An unknown Acid was titrated three times with the same standardized base. The volume of base for each titration was 16.00 mL 16.09 mL and 15.59 mL. What is the average amound of base used to titrate the unkown Acid?

Q: li 3-methylbutanal Route A 1-chloropropane Et₂O + Mg MgCl propylmagnesium chloride i) Eto ii) H₂O OH…

A: Less hindered Nucleophile will give good yield.

Q: How would you use an experimentally determined Ksp value to calculate that Ag2CrO4 should…

A:

Q: 1. Magnesium solid reacts with aqueous hydrochloric acid to form the Mg2+ ion in solution. In an…

A: This is a problem based on the thermochemistry which is a part thermodynamics. Here we will…

Q: Describe a typical polymer molecule in terms of its chain structure and how the molecule may be…

A: Most polymeric materials are composed of very large molecular chains with side groups of various…

Q: What type of solutes are able to change to osmolarity of a solution?

A: As we know:- osmolarity is only affected by the temperature and the volume of given solute.…

Q: Molecular formula N₂H4 Draw a structure with zero formal charge on each atom. 5(2) +1 (4) = 14 €…

A:

Q: Also include two figures for the reaction mechanisms and discuss how the mechanisms relate to your…

A:

Q: A solution of this polyanion with a concentration a=0.001M is separated by a semipermeable membrane…

A: Ideal gas constant, R = 8.314 L kPa/mol K Concentration of polyanion, a is 0.001 M or mol/lt…

Q: OH 1. LiAIH4 2. Н30

A:

Q: (44) Ⓒ This grinard reaction. does NOT proceed as onaan Shane The Obtenined. 0 organic products mort…

A:

Q: Convert the line angle formula for adrenaline and acetaminophen into Lewis Structures. Show all…

A: In this question, we have to Convert the line angle formula for adrenaline and acetaminophen into…

Q: 1. Draw: 4-bromo-3,3-dimethyl-1-hexen-5-yne

A: Solving only first question in accordance with the guidelines. We will draw the structure of…

Q: QUESTION 3 How many moles of CO 2 will be produced if we produce 8.97 grams of H 20 in the reaction…

A:

Q: Before answering question 14, you may wish to draw it in chair form. Reverse Reactions. Fill in the…

A: We have to carry out the required synthesis.

Q: First, order the samples by decreasing initial radioactivity. Then calculate how long it will take…

A:

Q: @ This grinard reaction. does NOT proceed as shown. willL ACTUALLY be share the obtained. H3C…

A: The addition of alkyl/vinyl/aryl magnesium halides to any carbonyl group in an aldehyde/ketone is…

Q: How many grams of aluminum can form by passing 353 C through an electrolytic cell containing a…

A:

Q: 1) BH3 THF 2) H₂O2, NaOH

A:

Q: How many moles of HgO are required to produce 10.5 grams of O 2 in the reaction 2 HgO -> 2 Hg + 02

A:

Q: Generally speaking, what does the size of the reaction quotient typically indicate regarding the…

A: Reaction quotient is defined as the ratio of the concentration of the products and the reactants at…

Q: In a titration, the species in the Erlenmeyer flask being titrated is called the : - titrant -…

A: In the given question we have to write the term for the species in the Erlenmeyer flask being…

Q: 4. The experimental procedure for this experiment has you add 5 mL of 0.0040 M AgNO3 to 5 mL of…

A:

Q: A pure sample of methane is found to effuse through a porous barrier in 1.50 minutes. Under the same…

A: Given: Time of effusion of methane = 1.50 minutes Time of effusion of unknown gas = 4.73 minutes…

Q: 1 2 3 4 Name (write ions under) aluminum sulfide potassium nitride calcium chloride barium fluoride…

A: During ionic compound formation, metal atoms donate electrons to form cation and nonmetals accept…

Q: 9. Infrared spectrum and microwave spectrum of a diatomic molecule (50 words max): (i) What model…

A: Infrared spectroscopy deals with the interaction of a molecule with radiation from the…

Q: 6) How many grams of solute are in each of the following solutions? a) 1.20 L of 18 M sulfuric acid…

A:

Q: How many moles of H 2 will be produced if we produce 49.1 grams of ZnCl 2 in the reaction Zn + 2 HCI…

A:

Q: Which of the following equations represents a reaction that provides the heat of formation of…

A: The standard enthalpy of formation of a compound is the change in the standard enthalpy when one…

Q: A 5.00 L tank at 29.6 °C is filled with 17.3 g of boron trifluoride gas and 12.8 g of chlorine…

A:

Q: cis-3-methylcyclohexanol with each of the reagents below: a) Sodium metal b) PBr3 c) SOCI₂

A:

Q: What volume of 2.3 M solution of sodium carbonate is needed to deliver 100.0 gram of sodium ion?

