Draw the voltage tripler circuit and explain its operation. Explain the difference between voltage quadrature and tripler.

Q: What is value of Iref. Vbe = 0.7(Volt).

A: Given circuit is - Given base to emitter voltage is 0.7(Volt). VBE=0.7Volt

Q: what is the value R)? 550sm 50 sr 2-5V 500s 12レ in

A: Nodal analysis is an important method to solve big and complex circuits. It is based on Kirchoff's…

Q: moving coil meter has a full scale deflection of 5 μA and a resistance of 500 Ω. It is connected…

A: Given Full scale deflection =Im =5 μA Rm =500 Ω To determine value of resistances

Q: The voltage of the battery is 12 V and the internal resistance is 0.04 (Ω). The resistance of radio…

A: Here in this question we have to make that to two cases one is when the switch is open and other is…

Q: In the electrical circuit of a house, the fuse acts as   A) a load B) a thermopile C) a safety…

A: Given: In the electrical circuit of a house, the fuse acts as

Q: Which change to the circuit will not extend the charging time of one time constant. a. Increasing…

A:

Q: 10KN Vin Vout 5V 5V Figure 3

A:

Q: Draw the circuit of voltage doubler and Voltage quadruple. Explain the working of voltage doubler

A: Diode is used in wave shaping device. A circuit which give integral multiple of peak ac input is…

Q: Also determine whether its overmodulation or undermodulation.

A: Given information: The current corresponding to the unmodulated carrier is Ic=10 A. The current…

Q: 2. R=

A:

Q: A circuit consist of a single diode and resistor which are connected to AC source. The resistance…

A:

Q: 1. The airbag igniter is modeled by the following circuit. Determine the time it takes the voltage…

A:

Q: What is folt meter

A: In the electrical power system, the fault condition occurs when the abnormal value of the current…

Q: the amount of current that the circuit breaker can interrupt without damaging itself electrically…

A: Short circuit limit of CB :- It is the ability of the circuit breaker to withstand 85% to 90% of…

Q: what is the power disipated by R1

A:

Q: The sides and bottom of the solar collector are usually insulated to Select one: maximize heat loss…

A: In the solar flat plate collectors the sides and bottom of the collector are generally insulated.

Q: 2k Ohm JFET =16 V 1 M Ohm 2V Figure 8.4 Common Source Configurations

A: Find Vgs and Vd for the given JFET?

Q: Calculate the output voltage if V1= 2V and V2 = 1V for the circuit: Vo=____Volts

A:

Q: 191 3.9KD 3.6K2 470KA B-80 VCE B-120 VeE IKA 0.18KA 0.5IK2

A:

Q: what the value of RL for the zener to draw maximum power.

A:

Q: From Figure 1, Ic= 3ma, B= 60, Freq.=200HZ, Vcc=9 Volts Solve for VCE, VRE, VRC, RE, RC,RBB, R1, R2,…

A: The circuit is as shown below,

Q: Requirements: 1. Explain what is an ADC converter and how the conversion process happens? 2. Show…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: B E G C – F A (b). Identify the hazard and modify the circuit to eliminate the hazard.

A: We must add an AND gate before the output G. This will enable us to get an output of 1 called high…

Q: 6 The following power switching device is controlled by voltage signal: А. BJT В. GTO С. SCR D.…

A: 6) MOSFET voltage controlled device. By controlling the gate to source voltage , we can control the…

Q: Define the term Plug Setting Multiplier and Time Multiplier Setting of a frelay

A: Plug setting multiplier(PSM) and Time multiplier setting are the settings of a relay used to specify…

Q: Draw only, the following items: 1. The DC multirange Voltmeter Instrument.

A: Given: DC multirange Voltmeter Instrument

Q: sketch a diagram showing the ohmeter face for a reading of 1.2 k resistance indicate the setting of…

A: The use of an ohmmeter is to measure the resistance between its leads. This resistance between its…

Q: A local oscillator uses a frequency multiplier circuit consisting of 2 triplers and 3 doublers to…

A:

Q: A 5.3 V zener is rated at 1.5 watt. The maximum zener current is equal to a. 2.83 mA. O b. 283 mA. O…

A: In this question we need to find a maximum zener current .

Q: technician A says battery warranties are often prorated. Technician B says some warranties have a…

A: Technician A is definitely correct as many a times the battery warranties are pro-rated. In case of…

Q: A KL25Z is used to drive a switching circuit as shown below. The maximum current per I/O pin is 18…

A:

Q: Define The followings effect on PV -IV curve by drawing each effect 1. Temperature effect 2.…

A:

Q: In the given statement for power electronics modules, state the true statement only The control…

A: Circuits in electronic modules are classified into two types namely; 1) Power circuit 2) Control…

Q: 2. Explain how an independent source is deactivated if it is (a) a voltage source and (b) if it is a…

A: Deactivation of independent source:

Q: Thee resistors each has a value of 1k ohm are connected in delta configuration to a three phase…

A:

Q: 12V R1 2 Vout R2 VREF +88 8 5V Volts -12V Determine the output voltage, Vout when: R1=10000,…

A: We need to find out output voltage for given circuit

Q: Sketch the output voltage (V,) for the circuit and the input voltage (V;) shown in figure (3

A: A diode is a two terminal PN junction device, the two terminals of a diode are anode and cathode.…

Q: Record the output voltage here: volts

A: Voltage at point 4 is = 3V voltage at point 3 is = 11+1×3                                 =1.5 V…

Q: Can you please tell what is the threshold voltage from the figure ?

A: The solution is given below.

Q: The maximum current rating

A:

Q: Draw Bread Board connection diagram for HALF SUBTRACTOR.

A: The truth table for the half-subtractor is given by:

Q: What is the range of values for Va will result in linear operation? 50kN 10kN 10V 4kN Va O -10V 4V…

A: we need to determine the range of Va.

Q: Determine the V1 (in volts)

A: In this question,  We need to calculate the voltage V1 as shown in the circuit.  We are solving this…

Q: identify any equiptment at home that undergo an electromechanical energy conversion. name and…

A: An electromechanical energy conversion equipment is an equipment that converts electrical energy…

Q: Which component/s must be present in all MULTISIM circuits for successful simulation? *

A: (1) For successful simulation of all multisim circuit, ground must be connected.  (2) Colpitts and…

Q: If the average current is 20 Amperes, what is the maximum current

A: Current- The term current refer to the flow of charge (electrons) is called as current.

Q: 2. In the space provided, draw a schematic diagram showing your ImAdc meter and multiplier resistors…

A: The multiplier ranges for the resistance are,  0-1 V0-5 V0-50 V0-100 V If the internal resistance of…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.