 1: The capacitor is initialy uncharged. The switch is closed at t-0. Find the following: C- 50 uF 1. The time constant 2. The voltage of the capacitor at 0.1s. 3. The voltage of the capacitor at 2.5. V35 V