Consider the following vapor phase reaction of ethylene. C₂H₂(g) + H₂0(g) C₂H₂OH(g) The value of Gibbs free energy is equal to 5040 J at a temperature and pressure of 125°C and 1 atm .Compute the conversion value if an isothermal reactor contains 50 mole % of steam while operating at a temperature of 125°C and 2 atm. Assume the outlet components behave ideally and the condition of equilibrium is attained at the exit.

Q: In the following two problems a continuous stream of fluid enters a vessel at temperature To and…

A:

Q: Focus on Example 8.4-5.  Show all of the plotting for the relative humidty and dry-bulb temperature.…

A: GIven = Dry bulb temp = 41^c RH = 10% 150 m3 of air to find = Abs humidity wet-bulb temp humid…

Q: Part D ONLY LAST PART ONLY PLEASE

A:

Q: A steam turbine operates adiabatically at a power level of 3500 kW. Steam enters the turbine  at…

A: Given that-Power of turbine, W=3500 kW= 3500 kJ/sInlet pressure of stream, P1=2400 kPaOutlet…

Q: For the following hypothetical Eutectic binary system, A and B, determine the melting point of pure…

A: Hypothetical eutectic phase diagram is given as shown below,

Q: Derive the concentration distribution equations for “diffusion into a falling liquid film?

A:

Q: A vapor/liquid experiment for the carbon disulfide(1) + chloroform(2) system has provided the…

A: To estimate the dew pressure at 298 K and y1 = 0.6 for the carbon disulfide (CS2, component 1) +…

Q: A) Define the following: Pipes in series, Dehydration, Critical point, Condensate, B) A 50-cubic ft…

A:

Q: reactor. What is the total volume of the two reactors necessary for 80% overall conversion of the…

A:

Q: Find the necessary volume V of a CSTR for the following problem dm³ min C V = 10 CAO V = ? Ca = 0.1…

A: given = Vo = 10 dm3/minCA = 0.1CAOK = 0.23 min-1 To find = V =?

Q: Using the Peng-Robinson, SRK and RK equations of state develope a compression factor and molar…

A: Write the general expression for Z as follows:Where, The molar volume of carbon dioxide,

Q: Calculate the performance ratio, specific heat transfer area, specific flow rate of cooling water,…

A: Feed salinity ,Xf= 45000 ppm Feed temperature, Tf = 25 °C Heating steam temperature, Ts = 90 °C…

Q: A pilot plant reactor, a scale model of a production unit, is of such size that 1 g charged to the…

A: here, the scale factor f = 5001/3 = 7.93Reynold's number, Re = Power input, P = where, n = turbine…

Q: Suppose a non-ideal gas has reduced pressure 3.5 and reduced temperature 1.5 at 98.5 atm and 410K.…

A:

Q: Experimental techniques for fast reactions. What is temperature jumped method

A: Experimental techniques for fast reactions. What is temperature jumped method

Q: The reaction of hydrogenation of nitrobenzene to aniline can be represented by the following…

A: Given reaction is-The tempearture of feed entering the reactor, T0=270C= 300 K  Feed is equimolar…

Q: The flow rate of water flowing in a 3 m wide channel is to be measured with a sharp crested…

A: As fluid flows when there is a pressure difference.So it is very important to know the surface on…

Q: Q6/ A mixture 25mol% pentane, 45mol% hexane and 30mol % propane is brought to a condition of 200°F…

A:

Q: A reactant diffuses through a pore within a catalyst particle (size L) and reacts on the catalysts…

A: Diffusion of reactant across pore of length L in the catalyst particle.The Diffusion follows Fick's…

Q: A dry gas well equipped 30 MMcfd with 85psig tubing pressure must be compressed to 300 psig for…

A:

Q: Here is a graph of the pressure of boron trifluoride (BF) in a reaction vessel during a certain…

A: Graph of pressure variation  of Boron trifluoride in the reaction vessel is given

Q: what is the required air feed rate in mol/min?  Answer in decimal format with 4 digits of precision.

A:

Q: Focus on the Enthalpy Deviation.  I am not clear how the two enthalpies were obtained.  Begin where…

A: We have air at 35oc and at 10% RH We have to find enthalpy deviation and final enthalpy

Q: 3- Which one/ones are not correct about silicate ceramics? a) b) () OD d) e) In layered silicates…

A:

Q: The solution containing bacterial spores is heated in an autoclave. When the autoclave has reached a…

A: Given that-Temperature is constant, T=1210CBacterial concentration is constant so as,Initial…

Q: The heat capacity of a molecule is given by Cp.m (J-K-¹-mol-¹) = a₁ + a₂T, where a₁-80, 12=7.0×10-²,…

A: To calculate the change in molar entropy (ΔSm) of the sample, we need to integrate the expression…

