A suitable target for the titration is 30.0 cm3 of 0.025 moldm-3 Br2(aq) Justify why a much smaller target titre would not be appropriate Calculate the amount in moles of bromine in the target titer Justification? calculate a suitable massof alive oil to transfer to the volumetric flask using your answer to of above question and the structure of Y Assume that the olive oil contains 85/- of Y by mass (If you were unable to calculate the amount of bromine in the target titer,you should assume it is 6.25×10^-8 mol .this in not the correct amount)

A suitable target for the titration is 30.0 cm3 of 0.025 moldm-3 Br2(aq) Justify why a much smaller target titre would not be appropriate Calculate the amount in moles of bromine in the target titer Justification? calculate a suitable massof alive oil to transfer to the volumetric flask using your answer to of above question and the structure of Y Assume that the olive oil contains 85/- of Y by mass (If you were unable to calculate the amount of bromine in the target titer,you should assume it is 6.25×10^-8 mol .this in not the correct amount)

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.5QAP

See similar textbooks

Similar questions

A series of solutions containing NaOH, Na.CO, and NaHCO, alone or in compatible combination, was titrated with o.1202 needed to titrate 25.00-mL portions of each solution to (1) a phenolphthalein and (2) a bromocresol green end point. Use this information to deduce the composition of the solutions. In addition, calculate the mass in milligrams of each solute per milliliter of solution. M HCI. Tabulated below are the volumes of acid (2) (1) (а) 22.42 (Ъ) 15.67 (c) 29.64 (d) 16.12 (е) о.00 22.44 42.13 36.42 32.23 33.333
Five drops of dichlorofluorescein have been added to a solution containing 0.800 g sample which required 25.30 mL of 0.100 M AgNO3. (a) Identify the type of argentometric titration method used.
The Merck Index indicates that 10 mg of guanidine,CH5N3, may be administered for each kilogram of bodymass in the treatment of myasthenia gravis. The nitrogenin a 4-tablet sample that had a total mass of 7.50 g wasconverted to ammonia by a Kjeldahl digestion, followedby distillation into 100.0 mL of 0.1750 M HCl. Theanalysis was completed by titrating the excess acid with11.37 mL of 0.1080 M NaOH. How many of thesetablets represent a proper dose for a patient who weighs(a) 100 lb, (b) 150 lb, and (c) 275 lb?
(3). Write short notes on displacement titration with suitable example.
A 10.00cm3 portion of the 100.00cm3 HCl solut was taken from the volumetric flask and was titrated with KOH (aq). It was neeutralized by 24.35cm3 of potassium hydroxide od concentration 0.0500moldm-3. Calculate the concentrat of the original concentrated hydrochloric acid in moldm-3.
A sample may contain NaOH, NazCO3 and NaHCO3, alone or in some combination, along with inert material. A samplewitha mass of 857.6 mgwas dissolved and titrated with0.1163 M HCI. The volume of HCl used from 0 to methyl red endpoint (Phenolphthalein endpoint was not monitored here) was found to be 36.54 mL. Another 228.8 mg portion of the sample was titrated to the phenolphthalein endpoint and 10.82 mL was used up for this titration. a. What is the composition of the sample? b. Calculate the percentage of each of the component present.
Calculate the volume in milliliters of .357 M KOH necessary to titrate .0282 moles of acetic acid to a phenolphthalein end-point. Report the answer with precision of two decimal places. I do not know how to set this up if you could explain how that would be great.
A student withdraws 3.00 mL of supernate from a saturated solution of KHC8H4O4at room temperature (-22 degrees Celsius). This sample was titrated to the phenolphthalein endpoint and 12.85 mL of 0.0997 M NaOH was required. a. Calculate millimoles of NaOH that was titrated from the buret.
5. A 300.0 mg sample containing Na,CO3, NaHCO3 and NaOH and inert material either alone or in some combination was dissolved and titrated with 0.1000 M HCI the titration required 24.41 mL to reach the phenolphthalein endpoint. And an additional 8.67 mL to reach the methyl red endpoint. Determine the composition of the sample and calculate the percent of each titrated component.
The concentration of ammonia in a cleaning product was determined by back titration.Firstly, 10.00 cm3 of the cleaning product was pipetted into a large conical flask,containing 250.00cm3 of 0.50 mol/l HCl to give Solution A.Following a period of reaction and shaking, 50.00cm3 of Solution A was removed anddiluted to 250 cm3 with water in a volumetric flask to give Solution B.20 cm3 samples of Solution B were titrated against 0.05 mol/l Na2CO3 solution, givingan average titre of 12.45 cm3. i) Write equations for the reactions that have taken place.ii) Determine the concentration of NH3 in the original cleaning product in mol/l,g/l, ppm, and % w/v.
I made some titrations and the calculated molarity of HCI was 0.096, 0.097 and 0.098. The nomical concentrsrion of HCl is 0.1. How can I explain my results by comparing it to the nominal concentration if my confidence intervals don't include the nominal concentration?
1. Determination of amino acid nitrogen by formal and iodometric titration methods. Scope, significance of methods, chemistry of reactions.