A split-wye capacitor bank is made up of two 4500-kVAR, 13.8-kV sections, for a total installed rating of 9000 kVAR. Each section consists of five 300-kVAR, 7960-V single- phase capacitor units per phase. The capacitor units are individually fused. Determine the current flow in the neutral between the two sections if one fuse element blows in one of the sections.

A split-wye capacitor bank is made up of two 4500-kVAR, 13.8-kV sections, for a total installed rating of 9000 kVAR. Each section consists of five 300-kVAR, 7960-V single- phase capacitor units per phase. The capacitor units are individually fused. Determine the current flow in the neutral between the two sections if one fuse element blows in one of the sections.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.9MCQ: Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated...

See similar textbooks

Similar questions

Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.
Draw three transformers for each of the different three-phase connections. That is, draw three transformers and then make the connection, eg star-star, then redraw three transformers and make another three-phase connection, and so on until all four combinations of three-phase connections are made.
QUESTION 19 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in series. What is the total inductance? O 5 mH. Without knowing the coupling factor the total inductance cannot be found. 45mH. QUESTION 20 E-06, PC-05. Why are the iron cores of most induction coils laminated? To increase the core permeability. O To reduce the core reluctance. O To reduce the effects of eddy currents. Click Save and Submit to save and submit. Click Save All Answers to save all answers. MacBook Air 888 F7 FB F6 F4 F3 F2 & 23 $ 4 5 0 8 3 Y W E と S D S F G >> J しのくつつ >
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
The total reactive power consumed by the three-phase load(in VAr) is??
A 13.2 kV, 60 Hz, 3-phase synchronous generator is connected in star and its neutral point is earthed while inductance per phase is 0.02 Henry. The generator is connected to a bus bar through a circuit breaker. The distributed capacitance up to circuit breaker between phase and neutral is 0.015 micro Farad. Determine the following: (i) Peak re-striking voltage (in kV) across the contact of circuit breaker; (ii) Frequency of oscillations (in kHz); (iii) Time to occurs first peak re-striking voltage (in micro second) and (iv) The average rate of rise of re-striking voltage (in mega volts per second)
Q5/C: Compare between Auto transformers and 2 winding transformers.
The concentration ratio of parabolic trough power plant is typically O a. from 30 to 40 O b. more than 1500 O c. less than 10 O d. from 10 to 20
In large transformers, the total copper losses may vary from % of the rated output. O 0.2 to 0.6 O 0.8 to 1.5 O 0.4 to 1 O 0.5 to 1
In no load phasor diagram of practical transformer, the magnetizing current Imag is with flux Ø O Leading by 30° O Lagging by 60° In phase O 90° out of phase
(5) Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor in Non- linear Load Figure 6 Analyse different methods of harmonics mitigation to eliminate the harmonic, which you have identify in above power system circuit. You can use harmonic filters, K or equivalent transformers or oversized neutral method depending upon the harmonic sources.
Please answer this problem Determine the Resistance Value and reactance of the rotal impedance