An induction motor having full load torque of 60 Nm when delta-connected develops a starting torque of 120 Nm. For the same supply voltage, if motor is changed to star -connection, then starting torque developed will be Nm.
Q: The charge entering the positive terminal of an element is q = 5 sin 4πt mC while the voltage across…
A: It is given that: q=5sin4πt mCv=3cos4πt V
Q: (a) What is meant by amplifier gain quoted in dB? (b) If an amplifier provides a gain of 20dB when…
A: “Since you have posted multiple questions, we will provide the solution only to the first question…
Q: Find the final value of the system corresponding to Y(s) - a(s+5) 2s(s²+2s+b)' where a = 7 and b =…
A: here we have to find the final value of the Y(s)
Q: Consider the following bode plot representing a filter with a constant term greater than 1, two…
A: The given problem is from control system bode magnitude plot. The detailed solution is given in the…
Q: Both switches close at t=0 after having been open for a very long time. (a) Find v(t). (b) Determine…
A: Solution: Given data: V(1)=120V V(2)=6V R(1)=200ohm R(2)=50 ohm C(1)=8 micro farade L=125mH…
Q: (b) The transfer functions of the plant and feedback controller are given 2 2 (S-1) (S + 3)…
A: In this question we need to find the close loop transfer function of the given system and comment on…
Q: What is the feedback topology of the amplifier shown below? R = 10 ΚΩ W Rin Q₁ Select one: O a.…
A:
Q: Television channel are 6MHz wide . a) How many bits/sec can be sent if eight levels signals are…
A: The bandwidth of the channel, BW=6 MHz Level of signals, V=8
Q: Consider the following bode plot representing a filter with a constant term of 100, one zero, and…
A: The given problem is from control system of bode magnitude plot The detailed solution is given in…
Q: A discrete source emits one of five symbols once every millisecond with probabilities 1/2/4/8/16 and…
A: Px1=12,Px2=14,Px3=18,Px4=116,Px5=116
Q: A continuous-time signal, x(t), has a Fourier transform denoted by X (w), and is expressed as: a)…
A: The above question is based on the concept of inverse Fourier transform. Please note that only part…
Q: Consider the circuit shown in Fig. calculate the total impedance and determine: a) The maximum…
A: It is given that:
Q: 4 +4 2 s²+35+2 4 2.3 G(s) = +45 +4 2.1 G(s) = S² 2.2 G(s)=- 25 7.4 G(S)=² +65 +25
A:
Q: Explore the numerous access control classes. Discuss the many controls that may be added to any…
A:
Q: 1. Draw a logic diagram for the equation : Y = AB • B+C 2. Construct the circuit using the diagram…
A: The given boolean expression needs to be implemented using the logic gates and the same needs to be…
Q: 18. The ac rms antenna current of an AM transmitter is 6.2 A when unmodulated and rises to 6.7 A…
A: An AM transmitter of antenna is having, AC RMS antenna unmodulated current, Ic=6.2 A. Modulated…
Q: Q3) The Voltage-divider bias circuit shown below is to be designed operate Efficiently stabilized.…
A: For the given voltage divider bias circuit the value of the bias resistor needs to be calculated.…
Q: for the network below @ find the current I, and Is Find the voltages Vs and V3 4A IO E R₁721 Is R2 M…
A:
Q: D. Pitch and Distribution factors Jsl Multi tumn Full Pitched Coll 1. Explain a Pitch and…
A: -Pitch factor -distribution factor
Q: A 741 OP-AMP has a gain-bandwidth product of 1 MHz. A non-inverting amplifier using this OP-AMP and…
A: A 741 OP-AMP has, A gain-bandwidth product, GBWP=1×106 Hz. In a non-inverting amplifier voltage gain…
Q: a. b. C. d. 7jw eX() 3 e7jw et X (74) 3 7jw 3X() -X(w) e p7jw 3
A:
Q: With a operational frequency of 30GHz, what is the effective length of a half-wave dipole?
