An open container made of metal is placed ona scale. Water flows into the container through an opening at the top. At the same time, water flows from the container through the two-equal 45° deflection opening at the sides (Figure Q2). The metal cylinder height is 65 cm, having a diameter of 26 cm, and weighs 21 N when empty. Under normal steady flow conditions, the water level maintained at 58 cm measured from the bottom of the container. One of your friends claims that we can treat this as a simple statics problem by sayi ng that the scale will measure the weight of the volume of water in the tank plus the tank weight only but you disagree with his /her statement. You make a message that says that flow analysis is required. Proof that you are right|

An open container made of metal is placed ona scale. Water flows into the container through an opening at the top. At the same time, water flows from the container through the two-equal 45° deflection opening at the sides (Figure Q2). The metal cylinder height is 65 cm, having a diameter of 26 cm, and weighs 21 N when empty. Under normal steady flow conditions, the water level maintained at 58 cm measured from the bottom of the container. One of your friends claims that we can treat this as a simple statics problem by sayi ng that the scale will measure the weight of the volume of water in the tank plus the tank weight only but you disagree with his /her statement. You make a message that says that flow analysis is required. Proof that you are right|

Name: °4545V,ScaleA1 = 95 cm?Vi = 305 cm/s%3DA2 = A3 = 43 cm?%3D%3DFigure Q
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: °4545V,ScaleA1 = 95 cm?Vi = 305 cm/s%3DA2 = A3 = 43 cm?%3D%3DFigure Q2 An open container made of metal is placed ona scale. Water flows into the container throughan opening at the top. At the same time, water flows from the container through thetwo-

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A U-shaped tube is filled with water of density 1000 kg/m3 until the level of the liquid is 28 cm above the bottom of the tube. Then oil of specific gravity 0.78 is poured into one branch of the tube until the level of the liquid in the other branch is 34 cm above the bottom of the tube. (g=9.8m/s2) I) Find the level of the oil-water interface in the branch where the oil was spilled II) Find the level of the oil-air interface in the branch where the oil was spilled
Problem (2) Neglecting friction, find the horizontal force of the water (N) on the horizontal bend shown in the figure. V, = 10 m/s %3D 8 cm dia. V2 4 cm Answer:
In the figure, the water level in a 1.8 m high and 0.9 diameter cylindrical tank is 1.4 m. If this tank is rotated with an angular velocity that can be inserted into the corner of its axis, the water in the tank will start to spill? Take the density of the water as 1000 kg / m3, the gravitational acceleration as 10 m / s2 and the value as 3.
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. ( WITH FREE BODY DIAGRAM ) CHOIECES: A.2.56 B.-2.72 m C.12.74 m D.-4.67 m
(1) The mercury manometer in the Figure below is connected to the inlet and outlet of a water pump (the left side to the inlet and the right side to the outlet). Assuming that the inlet and outlet are at the same elevation, determine the pressure increase for the pump. Inlet and outlet clevation Water hy =15 cm Mercury 13.9 keiul. Density of mercury = 13.6 g/cm3 = 13,593 kg/m3 Density of water = 1.0 g/cm3 = 1,000 kg/m3
(1) The mercury manometer in the Figure below is connected to the inlet and outlet of a water pump (the left side to the inlet and the right side to the outlet). Assuming that the inlet and outlet are at the same elevation, determine the pressure increase for the pump. - Inlet and outlet elevation Water hy =15 cm Mercury 13.93 kpin! Density of mercury = 13.6 g/cm³ = 13,593 kg/m³ Density of water = 1.0 g/cm³ = 1,000 kg/m³
A closed vessel contains water up to a height of 2 m and over the water surface there is air having pressure 8.829 N/cm^2 above atmospher. At the bottom of the vessel there is an orifice of diameter of 15 cm. Find the rate of flow of water from orifice. Take Cd=0.60. answer (155.75 L/s)
A closed vessel contains water up to a height of 2 m and over the water surface there is air having pressure 8.829 N/cm^2 above atmospher. At the bottom of the vessel there is an orifice of diameter of 15 cm. Find the rate of flow of water from orifice. Take Cd=0.60. 125.75 L/s 135.75 L/s 115.75 L/s 155.75 L/s
Determine the minimum time to withdraw 50 L of kerosene from the cylindrical tank with 147.43 cm long to the can with 20 cm height put in the ground if we use a siphon hose with diameter is 16 mm. take kerosene density 810 kg/m^3?
In the communicating vessels with diameters D1=8 cm and D2=4 cm, a liquid of density p=1000 kg/m3. By how much will the level of the liquid in the containers rise, if one A certain body of mass m=200g of density p0<p?
A scuba tank is dropped overboard and sinks to the ocean floor 20 ft below (T = 62 F). The composite metal (SG = 4.5) tank has a mass of 31.7 lbm when empty and has an internal volume of 0.355 ft3. The tank is currently filled with air to about 3000 psig. To retrieve the tank, you plan to dive down, open the valve, and let out air until the tank begins to float upward. Will this work? If so, what will be the pressure in the tank (psig) when the scuba tank first lifts off the ocean floor? If not, why not?
During a trip to the beach (Patm = 101 kPa), a car runs out of gasoline (density is 750 kg/m^3), and it becomes necessary to siphon gas out of another nearby car to a tank of a volume of 4 litres using a hose whose cross-sectional area is 0.2 cm^2. The shown setting is used where L1=0.7 m and L2=2.2 m. Consider point 1 to be at the free surface of gasoline in the tank so that P_1= 1 atm, V_1 ~= 0 since the tank is large relative to the tube diameter. Consider the gravitational acceleration to be 9.81 m/s^2. Using Bernoulli equation, the pressure at point_3 in kPa is: Select one: O a. 72.55 Z3 Ob. 122.34 Gasoline OC. 79.66 siphoning tube L2 Gas tank L1 22 Gas can/