A uniform straight wire with crossectional area of 8,1 mm and length of 10,0 cm carries a current of 8,0 milli-Amperes. If the potential difference between its ends is 8,1 Volts, calculate the conductivity of the material that it is made up of in units of Siemens/meter. Select one: a. 1250 b. 0,820 c. 12,2 d. 1,22 e. 0,0800

Q: A portion of an overhead conductor is taken to be s metres long. The tension in the conductor is T…

A: The vertical difference in level between points of support (most typically transmission towers) and…

Q: 6. Consider 2 rectangular copper lines connected by a cylindrical via of resistance 2 N, as shown…

A: Resistance is defined as: R=ρlAWhere ρ is resistivity in Ωml is length of the conductor in mA is…

Q: A coaxial cable of consists of two concentric cylindrical conductors. The region between the…

A: Here we will use formula of resistance ,

Q: . A conductor whose diameter is 0.175 inches has a resistance of 0.5 ohms. The wire is drawn through…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Consider a resistor of resistivity 2.82 × 10-8 Ω • m. If an electric field of 17 V/m is applied…

A: Given Data, The value of Resistivity =2.82×10-8ΩThe value of Electric field is  17V/mThe value of…

Q: Through two parallel wires A and B, 10A and 2A of currents are passed respectively in opposite…

A:

Q: C) A 50-m-long copper wire has a circular cross section with radius r= 2 cm. Given that the…

A:

Q: It is found that the resistance of a coil of wire increases from 40 ohms at 15 degrees Celsius to 50…

A:

Q: 5. A long copper wire carries a current of 20A which is evenly distributed in each cross-section of…

A: It is given that: I=20 AD=4mmr=2mmresistance per unit length=5Ωkm=5×10-3Ωm

Q: 45. With regards to the comparison of the čonduction of electricity along a uniform wire with the…

A: ans . A (1,2)

Q: In your own words, define a. an ideal conductor; b. an ideal voltage source; c. an ideal current…

A: Ideal conductor : An ideal conductor has the greatest capacity to flow of electron it has zero…

Q: Under some conditions, it is possible to approximate the effects of ferromagnetic materials by…

A: Given  Few parameters of cylindrical wire,we need to determine magnetic field, magnetic field…

Q: Compute the resistance of a conductor whose resistivity is 20.54 ohm-CM per foot with circular…

A:

Q: Q9: Find the length of copper wire of diameter (1mm) which will have a resistance of (IKN) and…

A: Given: For a copper wire, The diameter is d=1 mm Resistance is R=1 KΩ Conductivity is σ=5.8×107 S/m…

Q: very thin spherical shells are given as in the figure below. Let the loads with the inner shell load…

A: very thin spherical shells are given as in the figure below. Let the loads with the inner shell load…

Q: A copper (Cu) wire with a radius of 4 mm is connected to the end with an aluminum (Al) wire with a…

A:

Q: Calculate the resistance of a metal conductor 20 m length of a wire having a uniform cross-sectional…

A: a) Resistance =( resistivity × length)/area  R = (50×10^-8×20)/(0.1×10^-6) R= 100ohm

Q: Is the thickness of an insulating material considered as the outer radius in computing the…

A:

Q: An electric wire having a mass of 0.5 kg/m along the horizontal is suspended between supports of the…

A: It is given that: ω=50 Nmmaximum tension=800 Nl=50 m

Q: If a wire is made of a material that has zero resistance at -123.40C, its temperature coefficient of…

A: the relation between the resistance and temperature is given by  RT​=RT′​[1+α(T−T′)] where,  α =…

Q: 6. The radii of the inner and outer conductors of a coaxial cable of length L are a and b,…

A: 6. From the question given data is as follows: Coaxial cable length=L Inner radius=a Outer radius=b…

Q: Consider a conductor of length L and cross-sectional area A. The material of which is constituted…

A: We need to find out the current and voltage for given conductor,

Q: A cylindrical wire has length 40 cm, cross-sectional area 60 mm², and resistance 3.0 22. The wire is…

