An inductive reactance of 10 ohms is connected in parallel with the capacitive reactance of 30 ohms. If the combination is connected in series with a 10 ohm resistance. The given voltage is 200V.   *What is the total real power of the system in magnitude with unit of kW?    *What is the total real power of the system in magnitude with unit of kVAR?   *What is the total impedance in polar form in ohms?   *What is the total real power of the system in magnitude with unit of kVA?    *What is the total current in polar form in A?

Q: A power station has to meet the following demand : Group A : 200 kW between 8 A.M. and 6 P.M. Group…

A: The solution can be achieved as follows.

Q: In Industry, three Inductive loads, each of resistance R = 38 ohms and inductance L = 0.18 H are…

A: In this question,  Impedance is connected in delta with 430V, 50/HZ supply.  We know X= wL Find the…

Q: In three phase power measurement using one watt-meter method, if the load is balanced then the total…

A: Right Answer option TRUE

Q: A residential four-wire system supplies power at220 V rms to the following single-phase…

A: (b) For first phase total load are – Since loads are bulb so that total power is real and reactive…

Q: According to the relevant legislation, the reactive energy tariff is not applied to household…

A: According to the relevant legislation, the reactive energy tariff is not applied to household…

Q: 7. A power station has to meet the following load demand : 50 kW Load A between 10 A.M. and 6 P.M.…

A: The solution can be achieved as follows.

Q: A 15kV, 3 phase circuits feeds a load of 10,000 kW at a lagging load factor and the load current of…

A:

Q: A load consists of R=78 Q, XL=71 Q and Xc=47 Q. All the elements are connected in parallel across…

A:

Q: The line-to-neutral voltage at the terminals of the balanced threephase load in the circuit shown is…

A:

Q: Q1: Calculate the total real power absorbed by the lond shown. if V416 V is applied, with and…

A: In the question,  We are calculating the total real power and reading of watt-meters. 3 phase…

Q: B1, (i) A domestic lighting installation having 25, 75 W lamps is operated as follows: 7 lamps 6 Pm…

A: According to the question we have to calculate the value of daily load factor,  monthly load factor,…

Q: A substation rated 1250 kVA is operating at full-load at 0.8 pf lagging and to carry an addition…

A: A substation is a place included in the electrical power generation system where electrical voltage…

Q: H. W.: A 3-phase overhead transmission line is being supported by three disc insulators. The…

A:

Q: 7. A power station has to meet the following load demand : 50 kW Load 4 between 10 A.M. and 6 P.M.…

A: The solution can be achieved as follows.

Q: An impedance (inductive) ZL = (11.5 + j10) ohms is connected in parallel with an impedance…

A: The admittance of the inductive branch is given by, YL=1ZL=111.5+j10 =111.5-j10 11.5+j10 11.5-j10…

Q: Two impedances (14 +j5)Nand (18 +j10) N are connected in parallel across a 200-V, 50-Hz supply.…

A:

Q: Q3. Each phase of a delta-connected load comprises a resistance of 300 and an 80µF capacitor in…

A:

Q: The inductive reactance in series with Z in the circuit shown below has a value of 25 ohms. If the…

A: In this question,  What is reactive part of Z in shown the figure.  Power P= I2 R

Q: Given the following load impedances in delta and the impressed voltages as follows:    Vab = 220∠0 º…

A: Given,Phase voltages are,Vab= 220∠0°Vbc= 220∠240°Vca= 220∠120°The load impedances are,Zab=8+6j  Ω…

Q: B1, (i) A domestic lighting installation having 29, 70 W lamps is operated as follows: 7 lamps 6 Pm…

A:

Q: 18 10+j5 Rejf6 25 For the circuit shown below, Take Van = 100 Vrms and the transmission line…

A: solve prob..

