Find Ip in A (ampere) unit if E=9V, internal resistance Rp=43.3, and R=4582. (Answer should roundoff to 3 decimal places) + Vp Rp Ip + R VR E

Q: A kilometer of wire having a diameter of 11.7 mm and a resistance of 0.031 ohm is drawn down so that...

A: The answer is 0.93 Ω The first cross section is (π/4)*(11.7)2 = 107.5sq.mm. The second is: (π/4)*(5)...

Q: 10 KN 20 KN / m 5 KN / m A B SIMPLE STRESSES 5 KN / m D 50 KN-m 5 KN / m F 3. Points C and D of the ...

A:

Q: What is the value of the power which is absorbed by each resistor?

A:

Q: What is the instantaneous current at t=1 sec, if a 20 micro-farad capacitor was charged with 10 cos2...

A: It is given that: C=20 μFE=10cos2377tt=1 sec

Q: At what potential should the cyclical sweep begin? O open circuit potential O anodic peak potential ...

A: Answer 9- Cyclic voltammetry (CV)is performed by cycling the potential of a working electrode, and m...

Q: The following system of equations was generated by applying the mesh current law to the circuit in t...

A:

Q: 9.3 A Si sample is doped to 2.5×10º cm³ with P (phosphorus) not P-typ a. Where does E; lie with resp...

A: For a doped - silicon, ND=2.5×1016 cm-3   

Q: Find v(t) and i(t) in the circuit shown.

A:

Q: Design the circuit in the box to perform the function indicated in figure below Silicon diodes 10 V ...

A: Silicon diode- Silicon diode is a diode which have both charge polarity and allow current to pass th...

Q: The AC signal described by the function v(t) = -10 sin (wt – 250°) is the same as ... A) 10 cos (wt ...

A: We can get the above solution by comparing it with standard AC sinusoid equation. That is V(t)= Vm.S...

Q: Q8. Explain briefly the application / use of Capacitor 1 and Capacitor 2 in the circuit shown in Fig...

A: Capacitor: This is used to store the energy in electric form.

Q: 5.a.Which organization determines allowable maximum fill ratios for different cables? A. IEEE B. IEC...

A: "Since you have asked multiple question, we will solve the first question (5 a) for you. If you want...

Q: Describe how the circuit works 1A1 1V2 1V1 1S1 LAW W TH

A: Fluid power applications include pneumatics and hydraulics. Hydraulics uses relatively incompressibl...

Q: A coil has a resistance of 24 Ω at 50°C and 32 Ω at 120°C. Find the resistance at 0°C and the temper...

A:

Q: A 6000kVA, 6,600-volt, Y-connected, 2-pole, 60Hz turbine driven alternator. At rated load with unity...

A:

Q: In a BJT, the value of β=244 and IB=0.05mA. Solve for IE  in mA

A: This question belongs to analog electronics . It is based on the relation in different currents of B...

Q: Find the equalizer transfer function for the given channel transfer function. arg H) Channel Equaliz...

A: Given the block diagram as shown below: Given the channel transfer function plot as shown below:

Q: Solve for Vo and ID +8 V 1.2 ka 4,7 k2 Id=Blank 1 mA at least 2 decimal place Vo=Blank 2 V at least ...

A:

Q: What is Ideal Diode, Simplified Diode and Piecewise Linear Diode

A:

Q: 10 V 12 V -8 V

A: In this circuit we find the voltage at the terminal of diode. Applying kvl in clock wise direction,a...

Q: Shaa that un)= U,cnti)-24r(n)+U (n-1

A:

Q: 1 Ohm 2 Ohms 4 Ohms 4 Ohms ELECTONICS HU acov A07 H Ohms m

A:

Q: R1 A R4 150 80 R3 R2 V1 200 100 80Vpk 60HZ 30° L3 C2 20H =12µF C1 L2 R6 HH IC 12µF D 20H 10Ω R5 -10Ω...

