Consider the following hypothetical acid-base titration where A represents the acid and B represents the base. The products of this reaction are salt and water. Assume the equation is balanced as written. A+B --> salt + water (OR A + B right arrow salt + water) Calculate the molarity of B if 13.77 mL of A with a molarity of 0.217 is titrated with 18.29 mL of B.

Consider the following hypothetical acid-base titration where A represents the acid and B represents the base. The products of this reaction are salt and water. Assume the equation is balanced as written. A+B --> salt + water (OR A + B right arrow salt + water) Calculate the molarity of B if 13.77 mL of A with a molarity of 0.217 is titrated with 18.29 mL of B.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter15: Additional Aqueous Equilibria

Section: Chapter Questions

Problem 111QRT: Consider the nanoscale-level representations for Question 111 of the titration of the aqueous strong...

See similar textbooks

Similar questions

A bottle of concentrated hydroiodic acid is 57% HI by weight and has a density of 1.70 g/mL. A solution of this strong and corrosive acid is made by adding exactly 10.0 mL to some water and diluting to 250.0 mL. If the information on the label is correct, what volume of 0.988 M NaOH is needed to neutralize the HI solution? Suggest an indicator for the titration.
Follow the directions of Question 64. Consider two beakers: Beaker A has a weak acid(K a=1105). Beaker B has HCI. The volume and molarity of each acid in the beakers are the same. Both acids are to be titrated with a 0.1 M solution of NaOH. (a) Before titration starts (at zero time), the pH of the solution in Beaker A is the pH of the solution in Beaker B. (b) At half-neutralization (halfway to the equivalence point), the pH of the solution in Beaker A the pH of the solution in Beaker B. (c) When each solution has reached its equivalence point, the pH of the solution in Beaker A the pH of the solution in Beaker B. (d) At the equivalence point, the volume of NaOH used to titrate HCI in Beaker B the volume of NaOH used to titrate the weak acid in Beaker A.
Consider the nanoscale-level representations for Question 111 of the titration of the aqueous strong acid HA with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: (a) After a very small volume of titrant has been added to the initial HA solution? (b) Halfway to the equivalence point? (c) When enough titrant has been added to take the solution just past the equivalence point? (d) At the equivalence point? Nanoscale representations for Question 111.
How many mEq of HCO3 are present in a solution that also contains 75 mEq of Na+, 83 mEq K+, 10 mEq Ca2+, and 153 mEq Cl?
A scientist has synthesized a diprotic organic acid, H2A, with a molar mass of 124.0 g/mol. The acid must be neutralized (forming the potassium salt) for an important experiment. Calculate the volume of 0.221 M KOH that is needed to neutralize 24.93 g of the acid, forming K2A.
Phenol, C6H5OH, is a weak organic acid. Suppose 0.515 g of the compound is dissolved in enough water to make 125 mL of solution. The resulting solution is titrated with 0.123 M NaOH. C6H5OH(aq) + OH(aq) C6H5O(aq) + H2O() (a) What is the pH of the original solution of phenol? (b) What are the concentrations of all of the following ions at the equivalence point: Na+, H3O+, OH, and C6H5O? (c) What is the pH of the solution at the equivalence point?
Consider the following reactions: Reaction 1: HCIO, + KOH → KC1O, + H;O Reaction 2: HC;H;O2 + KOH → KC;H;O2+ H;O In both reactions, 15.00 mL of 0.8116 M acid is titrated with 0.4217 M KOH. A volume of 28.87 mL of KOH is required to reach the equivalence point in both reactions. a) What is the pH of the HC1O, solution before the titration has started? (No KOH has been added.) b) What is the initial pH of HC;H;O2 solution before the titration has started? K= 6.46 x 10-5 (Ok to use x is small.) c) What is the pH of Reaction 1 at the equivalence point? d) What is the pH of Reaction 2 at the equivalence point? e) What is the pH of Reaction 1 after 32.00 mL of KOH has been added? f) What is the pH of Reaction 2 after 18.00 mL of KOH has been added?
A 0.9600 M NaOH solution was diluted with a factor of 4. Then the diluted solution of NaOH was titrated against an unknown acid. The volumes of NaOH(aq) titrated are shown in the table below. Volumes of NaOH(aq): Rough titration First titration Second titration Third titration Third titration Final burette reading: (mL) 19.00 34.05 20.86 36.01 23.57 Initial burette reading: (mL) 19.00 19.07 5.76 21.02 8.54 The molarity of the unknown acid is 0.08108 M and the volume of the unknown acid used in each titration is 14.80 mL. (i) Was the unknown acid monoprotic, diprotic or triprotic? Show your calculations and reasoning.
What two quantities are equal at the endpoint of a titration of an antacid? O number of molecules of acid = number of molecules of base %D O grams of acid = grams of base %3D O moles of acid = moles of base O volume of acid = volume of base
A 0.9600 M NaOH solution was diluted with a factor of 4. Then the diluted solution of NaOH was titrated against an unknown acid. The volumes of NaOH(aq) titrated are shown in the table below. Volumes of NaOH(aq): Rough titration First titration Second titration Third titration Third titration Final burette reading: (mL) 19.00 34.05 20.86 36.01 23.57 Initial burette reading: (mL) 19.00 19.07 5.76 21.02 8.54 The molarity of the unknown acid is 0.08108 M and the volume of the unknown acid used in each titration is 14.80 mL. (i) Was the unknown acid monoprotic, diprotic or triprotic? Show your calculations and reasoning. (ii) What type of chemical reaction is this? _________________ or ________________ In the laboratory, what would you use for the following? (a) To measure the temperature of water _______________________________________________ (b) To get out of the lab immediately in an emergency ____________________________________ (c) To measure 5.50 g of CuSO4·5H2O…
A 0.9600 M NaOH solution was diluted with a factor of 4. Then the diluted solution of NaOH was fitrated against an unknown acid. The volumes of NaOH(aq) Strated are shown in the table below. Volumes of NaOH(aq): Second Third Reugh titration Fist titration Third titration titration titration Final burette reading: (ml) Initial burette reading: (ml.) 19.00 34.05 20.86 36.01 23.57 19.00 19.07 5.76 21.02 8.54 The molarity of the unknown acid is 0.08108 Mand the volume of the unknown acid used in each titration is 14.80 mL O Was the unknown acid monoprotic, điprotic or triprotic? Show your calculations and reasoning. (i) What type of chemical reaction is this?
Consider the reaction of a 20.0 mL of 0.220 M C;H;NHCI (Ka = 5.9 x 10) with 12.0 mL of 0.239 M CSOH. Write the net ionic equation for the reaction that takes place. What quantity in moles of C;H;NH" would be present at the start of the titration? What quantity in moles of OH" would be present if 12.0 mL of OH were added? -What species would be left in the beaker after the reaction goes to completion? d. What quantity in moles of C,H,NH would be left in the beaker after the reaction goes to completion?