Q: A wastewater sample with a DO content of 1.4 mg/L is diluted with deionized water with a DO content…

A: DO of waste water sample = 1.4 mg/LDO of diluted water = 8.8 mg/LDO after mixing = 7.8 mg/LA)…

Q: If the natural gas flow rate is 120 MMSCF/Day in a gas pipeline, NPS 20 with 0.25 in wall thickness,…

A: To calculate the outlet pressure using the Panhandle A equation, we can use the following…

Q: Q4/ A mixture containing equimolar amounts of Benzene, Toluene and Ethylbenzene is flashed to 110 °C…

A: Given that-An equimolar mixture of benzene, toluene, and ethylbenzene is flashed.Temperatur, T=1100…

Q: A gas A is diffusing eastward from a quiescent gas film to a spherical heterogeneous catalyst that…

A: To derive the equation for the molar flux of gas A (denoted as R) in the quiescent gas film, we need…

Q: Two CSTR reactors in series is considered. The 40% conversion is achieved in the first reactor. What…

A:

Q: 03: A sample of natural gas from the Texas field has the specific gravity 0.712(air-1), this gas…

A:

Q: 5) What is the work-energy theorem? a states that energy is created, work is done b. requires work…

A: The correct answer is:c. states that whenever work is done, energy changes.The work-energy theorem…

Q: 4. For the combustion of methane, the unbalanced reaction is: CH4 + O₂ => CO₂ + H₂O The reaction…

A: Reaction occurs in steady state reactor.Air is 25% excess.

Q: Estimate the fugacity of one of the following liquids at its normal-boiling-point tem- perature and…

A: a) n-PentaneT→ normal-boiling-point temperatureP=200bar Properties of the n-Pentane. Since the…

Q: For the reaction: 3X (g) + 5Y (g) + 4L (g) a.' Express the rate of the reaction in terms of the…

A: Given reaction is-The rate of reaction is expressed as the rate of disappearance of reactants or the…

Q: 2. A 90 wt% Ag - 10 wt% Cu alloy is heated to a temperature within the ß + L phase region. If the…

A: Given composition of alloy is,90 wt% Ag and 10 wt% CuComposition of the liquid phase = 85 wt% Ag

Q: Ethylene oxide (C2H4O) is produced by the catalytic oxidation of ethylene (C2H4) in the reaction…

A: given details = single pass conversion = 25%moles of ethylene oxide produced = 90 moles per 100…

Q: 1- The specific conductance and the equivalent conductance of a saturated solution of BaSO4 is 8x10…

A: Note: Since you have posted multiple questions, we will provide the solutiononly to the first…

Q: Utilize the following data for 0°C (273K) to calculate the fugacity of carbon monoxide at 100 and…

A: Given the data for pressure in bar and compressibility factor Z.It is required to calculate the…

Q: Gaseous oxygen is maintained at pressures of 2 atm and 1 atm on the opposite sides of a rubber…

A: P1 = 2 atm = 2.0265 bar P2 = 1 atm = 1.01325 t = 0.5 mm = 0.5 x 10-3 m T = 250C = 298K  DAB = 0.21 x…

Q: A gas decomposes at 900°C according to 2A(g) → 2 R(g) + S(g) with a rate constant of 1000 cm³/gmol-s…

A:

Q: 5) What is the work-energy theorem? a. states that energy is created, work is done b. requires work…

A: The correct answer i:c. states that whenever work is done, energy changes.

Q: experimentally For the reaction equation below, determined rate law is R = K[X]² [Y₂]. Drag and drop…

A: Given, The reaction is X + Y2 →XY + Y

Q: A solid slab has a thickness of 2L and a cross section of A The slab has heat generation at a…

A: Given temperature as a function of distance x       .........(1)here g is volumetric heat generation…

Q: Point 1: Point 2: -1 material balance (H₂O-dry air is already balanced on the chart) -2 absolute…

A: As two indepent properties are defined we can determine the whole system in the humid(psychrometric…

Q: For a binary mixture of ethanol (1) and benzene (2) at 343 K, the van Laar parameters are A = 1.946…

A: given = T = 343KA = 1.946B = 1.610To find = a) Calculate the activity coefficients for a mixture…

Q: Problem 30-4E. The "spinning disk" reactor is often used to carry out chemical reactions under…

A: Note: Since you have posted a question with multiple sub parts, we will provide the solution only to…

Q: Consider the data in the table for the reaction at 45 °C in carbon tetrachloride solution. z(s) 0…

A: Average rate of reaction at each time interval is to be calculated.

Q: I used to work in a plant that was just, the worst. Broken equipment everywhere, terrible management…

A: In this scenario, you were trying to measure the weight of a chemical using equipment that only…