A:

Q: A series generator having a combined armature and field resistance of 04. Ohms is running at 1000 rp...

A: It is given that: N1=1000 rpmN2=1500 rpmVt1=110 VP1=5.5 KW=5.5×103 WP2=10 KW=10×103 WRa+Rse=0.4 Ω   ...

Q: Get the phase of the AC signal defined by c(t) = 2 sin (wt + 70°) %3D

A:

Q: Find the transfer function of the following differential equation: d?y 1. dt2 dy dx +11+ 24y(t) = 5+...

A: In this question,  We need to determine the transfer function?  If differential equation is given.  ...

Q: 4. For each of the following statements, determine whether it is true or false. If you think it is t...

A:

Q: Si Ge 4,7 ka 1.2 ka +12 Vo -10 V K K Ge 3.3 k2 (a) (b)

A:

Q: Three motors are operating in sequence with the following conditions: 1. Start Pushbutton (10.0) is ...

A: It is asked to draw a diagram for the operation of three motors Q.0, Q.1 and Q.2 in a sequence. So w...

Q: 14.a. Where should fiber optic cables that are fixed in cable trays be installed? A. In riser spaces...

A:

Q: PROBLEM 2 Consider a series RLC circuit with R = 25 N, L = 6 mH, and C = 25 µF. The circuit is conne...

A:

Q: Modulator is a term used to describe any device that converts signals.explain

A: For the wireless transmission of the signal, the signal message signal must be amplified and must be...

Q: Find the value of the following Wilkinson's Factor: 8,

A: In this case, the value of the following Wilkinson's factor is to be determined: W84

Q: current

A: Diode Ideally, diode is open circuited when reverse biased and short circuited when forward biased.

Q: A resistor and a capacitor are connected in series across a supp 250V. When the supply frequency 50H...

A: Given  The resistor and capacitor are connected in series Supply voltage V=250 v frequency  is 50 Hz...

Q: 2. A square surface area with side length of 2cm is in the yz plane at x=0, Find the magnitude of th...

A: The area vector, A = 2x2cm2 ax = 4 cm2 ax​​​​​​ Magnetic Field, B = ax-2​​​​​​ay+3az​​​​​​ Magnetic ...

Q: Find the two elements in a series circuit (i.e., R an

A:

Q: R1 R4 150 80 R2 100 R3 200 V1 V2 Ic 20Vpk }60HZ 30° 15Vpk 60HZ 15° [13 20H C2 12µF

A:

Q: 2. f(t) = cos25t – e5t sin5t SO:

A:

Q: Q3/ A- Design a logic circuit using only NOR gates to implement: F(A,B,C)= (A+B+C)(A+B+C)?

A: The given boolean expression is: FA, B, C=A+B+CA+B+C  

Q: Voltage to Current Converter with Floating Load (In phase)   Design a Voltage to Current Converter...

A: Given: For a Voltage to Current Converter with Floating Load, assume that a 10 V input voltage with ...

Q: A 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a 2...

A: In this question,  A inductor is connected to the parallel of the series R and C.  If current in the...

Q: If a cell has an E.M.F of E volts, an internal resistance of r ohms and supplies A current I ampere ...

A:

Q: Given the plot below, determine the amplitude, duty cycle and period Figure 1 Fle Edit View Insert T...

A:

Q: Find the complex power supplied by the source and the power factor of the source for the network sho...

A: The solution can be achieved as follows.

Q: Determine the currents 1, 12, and ID2 for the network. RI 3.3k2 Si Di 20 V Si D2 12 R2 5.6 ka

A:

Q: The following system of equations was generated by applying the mesh current law to the circuit in t...

A:

Q: Q1. Which among the four choices is not true in using a voltmeter. a) Always connect voltmeter in pa...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: 12.0V R5 10000 C3 R1 1µF R6 1000000 10000 Q2 Č1 R3 1500000 5µF R2 100000 V1 5Vpk 1kHz 0° R4 C2 :4pF ...

A:

Q: 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a 20-...

A:

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.