A: Given data, The length of wire is 40 cm, The cross-section area of the wire is 60 mm2, The…

Q: A 1,200 mm long copper wire has a cross-sectional radius of 0.5 cm. (a) What is the resistance of…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A) Explain briefly various theories of breakdown in liquid dielectrics. B) What are the requirements…

A: A) A liquid can be assumed as a highly compressed gas in which molecules are very closely arranged.…

Q: A long copper wire carries a current of 15A which is evenly distributed in each cross-section of the…

A: we have given A long copper wire carries a current I=15A diameter of the wire d=3 mm resistance per…

Q: The number of the electric field lines, between two charged particles, is proportional to the amount…

A: The electric field lines give all the information about the direction and magnitude of the electric…

Q: -B- An electric cable of 20 mm in diameter and L=1m is to be insulated with plastic (k=0.175W/m.K).…

A: It is given that: r1=202=10 mmK=0.175 W/mKT∞=30°CT1=70°Ch=9.3 W/mK

Q: Design a 1500-meter-long electrical transmission line with a cross-section size of 0.00199 cm2 that…

A:

Q: An AWG #10 copper conductor has an 80.8-mil diameter. A 50-foot long conductor of this type carries…

A:

Q: 2. Consider a Coaxial Cable that is made up of three regiọns. From 0<r<a the cable is made of a…

A: Considering a coaxial cable that is made up of three regions. From 0&lt;r&lt;a the cable is made up…

Q: It is found that the armature of a coil of wire increases from 50 ohms at 20 deg C to 60 ohms at 56…

A:

Q: The current density in a copper wire of radius 0.750 mm is uniform. The wire's length is 5.00 m, the…

A: Given values are - r=0.75mm=0.75×10-3mL=5mV=0.2VoltElectron densityn=8.10×1028m-3 Given that wire is…

Q: 3) .A conducting material of uniform thickness h and conductivity o has the shape of a quarter of a…

A:

Q: A long, straight wire has a radius R=0.5cm and carries a current I=10A that is NOT uniformly…

A: The general expression for B for the following cases is determined as shown  below

Q: A copper transmission cable (p = 1.72 × 10¬8 Nm) 250 km long and 20 cm in diameter, caries a current…

A:

Q: 4. An aluminum conductor having a cross-sectional area of 1843 MCM is used to transmit power from a…

A:

Q: Q4) The resistance of the wire used for telephone is 35 per kilometre when the weight of the wire is…

A: Given,Resistance of wire, R=35 Ω/km.Weight of wire, W=5 kg/km.Specific resistance, ρ=1.95 ×10-8…

Q: a) In an experiment using a copper made conductor, the resistance of the conductor which has a…

A: Write the given values in the question.

Q: In the Electric Field Mapping experiment, you used two electrodes separated by a distance L and a…

A: An electric field mapping experiment is conducted to find the electric potential in space or in…

Q: A #10AWG stranded copper wire has 37 strands, each strand has a diameter of 0.0167 inch, and a…

A:

Q: Two Conducting Plates of Size 15m are inclined at (450) to each other with gap of width 4mm…

A: It is given that:Conducting plates size=1×5θ=45°W=4mmV=50 voltεr=1.5

Q: For an electrical component, the formulas for charge and voltage are given below. A is 9 coulombs,…

A:

Q: conductor with a current of 200mA passing through it converts 40 J of electrical energy into heat in…

A: In this question we will find potential drop across conductor...

Q: The resistance of a cylindrical brass conductor has a resistance of 0.00108 ohm with 0.5 cm diameter…

A: Given :-Case-1:-Resistance of brass=0.00108Ω=R1Diameter , d1=0.5cm=0.5*10-2 mLength ,…

Q: A potential difference of 100 volt exists between the ends of a conductor having length of 300 cm.…

A: We have a conductor having, Potential difference (V) = 100 V Length of conductor (l) = 300 cm = 3 m…

Q: Suppose we have two conductors A and B. If we place charges on A by amount Q while leaving B…

A: Let the charge of the conductor A is Qa and charge on the conductor b is Qb Charge distribution = ρ

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.