Consider a 2-ft * 2-ft thin square plate in a room at 75°F. One side of the plate is maintained at a temperature of 130°F, while the other side is insulated. Determine the rate of heat transfer from the plate by natural convection if the plate is (a) vertical, (b) horizontal with hot surface facing up, and (c) horizontal with hot surface facing down.

Q: A block of unknown metal has the following dimensions: 1cm× 1cm×3cm. The block's density is 80o09/m³...

A: Mass of any metal is given by  Mass = density X volume  

Q: Calcium fluoride is considered as a relatively insoluble compound and therefore lime or slaked lime ...

A:

Q: In the empty graph below, draw a phase diagram for a binary-eutectic alloy with the following charac...

A: Since the plot is temperature v/s composition of B Hence the melting point of A will be on left y ax...

Q: Why is maintaining constant supersaturation important during bioproduct crystallization?

A: The reason for maintaining constant supersaturation during bio-product crystallization is to be ment...

Q: What are the assumptions for an ideal leaching or washing stage?

A: The assumptions involved in the ideal leaching or washing stage are to be mentioned.

Q: What are the advantages and disadvantages of continuous, counterflow, mechanically assisted extracto...

A: The advantages of the mechanically assisted forms of the continuous and counter-flow extractors are ...

Q: Estimate the theoretical production of landfill gases (CH4, NH3 and CO2) from the degradation of 80 ...

A: Given data: Chemical formula of solid waste = C68H111O50N Mass of solid waste = 80 kg Conversion of ...

Q: ) Calculate the thermal conductivity for Ne at 300K and 15 mbar pressure. The gas iscontained in cub...

A: Given data: Temperature = 300 K Pressure = 15 mbar The edge of a cubic vessel = 15 cm The temperatur...

Q: Which of the following statements concerning corrosion is(are) true? For the false statements, corre...

A: a) Since corrosion is a process in which the metal converts into oxides by reacting with the oxygen ...

Q: Differentiating principle!gpgasation. example fox each Adrorptien and Abrorption besed elathony and ...

A: The difference between Adsorption and Absorption is to be mentioned based on the principle along wit...

Q: State three assumptions usually made in the application of the McCabe-Thiele method of analysis in d...

A: The three assumptions of Mccabe-Thiele method are to be mentioned. The operating condition at which ...

Q: Estimate the theoretical production of landfill gases (CH4,  NH3 and CO2) from the degradation of 80...

A:

Q: Estimate the theoretical production of landfill gases (CH4,  NH3 and CO2) from the degradation of 80...

A:

Q: THE PROBLEMIt has been proposed that commercial manganese ferrite (MnFe2O4) production in Ghana isba...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: two plates which are aligned parallel above eachother.The top plate is moving horizontally with a co...

A: A Newtonian fluid is flowing between two parallel plates where top plate is moving with a constant v...

Q: Furfural is extracted from water by toluene at 25oC in an agitated vessel like the one in Figure . T...

A: Given information:   Feed mass flow rate, mF = 20400 lb/h Solvent mass flow rate, mS = 11200 lb/h Te...

Q: A distillation column is used to separate 750 kg /h of a mixture containing 30wt% Acetone (C3 H6 O) ...

A: Given data: Flow rate of the feed = 750kg/h Composition of acetone = 30 wt% Composition of hexanol =...

Q: A process is being developed to produce carbonated beverages. As part of this process, a wetted-wall...

A: (a) The maximum possible concentration of dissolved CO2 in water at 2.54 atm CO2 partial pressure is...

Q: Determine the length and diameter of a horizontal reflux drum for the conditions shown in Figure .

A: The length and diameter of a horizontal reflux drum for the conditions shown in Figure is to be dete...

Q: Hot oil at 150°C is used to preheat a cold fluid at 30°C in a I:I shell and tube heat exchanger. The...

A:

Q: 1 mol super cooled liquid water transformed to solid ice at -10 oC under 1 atm pressure. a) Calculat...

A:

Q: Explain the PVT behavior of pure substances with appropriate examples 400 to 500 words Write a short...

A:

Q: Ammonia, NH3, in air is being absorbed into water within the enclosed tank shown in the figure below...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: Explain the PVT behavior of pure substances with appropriate examples  500 words

A: The substance whose compositions does not change gradually and are fixed throughout the process are ...

Q: A tub of pure water sits in a room open to the atmosphere at 85°C. When the water has reached equili...

