A titration of 25.00 mL of sulfuric acid required 37.22 mL of 0.1124 M NAOH reach the endpoint. What is the molarity of the acid?

Q: Calculate the volume in milliliters of 0.368 M KOH necessary to titrate 0.0209 moles of acetic acid…

A: Given : Concentration of KOH = 0.368 M Moles of HOAc = 0.0209 mol

Q: 220 mL of 0.03 M NaOH were added to 200 mL of 0.03 M benzoic acid (pKa = 4.2). What is the pH of the…

A: When NaOH is added to benzoic acid, sodium benzoate will form as per the chemical reaction:…

Q: In a titration experiment a 25.0 mL sample of a diprotic acid required 30.0 mL of 0.200 M NaOH for…

A:

Q: A 0.4000 M solution of nitric acid is used to titrate 50.00 mL of 0.237 M barium hydroxide.  What is…

A:

Q: Most of the titrations that have done to date require to titrate an acid with a base until we see a…

A: Most of the titrations Requires titration of an acid with a base until it gives a pink colour with…

Q: If you were to overshoot tje endpoint in the titration of your unknown acid, would youncalculated…

A:

Q: A solution of sulfuric acid (25.00 mL) was titrated to the second equivalence point with 36.55mL of…

A:

Q: Determine the concentration in molarity of 100ml acid solution used in titrating a 67.119g of sodium…

A: Introduction :  Molarity of a solution is defined as the number of moles of solute present in one…

Q: What is not correct in computing for the buffer capacity, if an additional acid is added a. The…

A: Buffer capacity is the amount of acid or base that it can effectively neutralize.

Q: What is the percentage of a total acid expressed as acetic acid (HC2H3O2) in a sample of vinegar if…

A: The quantitative chemical reaction of an acid and a base with each other is known as neutralization…

Q: In general, during a titration the pH of the solution changes slowly or quickly when far from the…

A: In chemistry, there are many ways to check the deviation of experimental data from the accurate…

Q: In a titration, is used in order to observe the equivalence point. O a. water b. base O c. salt O d.…

A: The details solution for this is provided below in step II

Q: molarity

A:

Q: 2. A 200 ml of 0.05 F hydrogen sulfide solution is added to 25 ml 1.5 F acetic acia solution.…

A:

Q: In a system where a weak acid is an analyte, a strong base is a titrant, what is the milestone pH…

A:

Q: Consider an acid-base titration in which the base is dispenssd from a burette into a flask…

A: For an acid- base reaction , M×V (acid) = M×V (base)where,M = MolarityV = Volume M (acid) = M×VV…

Q: A solution is made with 554 ml of 8.21 M HX solution and 549 mL of 6.06 M Nax solution and the pH at…

A:

Q: Which of the following statements regarding complexometric titrations is incorrect ?

A: Complexometric titrations: It is a kind of Volumetric analysis , where formation of colored complex…

Q: I have a solution of hydrocyanic acid, HCN, of unknown concentration. I titrate 100.mL of the HCN…

A: Titration is the process through which we determine the concentration of unknown solution by…

Q: What is the molarity of a 12.46 mL sulfuric acid solution if 18.22 mL of 0.100 M potassium hydroxide…

A: Stoichiometry is mainly based on the calculation of moles and volumes. These two values are used to…

Q: Benzoic acid extracted from 123.16 g of sample required a 27.13 mL titration with 0.0792 M barium…

A:

Q: A 40.0 mL sample of a 0.08 M HCl solution is titrated with a 0.10 M NaOH. What volume of tiltrant is…

A:

Q: In an acid-base titration,21.16 mL an NaOH solution are needed to neutralize 20.04 of a 01.0997 M…

A:

Q: If 35.0 mL of a 0.100 N acid solution is needed to reach the end point in titration of 21.5 mL of a…

A: Given, Normality of acid solution (N1) = 0.100 N Volume of acid (V1) = 35.0 mL Volume of base…

Q: Calculate the volume in mL of a 0.50 M NaOH solution that will be required toy titrate 1.2g of…

A:

Q: As the pH imerease, the solubility ए्पावि लिटाएपडए? Explain lead () hydro Yide baঠাपल एकानांवेर…

A:

Q: Question attached

A: The expression of dilution law is shown below: M1V1= M2V2 where; M1 = molarity of known solution  V1…

