A resistance of 50Ω is connected in series with a capacitance of 20μF. If a supply of 200V, 100Hz is connected across the arrangement, find (a) the circuit impedance, (b) the current flowing, and (c) the phase angle between voltage and current.

A resistance of 50Ω is connected in series with a capacitance of 20μF. If a supply of 200V, 100Hz is connected across the arrangement, find (a) the circuit impedance, (b) the current flowing, and (c) the phase angle between voltage and current.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: 6. A circuit having a resistance of 15 Q, an inductance of 0.15 H and a capacitance of 100 µF in…

Q: V = 75cos(5000t)V L1 110mH, L2 = 4mHe C, = 4µF %3D %3D C1 L2 ll Ix R1 V1 Vo 10 Q 100 Ix ll

A: The solution is given below

Q: 2.Calculate the value of the resistor(2) that must be connected in series with a 120 mH inductor to…

A: In this question, Find the value of resistance R and power dissipate across the resistance. Power…

Q: A coil having a resistance of 45ohms and inductance 0.4 H is connected in parallel to a 20 microF…

A: Step1 In this question, we have to find out Current I taken from mains. Following parameters are…

Q: The current flowing through a 1.6 mF capacitor is shown in the figure below. Assume the passive sign…

A: In this question, Find the voltage across the capacitor at time to= 200ms, 600ms and 1.2s.…

Q: A coil of 20 ohms resistance has an inductance of 0.2 H and is connected in parallel with a 100…

A: Circuit will act as non inductive resistance at only resonant frequency.

Q: Two coils A and B are connected in series, and their effective inductance is 12.0H which the current…

A: As here 12H inductance is found when currents in both coils are in opposite direction, and 8H is…

Q: In the following circuit, if L, = 10 H, then the energy stored in the inductor is: 29 "C 2F 3A() 452…

Q: 이 B 1 uF 1 uF ㅏ 4 uF ㅏ 4 uF Determine the equivalent capacitance, Coq, between terminals A and B in…

A: Given circuit,

Q: Q5. A resistor (R) is connected with a capacitor (C) in series to a voltage source of v(1).…

A: It is given that: Resistor R is connected in with a capacitor C in series to a voltage source of…

Q: 5:-Given a balanced Inductor and resistance, (Y), 30, has (L= 530 m H) (R= 2000), (VL= 400v), (F= 60…

Q: 22. Given a set of capacitors: 12nF, 6nF, 9nF, 4µF, 2pF and 7µF, solve the following problems: a.…

Q: A 200µF capacitor is connected in series to a 250V, 60Hz source. Assuming its resistance is 20Ω,…

Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 57.81-ohm resistor,…

Q: 2. A capacitor of 50 µF is connected in parallel with a coil that has a resistance of 20 Q and…

Q: 4. Find a. The equivalent capacitance of the network b. If point A and B are connected to a 12v…

A: a. Find the equivalent capacitance of the work;…

Q: Consider the circuit shown below. If V = 100 V, R = 1 kN, L = 65 H, what is the current in mA…

Q: 70. Ideal inductors and capacitors are 90 degrees out of phase with each other. True False 71.…

Q: mutual inductance

Q: 2µF A 6)Three capacitors are connected as shown in the figure (assume 3 significant figs.) 4µF 6µF B…

A: Here three capacitance given and we need to find equivalent capacitance between points A and B

Q: Short Problem: Given a parallel RLc circuit comprised of the following element 62.96-ohm resistor,…

Q: 1. The capacitive network shown in the figure is assembled with initially uncharged capacitors. A…

Q: Two coils A and B are connectedin series, and their effective inductance is 12.0H which the current…

Q: A 120 microfarad capacitor is connected in parallel with a coil of 78 ohm resistance and 321 mH…

A: Given data, Supply voltage V =215 V C=120 μF R=78 Ω, L=321 mH Frequency f = 60 Hz

Q: Q3] Two coils of inductance 6 IH and 8 H are connected in parallel. If their coefficient of coupling…

Q: series circuit having pure resistance of 40 , pure inductance of 50.07 mH and a capacitor is…

A: It is given that: R=40 ΩL=50.07 mH=50.07×10-3 HVrms=400 Vf=50 Hz

Q: Find the equivalent capacitance with respect to the terminals a, b for the circuit shown below 20 nF…

A: When two capacitors are in series, then the equivalent capacitance is 1cS=1C1+1C2 When two…

Q: A coil has resistance 10 Ω , inductive reactance 20 Ω . A capacitance of 50 uF is connected in…

Q: Design a charger circuit for mobile phone from: 220V, 50Hz AC source Select the proper circuit…

Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 62.52-ohm resistor,…

A: True power will be power dissipated in resistor . So we will find out current for resistor then we…

Q: Determine the current through a 8 microfarad capacitor given that the v(t) = 3t3 volt 5t+1

A: In this question we will find current through capacitor...

Q: The circuit has been under DC conditions for a long time.

A: (a) Amount of energy stored in each of capacitor is calculated as follows,

Q: Two coils of inductance 6 H and 8 H are connected in parallel. If their coefficient of coupling is…

A: Need to find Leq for both cases First find M Therefoe M = K L1L2 = .4356x8M = 3.013 H Solution…

Q: A 1.2kΩ resistor, a 2mH ideal inductor, and a 15nF capacitor are connected in parallel. Find the…

A: We will write capacitive and inductive reactance and then calculate impedance:

Q: In the circuit with capacitors shown, it is known that VAB = 4.5 kV, determines the electric charge…

Q: For the given circuit, find the current, voltage, power and energy of the inductor as a function of…

A: As per company guidelines, only the first 3 parts will be solved. If other parts are needed, please…

Q: Capacitance by AC- Bridge: In AC Bridge experiment, the balance was obtained as shown. Therefore,…

A: In this answer we will find the value of Cx for the bridge balance condition as shown below.