A: Step-1-> The effective length of a half-wave dipole can be calculated using the formula: L=λ2…
Q: QI. A discrete-time signal is given with a combination of two exponentials as below: н x[n] = (-)"…
A:
Q: The following measurements were made on a resistive two-port network: Condition 1- create a short…
A:
Q: 3. For the network of Figure 3, determine: a. V₁ b. ID and VGS c. VD and Vs d. VDs VG 910 ΚΩ + Vase…
A:
Q: where is the phase angle and the equation of the waveform?
A: Here, we need to calculate the phase angle and the equation of the waveform given.
Q: FIND i(t), t>0 t=0 -36V -6.02 12:02 2H
A:
Q: Compute the value in μF for C that yeild a first-order high-pass filter with a passband gain of 8…
A: In this question We need to determine the value of capacitance C if gain is 8 and cut off frequency…
Q: The current flowing through a 22.6H inductor is given by iL (t) Find the voltage across the inductor…
A: In a circuit, Inductance, L=22.6 mH. Current through inductor, iLt=575e-20t mA. To calculate the…
Q: Complete the simulation table for the 1-bit register until cycle 4 considering the following inputs:…
A: To complete the simulation table for the 1-bit register until cycle 4, we need to calculate the…
Q: using constant voltage model, find V_out given that, V_in=6V, R1= R2= 1K ohm and V_B= 1V Vinº D₁ W…
A:
Q: An earth satellite has onboard a 12-v battery that supplies a continuous current of 0.5A. Solar…
A: Voltage of battery =12 v Continuous Current supplied by battery =0.5 A Time the solar cells…
Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t = 850 ms is: O a.…
A: Capacitance C=2 mF. Voltage V=525cos20t V. Time t=850 ms =0.850 sec.
Q: The primary of 200/1 A, 5 VA, 0.8 pf current transformer carries 100 A. The secondary current is…
A: It is given that: turns ratio or nominal turns ratio, K=2001VA=5cosϕ=0.8 pfIp=100 AIsec=0.495 A
Q: 3- given points A(8,-5, 4) and B(-2, 3, 2), find: a) the distance from A to B. |BA| = |(-10, 8, -2)]…
A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…
Q: 28. A voltage waveform is shown below, please find its RMS voltage value. Choose the value that is…
A:
Q: 23/ For the JFET transistor shown in figure (1), find the following :- VGsa, IDQ, VDS, VG, VD and…
A:
Q: Vref (8) KA 1+0.05s Amplifier VR(S) 1+0.58 Exciter Vp(s) 0.8 1+8 Generator Vt(s)
A:
Q: Find the power delivered to an element at t = 3 ms, if the current entering its positive terminal…
A: It is given that: i=5cos60πt Av=3didt
Q: V DC separately excited motor has ure resistance 2 ohms and voltage constant V /rad/s. The field…
A: V = 100 V Ra = 2 ohm Kb= 0.6 V/rad/s T= 20 Nm Kt = 50 Nm/s
Q: Find the Norton current for the circuit below at terminals a-b. Ο IN=1,404 <9,40 A IN=1,639 <10:30 Α…
A:
Q: A single period of the magnitude and phase spectra of a discrete-time signal is shown below. What is…
A: Asked to find the following time domain expression of signal Fourier transform of the given…
Q: 11 Ia 6-j8 Ω 440-120° V It 6-j8Q2 N For the three-phase Y-load circuit shown above: (a) Find the…
A:
Q: Problem I a. Is the Logic Family 1 output compatible with the Logic Family 2 input? b. If…
A: Given data For Logic Family 1, VOHmin=3.5 V, VOLmax=0.5 V VILmax=1.4 V, VIHmin=3.4 V For Logic…
Q: *2. If a 1500-kHz radio wave is modulated by a 2-kHz sine-wave tone, what frequencies are con-…
A: Frequency of modulated radio wave, fc=1500 kHz.. Frequency of modulating sine wave, fm=2 kHz.
Q: Use your personal key number N to find the values to use in solving. Show your work and explain your…
A:
Q: Give the analogous quantities for electrical voltage in linear mechanical, pneumatic, hydraulic and…
A: There are two questions a) Analogous quantities for electrical voltage in linear mechanical,…
Q: 3. Given diagram below, implement an equivalent circuit using ONLY NA and NOR gates. Conditions: All…
A:
Q: Convert the following systems to signal flow graphs and solve for the transfer function using…
A: Given: Block diagram of a control system, To find: We have to make signal flow graph from the…
Q: Analyze the timing diagram. Which flip-flop is being used?