Q: At what point will a  buffer solution cease to moderate changes in pH? a. Only after all the acid or…

A: A buffer solution is the mixture of weak acid or base with their respective salts. They exhibit…

Q: What will be the molar concentration of potassium permanganate solution if 38.75 mL of this solution…

A: The answer to the following question is-

Q: need

A: A dilution can be performed not only to lower the concentration of the analyte that is being tested,…

Q: The concentration of a perchloric acid solution was established by titration against primary…

A: Given: The perchloric acid solution is titrated against standard sodium carbonate. Mass of sodium…

Q: A 15.00mL sample of ammonium hydroxide (0.980g/mL) is titrated with 31.25mL of 0.500M HCl. Find the…

A: Balanced equation of ammonium hydroxide and Hydrochloric acid NH4OH  + HCl  →NH4Cl  +H2O Molarity =…

Q: Consider an acid-base titration in which the base is dispensed from a burette into a flask…

A: The strength of an acid (in a flask) is determined as follows.…

Q: When 20.00 ml of sulfuric acid of unknown concentration is titrated with 0.1249 M NaOH,  32.50 ml of…

A: The solution is as follows :

Q: T or F: The normality of the solution obtained by dissolving the acid sample be approximately the…

A: The normality of a solution is calculated by the ratio between the gram equivalent to the solution…

Q: What is the percentage of total acid expressed as acetic acid (CH3COOH) in a sample of vinegar if…

A:

Q: Below is a titration curve for titrating a weak acid with NaOH. What is the pk,?

A: Befoe the equivalent point: In this range, the solution contains a weak acid and the salt of its…

Q: 4. A solution was prepared by dissolving 0.541 g of benzoic acid (HC,HSCOO) in 100 mL of water. The…

A:

Q: (a) In performing a titration, why is it better to use a solution of a concentration such that 30-45…

A: For an example, assume we have a base of higher concentration and we want to neutralize the acid of…

Q: Borax was used to standardize a solution of HNO3. Titration of 0.261 9 g of borax required 21.61 mL.…

A: Solution; - Reaction of borax with  HNO3 ; Na2 [B4O5 (OH)4 . 8 H20 + 2HNO3 →   4H3 BO3  + 2 NaNO3…

Q: How do i make a second derivative plot with a titration curve that has pH on the y axis and volume…

A: In acid-base titrations using pH, different types of curves are plotted to determine the equivalence…

Q: Which of the following statements regarding complexometric titrations is ? incorrect

A: In the pH range 3-10 the predominant species are H2Y2-2 and HY3-.

Q: 6g of impure NaOH were dissolved in water and the solution was completed to become 1L ,if 25ml of…

A: Molarity is the concentration term for number of moles of solute dissolved in one liter of solution.…

Q: If 31.0 mLmL of a 0.200 NN acid solution is needed to reach the end point in titration of 24.5 mLmL…

A: Given ,  Volume of acid (Va) = 31.0 mL Normality of acid (Na) = 0.200 N Volume of base (Vb) = 24.5…

Q: A titration of 25.00 mL of sulfuric acid required 37.22 mL of 0.1124 M NaOH to reach the endpoint.…

A: Given; The molarity of NaOH, (M1) = 0.1124 M. The volume of NaOH, (V1) = 37.22 mL. The volume of…

Q: Calculate the concentration of the acid, if 13.45 mL of 1M NaOH solution was needed to react with…

A: Given information, Volume (V1) of NaOH = 13.45 mL Concentration (M1) of NaOH = 1 M Volume of acid…

Q: What volume in mL of 0.1152 M NaOH is required to titrate 15.00 mL of 0.1073 M acetic acid (HAc)?

A:

Q: A 3.00 mL aliquot of 0.001 M NaSCN is diluted to 25.0 mL with 0.1 M HNO3.  How many moles of SCN-…

A: Given :Volume = 3 mL = 3 X 10-3 LMolarity of NaSCN = 0.001 MVolume after dilution = 25 mLMolarity of…

Q: Which of the following statements regarding complexometric titrations is incorrect

A: The "larger the formation constant" for the EDTA-metal complex, the sharper the end point.

Acid Base Titration

An acid-base titration is the method of quantitative analysis for determining the concentration of an acid and base by exactly neutralizing it with a standard solution of base or acid having known concentration.