c.1 For the network given below, determine AVNL, Zi, and Zo.

Q: (2) The starting current of the DC motor is: a- Twenty times the rated current. b- Nine times of the...

A: There are two types of DC Motor. Separately excited DC motor and Self excited DC motor.In self excit...

Q: E1=E1= 26 VV, and E2=E2= 6.2 VV , V1=V1= 5.6 VV, and V3=V3= 17.1 VV using Kirchoff's voltage law,  ...

A: In this question,  As shown the circuit, find the voltage V4 and V2?  E1= 26 V, and E2= 6.2 V , V1= ...

Q: A sinusoidal voltage with maximum value (336 V), and a Frequeney its value (50 Hz), was applied on a...

A: As per the guidelines given to us, we can only provide the solution of first three subpart in multi ...

Q: 1- In a table compare between diesel power plants & gas power plants.  2- Give any five comparisons...

A:

Q: Vec Rc C2 RE

A: The solution is given below

Q: . Calculate the load voltage, load current, and diode power in figure below using the second approxi...

A:

Q: Cunent (lales O-012A Rz 23 O-13 A O.O1S A 12 0.027 A

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: 1. Refer to Figure 1. A Y-connected source supplies 3 balanced 3-phase loads. The source has voltage...

A:

Q: Consider a system described by the equation y" (t) + 2y(t) = x (t) + a' (t). Using the convolution p...

A: The solution is given below

Q: Consider a generator that rotates its 200 turn, 0.19 m diameter coil at 3600 rpm in a 0.95 T field. ...

A:

Q: A delta-connected balanced 3 phase load is supplied from a 3 phase 400 V supply.

A:

Q: How many GPS Satellites are present?

A: The GPS is the abbreviation for global position system it is used to determine the location of some ...

Q: c. Given an Early voltage of VA = 100 V, determine ro if VCEO = 8 V and IcQ = 4 mA.

A: The solution is given below 

Q: solve for branch currents using kirchhoffs

A: We will solve using Kirchhoff voltage law consider loop currents as shown below.

Q: ode is used as a voltage regulator.

A: Zener diode : Zener diode is a semiconductor device which have the special property that it allows t...

Q: Q2 why have the filters in the BASEBAND CHANNEL FILTERS module got common slotband widths (instead, ...

A: According to the question, we need to discuss why have the filters in the BASEBAND CHANNEL FILTERS m...

Q: QUESTION 24 A ROM chip with a 128KX8 organization has memory locations. 128 138 128K 17

A:

Q: A starconnected, 5000 V, 3pase altemator is supplying 3,00 kWat power factor of 0.8. Calculate the a...

A:

Q: 4. A balanced wye-connected, three-phase load withdraws 150 A per phase with a leading power factor ...

A: The solution is given below 

Q: The Sensitivity of a measuring instrument is 3 0/°C. This instrument is used for the measurement of ...

A: Given, Sensitivity of measuring instrument, S=3 Ω/°C  

Q: 12 V what value of Rc will cut the voltage gain to half the value obtained from the original values ...

A:

Q: What are the benefits of using fiber optics as a transmission medium rather than copper?

A: Fiber optics (optical fiber) It is the technology that transmits information as light pulses along a...

Q: If we want to make a coil consisting of an aluminum wire of length (100 m), so that it carries a cur...

A: The solution is given below.

Q: 1. FINDING THE TRANSFER FUNCTIONS a) Take the mass of the block is M(kilogram-Newton-secondimeter), ...

A: The solution is given below

Q: 1. How can you draw the spectrum of FM?

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please su...

Q: A 250 V DC long-shunt, compound motor takes a current of 82 A at full load. Calculate the motor effi...

A: There are two types of compound motor.in commulative compound motor, shunt field add the series magn...

Q: V1 (s) Determine the transfer function G(s) = of the circuit showr V(s) in the figure, given: R1 = R...

A:

Q: Q4. A finite line charge density of pI = 5nC/m is distributed between z=0 and z=-4 as shown in the f...

A:

Q: the cct shown find Vo f i. 8Ke Va io Skr vb V。そEL 1oka

A:

Q: 7. The rotor resistances per phase of a 4-pole, 50-Hz, 3-phase induction motor are 0.024 ohm and 0.1...

A: The solution is given below 

Q: 10 kN, and P2-20. In Fig. P2.20, R2 = 2 kN, R, U = 24 V. (a) Predict v2. (b) A practical voltmeter c...

A: Use basic circuit laws voltage division rule and nodal analysis to find the voltage V2 and voltmeter...

Q: 1. For Figure 1, what are the possible values of the Mux outputs? Describe what these do in terms of...

A: According to the question, for the given figure shown below We need to explain the operation of the...

Q: 016: Choose the correct answer: 1-Gate turn-off thyristor (GTO) is turned off by: (a) Applying negat...

A: The solution is given below

Q: S n iron cincumprenee rung.10 cm mean is made from 1 Cross rection lo3m². 5 rulative fèrmealiidy wou...

A: flux in the core = MMFreluctance                          = No. of turns×currentMean length of the c...

Q: - E=E= 60 VV, - C1=C1= 5 μFμF; C2=C2= 10 μFμF; C3=C3= 6 μFμF - C4=C4= 3 μFμF; C5=C5=72 μF Deter...

A:

Q: Draw the diagram of a full wave bridge type power supply circuit in your own words discuss in detail...

A: The full-wave bridge type power supply circuit is shown below:

Q: c) Find the transfer function of figure 1.3 with the values given in part b x(t) f(t) Figure 1.3

A: The solution is given below

Q: 4. Bundling of conductors in a transmission line reduces the risk for corona. Also, it: a. Reduces t...

A: As per bartleby guideline for more than one question asked only first is to be answered please uploa...

Q: * Choose the correct output waveform for the Zener diode circuit shown below +40 27 D,V, =10r1 -40 +...

A: We need to find output waveform for given circuit

Q: Find the transfer function of the electrical system. Show complete solution and formula used.

A:

Q: VcC 5V D1 R1 Vout 1.5kQ silicon diode D2 Germanium Diode Figure 1

A: Vo is simply the voltage drop across the germanium diode It is generally taken as 0.3 V Or else we c...

Q: 1. In free space, let Q1 = 10nC be at P1(0,-4,0), and Q2 = 20nC be at P2 (0,0,4) a. Find E at the or...

A:

Q: A group of cells consisting of four rows connected in parallel, each row containing five cells conne...

A:

Q: *The average value of the following waveform is cm. 100 V OV- 63.6V 50V 100V 36.3V O

A: We need to find average value for given waveform

Q: QUESTION 4 What is the highest system address stored in IC 1? As- A7. Ao IC 1 IC 2 CS CS O H OFF H 1...

A: The solution is given below

Q: AB 4° 31 12 प fined the Bolean Runction make the guauping Clenrly! 2.

A: The solution is given below

Q: what are the independent and dependent variables in the governing current equation for BJT? FOR FET?

A: The solution is given below

Q: calculate the resistance between (A,B) in figure (2-38). 32 16-2 ひb。 1ス2

A:

Q: fourier transform

A: Delta Function- It is also known as the unit impulse function. It's value is equal to zero everywher...

Q: 8. The resistance and reactance per phase of the rotor of a 3-phase induction motor are 0.6 ohm and ...

A: Rotor resistance=0.6ΩRotor reactance=5ΩInduced emf between the slip rings=80 VThe phase voltage of i...

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.