Q: Draw the impedance diagram of the following power system in per unit using base power = 100 MVA and…

A:

Q: . A star connected load is supplied a 440 V, three phase source, CBA circuit where the total power…

A: Given data VL=440V W1=1950w W2=1200w

Q: A factory takes a steady load of 0.22 MW at a 82% lagging (pf). The tariff is Rp 18000 per kVA of…

A: Given: A factory takes a steady load of 0.22 MW at an 82% lagging (pf). Peak load of factory, P=0.22…

Q: Which of the following descriptions IS NOT correct for loads in power systems? A. The purely…

A: capacitive load will deliver reactive power to the grid.     so option C is the wrong one

Q: Three loads connected in parallel across a 1000-V (RMS), 60-Hz single-phase source. Load 1:…

A:

Q: an impedance diagram for the electric power system as shown in fig, and all impedances per-unit on a…

A: Given, G1: 90 MVA, 20 KV, 0.09 puG2: 90 MVA, 18 KV, 0.09 puT1: 80 MVA, 20/200 KV, 0.16 puT2: 80 MVA,…

Q: Assume that the magnitude of voltage source V, is 87.14V, apply Ohm's Law and Kirchhoff's Voltage…

A: In the  question  we are finding the power in 5A. current source using kirchhoff law. Power = VI

Q: 1.3. The annual load of a substation is given in the following table. During each month, the power…

A: Below are the codes required to generate the load curve using barcycle function.

Q: inductive loads each having a resistance of 10ohms and inductor of B H ohms,are connected to 400V…

A:

Q: A domestic lighting installation having 18, 60 W lamps is operated as follows: 7 lamps 6 Pm till 8…

A: Given, a domestic lighting installation having 18, 60 W lamp, So, lamp rating = 60 W

Q: O A Library office is fitted with four units of 20W Compact Fluorescent Lamp (CFL) downlights and…

A: First calculate active and reactive powers of the individual loads.  Total active power is sum of…

Q: The load in the circuit shown absorbs 50 kVA of complex power at power factor pf = 0.83 lagging when…

A:

Q: In the case of reactive power compensation in a low voltage distribution network and increasing the…

A: In compensation of reactive power of a network, the active power consumed by network always remains.…

Q: In the figure below, two wattmeters are properly connected to the unbalanced load supplied by a…

A:

Q: TWO-WATTMETER method is used to measure the total real power of the load in Problem , where…

A:

Q: source delivers 50 kVA to a load with a power factor of 65 percent lagging. Find the load’s average…

A: We need to find out power of the given loads .

Q: A load consists of R=78 Q, XL=71 Q and Xc=47 Q. All the elements are connected in parallel across…

A: Given, a load consist of R= 78 ohm XL= 71 ohm XC= 47 ohm All elements are connected in parallel…

Q: The weekly discharge of a typical hydroelectric plant is as under: Day Sun Mon Tues Wed Thurs Fri…

A: Given, The weekly discharge of a typical hydroelectrical plant is as under, Plant has an effective…

Q: In figure below the rating of reactance and various components are shown. A load of 50MW at p.f.…

A: Let 100MVA and 11KV be the base in the generator circuit. accordingly the base in transmission line…

Q: Course: Electrical Engineering Subject: Electrical Apparatus Instructions: Write the GIVEN with…

A:

Q: Two balanced three-phase loads are supplied by 840 Vrms, 60hz line as shown below. Load 1 is…

A:

Q: Example 2.4 Three loads are connected in parallel across a 1400-V rms, 60-Hz single-phase supply as…

A: Three loads are connected in parallel across 1400volts , 60 hz rms supply. i.inductive load is…

Q: The annual load of a substation is given in the following table. During each month, the power is…

A: Below are the codes required to generate the load curve using barcycle function. Above is the…

Q: A 60-Hz, single-phase power line and a telephone line are parallel to each other as shown in the…

A:

Q: A three-phase system has balanced conditions so that the per-phase circuit representation can be…

A: The three-phase system diagram is shown below, Here,The load voltage is,VL=4kVrmsThe load impedance…

Q: A11 kV,15 km length primary feeder connected to a balanced load of 950 kW at a power factor of 0.85…

A: We assumed three phase feeder as nothingI is mentioned about single phase or three phase. given…

Q: H. W.: A 3-phase overhead transmission line is being supported by three disc insulators. The…

A: Given,  Number of insulator disc (n)=3 Voltage across the top unit (V1)= 9 kV Voltage across the…

Q: Draw a reactance diagram for the electric power system shown in Fig. 2 showing all reactances in…

A:

Q: An impedance (inductive) ZL = (11.5 + j10) ohms is connected in parallel with an impedance…

A: Given ZL=11.5+j10 ΩZC=8-j20 Ω circuit diagram is

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.