A: Given, Molarity of sodium carbonate solution = 2.3 M = 2.3 mol/L Mass of sodium ion (Na+) = 100.0 g…

Q: 3) Provide the product/s and mechanism/s for each of the following reactions. i) ii) iii) OTS Br…

A:

Q: How many moles of HgO are required to produce 14.8 grams of O 2 in the reaction 2 HgO - -> 2 Hg + 02

A:

Q: Using the reagents below, list in order (by letter, no period) those necessary to prepare…

A: This conversion include oxymercuration of alkene compound in presence of metahnol solvent.…

Q: Calculate the potential of the electrochemical cell and determine if it is spontaneous as written at…

A:

Q: (d) Using the reagents below, list in order (by letter, no period) those CH3 o necessary to prepare…

A: The first step of the formation of the desired product is the benzylic bromination of the toluene.

Q: 10 magnesium nitride 11 gold (I) chloride 12 gold (III) chloride 13 gold (I) sulfide 14 gold (III)…

A: To write the  formula of a compound, first identify the cation and write down its symbol and charge.…

Q: (b) do Using the reagents below, list in order (by letter, no period) those necessary to prepare…

A: b) We have to synthesize compound B from fluorene. The given options are Ethyne NaC=CH2 NaCCH NBS,…

Q: Given the following selectivity coefficients for a K* ISE, which of the below ions would cause the…

A: Here we are asked to select the ion which cause the greatest interference.

Q: You calibrate a fluoride ion-selective electrode (F) with a series of fluoride standards. Plotting E…

A: Given that  The plot E (mV) vs. Log [F-] in fluoride ion-selective electrode gives a straight line…

Q: Ⓒ a. prane 1 но. tautomer of the structure becau OH O она [ALDSUNDIC] Alld Ньо b. show the detailed…

A: In ascorbic acid, there are several hydroxyl groups along with a double bond and a carbonyl group,…

Q: Given the following reaction: 2C₂H₂(g) +50₂(g) → 4CO₂(g) + 2H₂O(g) AH = -2511.6 kJ What is the…

A: Molar mass of C2H2 = 26.04 g/ mol

Q: Calculate the time required for electrolysis when a constant current of 0.852A is applied to produce…

A: We have to calculate the time needed for a constant current of 852 A to deposit 0.250 gm of cobalt…

Q: An arctic weather balloon is filled with 21.7 L of helium gas inside a prep shed. The temperature…

A:

Q: Using the equations 2 Sr(s) + O₂(g) → 2 SrO (s) AH° = -1184 kJ/mol CO₂ (g) → C (s) + O₂ (g) AH° =…

A: Hess's law states that overall change in enthalpy for a chemical reaction is equal to the sum of the…

Q: For each of the following ethers, fill in the blank with the IUPAC NAME of the ether. butoxy)butane…

A: The IUPAC names of the given ethers are listed below -

Q: 1) Describe Equimolar. 2) How is the maximum heat produced in a compete Neutralization? I

A: Question 1 -->  Equimolar -  The equimolar substances are defined as the substance which are…

Q: Using the reagents below, list in order (by letter, no period) those CH3 necessary to prepare…

A: In this question, we will see all three reagent in each steps which give final product from the…

Q: For the chemical reaction H₂ (g) + F₂ (g) → 2 HF (g) AH° = -79.2 kJ/mol. What is the molar enthalpy…

A:

Q: Molecules with they lack the rigidity necessary for alignment. O only single and double bonds O only…

A: To solve this problem we have to fill in the blank and calculate the enthalpy of reaction .

Acid Base Titration

An acid-base titration is the method of quantitative analysis for determining the concentration of an acid and base by exactly neutralizing it with a standard solution of base or acid having known concentration.