A: The fugacity of an ideal gas is equal to its pressure. The fugacity, therefore of the given vapour i...

Q: A stream with a flow of 1.7 m/s and BOD 3.4 mg/l is saturated with DO (9.27 mg/l at 20°C). It receiv...

A:

Q: What is the critical moisture content?

A: The definition of the critical moisture content is to be mentioned.

Q: Book: Introduction to Chemical engineering Thermodynamics 8th edition, McGraw Hill, 2018

A: The Henry's law constant for the component A is to be determined with assumptions.

Q: What is the difference between suspension leaching and percolation leaching? For what conditions is ...

A: Suspension leaching is also known as agitated leaching. The method is used for the ores that does no...

Q: THE PROBLEM It has been proposed that commercial manganese ferrite (MnFe2O4) production in Ghana is ...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: A fixture containing an ordinary incandescent light bulb is connected to a dimmer switch. The dimmer...

A:

Q: An adiabatic steam turbine in an electric power plant is designed to accept steam at 5000 kPa and 60...

A: The inlet pressure of the steam to the adiabatic electric turbine is, P1 = 5000 kPa The inlet temper...

Q: Solubility of gases in water increases with increasing mass. Explain?

A: The force of attraction between the gas molecules is weak which are primarily London dispersion forc...

Q: What is a hybrid system?

A: The definition of the hybrid system is to be mentioned.

Q: A quiescent body of water has a depth of 600 mm. The DO level at the bottom after 16 days is 3.5 mg/...

A: Let, dissolved oxygen (DO) be represented by ‘A’.   Since the surface of the water body is exposed t...

Q: (a) When rinsing clothes, would it be more efficient to divide the water and rinse several times, or...

A: Let,   The mass of dry cloth that is insoluble be ‘FA’ The mass of soluble dirt be ‘FB’ The mass of ...

Q: 1. a.   Explain the terms (i) steam economy (ii) vapourrecompression.   b. A single-effect evaporato...

A: Since you have posted multiple questions, we are entitled to answer the first only.

Q: The availability of forestry and agriculture wastes and residues is mainly determined by future deve...

A: Biomass is one of the potential renewable energy sources that can help us in bridging the gap betwee...

Q: 2.5 mol of an ideal gas at 20 oC under 20 atm pressure, was expanded up to 5 atm pressurevia;(a) adi...

A:

Q: Molecular weight of benzene = 78 kg/mol Molecular weight of Toluene = 92kg/mol

A: The number of theoretical plates required to achieve the given separation is to be determined.

Q: State theee ass umytims usurlly made in the applicatien of Mecabe Thiele methed oņ analys in dis tih...

A: The assumptions that are necessary before using the Mccabe-Thiele method for distillation analysis a...

Q: Determine the mass flow rate of fuel from the gasoline tank to the car's fuel injection system. Assu...

A: Given ; Consumption of fuel is 20 mpg i.e 20 miles per gallon  And speed of car is 60 mph i.e 60 mil...

Q: What is the approximation of Fick's equation ?

A: The first law of Fick’s gives the relationship between the diffusive flux and the concentration grad...

Q: 2000 kg/h of milk is sterilized in a steam infusion sterilizer. The milk is heated to 145 °C by intr...

A: The milk is sterilized in a steam infusion sterilizer. Milk is heated in a steam infusion chamber an...

Q: Practice 14 fluid undergoes adiabatic expansion in a turbine. Which reference state will result in t...

A: Reference states for enthalpies

Q: Step by Step on how to solve this problem.   The displacement volume of an automobile engine is 167i...

A: the relationship between inch and cm is  1 in = 2.54 cm  cubing both side we get  1 in3 = 2.543 cm3 

Q: Prove that carnot engine efficiency can never equal one

A: Carnot engine runs on Carnot cycle which is made up of 4 reversible process  The 4 reversible proces...

Q: In distillation, what is meant by reflux, boilup, rectification section, and stripping section?

A: The definitions of reflux, boil-up, rectification section and stripping section in the distillation ...

Q: Why is the draft-tube, baffled (DTB) crystallizer popular? What are its main features? What is a dra...

A: The popularity of the draft-tube baffled crystallizer are to be mentioned along with its main featur...

Q: Differentiate between absorption and adsorption based on their principle of operation and give an ex...

A: The difference between Adsorption and Absorption is to be mentioned based on the principle along wit...