Ex-2-: In a levelling process the readings were recorded as following: (1.349, 1.723, 1.522, 1.634, 1.542, 1.773, 1.829 m). If the Level instrument was relocated after the fourth reading and the level of the fourth point was (30 m). Calculate the elevations of the other points and do check your calculations.

Ex-2-: In a levelling process the readings were recorded as following: (1.349, 1.723, 1.522, 1.634, 1.542, 1.773, 1.829 m). If the Level instrument was relocated after the fourth reading and the level of the fourth point was (30 m). Calculate the elevations of the other points and do check your calculations.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q4: a. The following readings were observed successfully with a leveling instrument. The instrument was shifted after 5th and 11th readings. Draw a page of level book and determine the R. L's of various points by H.I method if the R.L of 1" point was 264.250 m. [CLO-3, Marks-20] 0.485, 1.020, 1.787, 3.395, 3.875, 0.360, 1.305, 1.785, 2.675, 3.385, 3.885, 1.835, 0.435 and 1.705
Complete the following level notes. Show your detailed solution and checking. Differential Leveling Station BS HI FS Elevation BM1 1.050 ---- 147.630 TP1 1.224 1.923 TP2 1.276 1.481 TP3 1.087 2.290 TP4 1.162 2.140 TP5 1.751 2.700 BM2 ---- 2.565
A line of levels was run from station A to station B. The leveling was continued to a BM of elevation 40 m. The stadia readings were obtained as follows. What is the elevation of station A? What is the elevation of station B? BS HI FS IFS ELEV REMARKS 1.195 A 0.445 2.370 2.150 0.995 0.720 B 1.465 0.260 2.630 0.905 1.305 40.00 BM Choices: 37.655 m 37.523 m 37,950 m 38.201 m
Complete the following level notes. Show your detailed solution and checking. Differential Leveling Station BM1 ΤΡΙ TP2 TP3 TP4 TP5 BM2 BS 1.050 1.224 1.276 1.087 1.162 1.751 HI FS - 1.923 1.481 2.290 2.140 2.700 2.565 Elevation 147.630
The readings given in the table below were recorded in a levelling operation from points 1 to 10. Fine the reduce levels by the height of instrument method and apply appropriate checks. The point 10 i a bench mark having elevation of 66.374 m. Determine the loop closure. Station Chainage (m) B.S. I.S. F.S. Remarks 1 0.597 B.M. = 68.233 m %3D 20 2.587 3.132 С.Р. 3 40 1.565 4 60 1.911 5 80 0.376 6 100 2.244 1.522 С.Р. 7 120 3.771 8 140 1.334 1.985 C.P 160 0.601 10 180 2.002
Reciprocal leveling gives the following readings in meters from a set up near A: on A, 1.110; on B, 0.887, 0.995, and 0.884. At the setup near B: on B, 1.549; on A, 1.673, 1.670, and 1.666. The elevation of A is 1045.343 m. Determine the misclosure of B. Express your answer to three decimal places and include appropriate units. Misclosure = Submit Part B elevB = μÁ Value Request Answer CHA Value Units Determine the elevation of B. Express your answer to three decimal places and include appropriate units. Units ? ?
Q2/ Complete the settlement table below and verify the correctness of the calculations. Then check the correctness of the work, bearing in mind that the length of the leveling line is 2,250 meters, bearing in mind that the required level of leveling is the third. Find the closing error and adjust the levels if necessary, suppose that the error equal for all points. Elevation Station B.M1 TP1 TP2 TP3 TP4 TP5 TP6 BM1 B.S 1.23 0.955 1.332 1.652 2.558 2.465 2.882 H.I F.S 1.735 2,642 3.000 2.524 2.221 0.755 0.218 50,000
In carrying out the permanent adjustments of a level by, the following observations were made: Instrument at peg (C) midway between points A and B, 100m apart. Readings at points A and B are 2.500m and 3.500m, respectively. Instrument at peg (D) in line of AB such that AD-120m and BD-20m, Readings at points A and B are 1.500m and 2.600m, respectively. Check whether the instrument needs permanent adjustment or not and whether the line of sight is inclined upward or downward. What should be the correct reading at (A and B) if the instrument is to be adjusted?
B. Double-Rodded Leveling 3. Complete differential level notes for the information shown and perform the customary arithmetic check. STATION BS HI FS STATION 1.722 BM1 127.378 m 1.722 ΤΡΙΗ 2.623 1.382 TP1L 2.789 1.522 TP2 H 3.089 0.899 TP2 L 3.214 0.714 ТРЗ Н 1.521 2.452 TP3 L 1.632 2.678 ТРА Н 2.333 1.113 TP4 L 2.589 1.523 TP5 H 0.667 2.877 TP5 L 0.986 2.543 3.521 BM2 3.214
Reciprocal leveling gives the following readings in meters from a set up near A: on A, 1.110; on B, 0.887, 0.845, and 0.984. At the setup near B: on B, 1.549; on A, 1.673, 1.670, and 1.666. The elevation of A is 1045.343 m. Part A Determine the misclosure of B. Express your answer to three decimal places and include appropriate units. Misclosure = Value Submit Part B elevB = Submit μA Request Answer Determine the elevation of B. Express your answer to three decimal places and include appropriate units. НА Value Units Request Answer Units ? ?
Prepare a set of level notes for the data listed. Perform a check and adjust the mis- closure. Elevation of BM 7 is 852.045 m. If the total loop length is 1500 m, what order of leveling is represented? (Assume all readings are in meters.) +S (BS) -S (FS) Point 4.388 6.907 ВМ 7 TP1 4.538 as BM 8 4.680 8.800 TP2 3.730 5.978 5.245 3.598 ТРЗ 8.464 ВМ 7
Which of the following may cause errors in leveling measurement? (Multiple choice) (Multiple choice) 1 □ A. The level tripod sinks O B. Reading Error □ C. The instrument is not erected at approximately the same distance from front to back □D. Improper implementation of the centering of the level □ E. Subsidence occurred at the level where the level was erected □ F. Vertical dial error of the level