A: For the given input to flipflop, clock, preset, and clear input the respective output of the…
Step by step
Solved in 3 steps
- The field windings of the series motor have a resistance of 120 ohms at 15-degree C. After running for two hours, the resistances increase to 140 ohms. If the temperature coefficient of the windings at 0 degree C is 0.004, find the new windings of the temperatureA freewheeling DC motor is driven with 1000 rpm and a nominal load torque of 80Nm. The field circuit resistance is 200 and the armature circuit resistance is 0.2 O. The field coils are fed with a zero degree transmission angle through a single-phase fully controlled converter connected to a single-phase 240V source. The armature circuit is fed from a single phase 400V source through another fully controlled converter. Magnetic saturation has been neglected, the motor constant is given as 0.8 V - s / A - rad. Assuming that there is no fluctuation in armature and field current, find the control angle of the converter feeding the armature at nominal load. If you want to leave the question blank, click again on the option you marked.A repulsion start, induction run motor is used to drive a fan. The motor has a rated power of 2kW and operates at 220V. The repulsion start winding has a resistance of 0.5 ohm while the induction winding has a resistance of 0.3 ohm. Determine the total loss in the motor, assume 0.8 pf.
- 8. A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical power developed by the motor is ............ (i) 20 W (iii) 500 W (ii) 980 W (iv) 200 W6- Which of the following supply is given to the rotor winding of 3-Phase Induction Motor: a) DC Supply b) AC Supply c) No Supply d) Pulsating Supply 7- 3-Phase Induction Motor will have Starting Torque and Starting Current a) High, High b) Low, Low. c) High, Low d) Low, High 8- Which of the following method is used for controlling the speed of an induction motor: a) Changing number of stator poles b) Supply voltage control c) Frequency control d) All the options are correct 9- Which of the following method cannot be used for starting of 3-Phase Squirrel Induction Motor: a) Star-Delta Starting b) Line resistor startling c) transformer Starter d) Rotor Resistance Starting 10- The rotor of a stepper motor has no: a) windings b) commutator c) brushes d) all of the aboveThe efficiency of 3-ph induction motor. at (Is=4.5A, T=13 N.m, N=1333 rpm, Pph=864 watt ) is
- A DC shunt generator delivers 45 A at a terminal voltage of 220 V. The armature and the shunt field resistances are 0.01 2 and 44N respectively. The stray losses are 375 W. What is percentage efficiency of the DC generatorThe name plate of single phase induction motor has following data output 373W,230V, frequency 50Hz. Input current 2.9A and power factor is 0.71. Speed 1420 rpm What is efficiency of motor.the field windings of a series motor has a resistance of 120 ohms at 15° c. after running for 2 hours, the resistance has increases to 140 ohms. if the temperature coefficient of the windings at 0°C is 0.004, find the new temperature of the windings
- A four-pole induction motor drives a load at 2478 rpm. This is to be accomplished by using an electronic converter to convert a 400-V dc source into a set of three-phase ac voltages. Part A Find the frequency required for the ac voltages assuming that the slip is 4 percent. The load requires 2 hp. Express your answer to three significant figures and include the appropriate units. f= Submit Part B Value I = HA Request Answer Submit If the dc-to-ac converter has a power efficiency of 90 percent and the motor has a power efficiency of 80 percent, estimate the current taken from the dc source. Express your answer to three significant figures and include the appropriate units. HÅ Value Units Request Answer ? Units ?A 110 V, 60 Hz, 6 – pole single phase induction motor 1/3 hp has the following equivalent circuit impedances: RI = 1.52 ohm, R2 = 3.13 ohm and x1 =2.10 ohm, x2 =1.56 ohm. Xm=58.2 ohm, The Friction, windage and stry losses =16W, the core loss = 35 W, For a slip of 0.05, calculation (a) input current, (b) power factor, (c) developed power, (d) output power, (e) speed (f) in put power (g) air gab power (h) T ind (i) T load 6) efficiency.The dc series motor has a linear torque- speed characteristics. O True O False