Q: 23. Given a set of capacitors: 7nF, 6nF, 5nF, 4µF, 3pF and 10µF, solve the following problems: a.…

Q: One of the three elements shown below is a resistor, one is a capacitor and one is an inductor.…

A: If v(t) is the voltage applied across a resistor and if i(t) is the current flowing through it, then…

Q: Calculate the value of the resistor(Ω) that must be connected in series with a 120 mH inductor to…

A: From expression of current in terms of R and L find resistance required Now power dissipation =…

Q: Solve the total capacitance, total current, voltage across 6 microfarad (out of 3 choose 1) at the…

A: Given data From the above diagram

Q: Q2. Apply combinatorial techniques as appropriate to obtain a value for the equivalent inductance…

A: Given circuit is asking us to calculate equivalent inductance between a and b. Inductance follows…

Q: 6. A circuit having a resistance of 15 Q, an inductance of 0.15 H and a capacitance of 100 µ F in…

A: Given values are - R=15ohmL=0.15HC=100μFf=50HzVS=100V

Q: 5:-Given a balanced Inductor and resistance, (Y), 30, has (L= 530 m H) (R= 2000), (VL= 400v), (F= 60…

Q: Problem 2: Given this network of capacitors: C2 C1 4 uF 1 uF C3 3 uF C4 2 uf C5 2 uF Assuming the…

A: Equivalent capacitance: This is the total capacitance of the capacitors in the circuit. Calculation…

Q: A 10 2 resistor, a 0.2 H inductor, and a 0.1 F capacitor are connected to a voltage source as below.…

A: To find the current i(t) and magnitude of the current

Q: 18. Two coils of inductances 4 H and 6 H are connected in parallel. If their mutual inductance is 3…

Q: The inductor shown is 5 µH with a tolerance of +20%. Given the current waveform shown, sketch the…

A: Write the expressions for current according to the given waveform.

Q: Question 1 C= 2nF C= 3nF C,= 6nF C,= 4nF C- SnF V= 24V C= 2nF C= 2nF Using the given circuit,…

Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 53.37-ohm resistor,…

Concept explainers

Magnetically Coupled Circuit

When two loops of a circuit with or without any physical contact affect each other with the help of magnetic fields, the circuits are said to be magnetically coupled. Magnetically coupled circuits are important parameters in electrical engineering. The most common example of a magnetically coupled circuit is a transformer. The transformer is a device used to transfer electric energy from one circuit to another. The primary winding and secondary winding are the main elements of a transformer. The primary winding creates varying magnetic flux and the secondary winding induces the electromotive force due to the effect of magnetic flux created by the primary winding.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
A resistance 170 N and a capacitance 75 µF are connected in series across a 240 V, 50 Hz a.c. supply. Calculate (a) the circuit impedance (b) the voltage across the resistance (c) the voltage across the capacitor and (d) phase angle in degrees.
The circuit in the figure is fed by a sinusoidal alternating voltage with a frequency of 50 Hz. The circuit consists of a resistor and a capacitor with the capacitance C= 300 μ Q. The power supplied to the circuit is P=100 W and the voltage across capacitor is UC=120 V. a) Calculate the current I. b) Calculate the resistance R. c) Calculate the voltage U (amount). d) Calculate the phase angle of the circuit
A resistance 190 Q and a capacitance 45 µF are connected in series across a 240 V, 50 Hz a.c. supply. Calculate (a) the circuit impedance (b) the voltage across the resistance (c) the voltage across the capacitor and (d) phase angle in degrees.
A capacitor and a resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 40 Ω, and the capacitor has a capacitance of 132.6 µF. What is the total current flow through the circuit? What is the impedance of the circuit?What is the power factor of the circuit? How many degrees out of phase are the current and voltage?
A series resistance - capacitance ( R-C ) circuit is connected to a 230V, 60 - cycle source. If the power taken by the circuit is 4, 800W and the voltage drop across the resistor is 115V.Calculate the capacitance of the capacitor. 600.36 microfarad 1,500.05 microfarad 556.096 microfarad 250.94 microfarad
A capacitor and a resistor are connected in parallel to a 120 V , 60 Hz line the resistor has a resistance of 40 ohms, and the capacitor has a capacitance of 132.6 mF. What is the total current flow through the circuit.
An R−L−C series circuit has a current which lags the applied voltage by 45°. The voltageacross the inductance has a maximum value equal to twice the maximum value of voltageacross the capacitor. Voltage across the inductance is 300 sin(1000?) and R = 20 ohms. Computethe following: Value of total Impedance (Z) Value of Inductance (L) Value of Capacitance (C)
A series circuit consisting of a variable resistor in series with a capacitance of 80uF is connected across a 120V, 50hz supply. To what value should the resistor R be adjusted so that the power absorbed by the series circuit will be 10o0W?
4. A resistance of 100 ohms, an inductance of 0.8 H and capacitance of 16 microfarad are connected in parallel to 100 volts, 60 hz a-c source. Determine the currents flowing in the circuit and draw their phasor diagram.