A parallel conductor transmission line #6 with a distance of 30.48 cm (12 in.) Made of AWG copper wire (diameter =4.11mm (0.162 inch), x= 58 MS/m). Conductors Assume that there is air between Neglecting the internal inductance; L, C. G's per meter their values; Find the dc resistance and the ac resistance at 1 MHz

A parallel conductor transmission line #6 with a distance of 30.48 cm (12 in.) Made of AWG copper wire (diameter =4.11mm (0.162 inch), x= 58 MS/m). Conductors Assume that there is air between Neglecting the internal inductance; L, C. G's per meter their values; Find the dc resistance and the ac resistance at 1 MHz

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.4P: One thousand circular mils or 1 kcmil is sometimes designated by the abbreviation MCM75C. Data for...

See similar textbooks

Similar questions

The conductors of a 10 km long, single phase, two wire line are seperated by a distance of 1.5 m. The diameter of each conductor is 1 cm. If the conductors are of copper, the inductance of the circuit is ??
3. The three conductors A, B and Cof a 3-0 line are arranged in a horizontal plane with DAg =2 m and Dac = 25 m. Find line-to-neutral capacitance per km if diameter of cach conductor is 1-24 cm. The conduc- lors are transposed at regular intervals. [0-0091 pF/km]
Q-1) Polystyrenes has a relative permittivity of 2.7. If the wavw is incident at an angle 'ei' of 30° from air onto polystyrene, the angle of transmission will be nearly..?
A Parallel wire line has its radius of the conductor is 0.2 mm and the distance between the conductors is 0.55 inches. Compute for the characteristic impedance of the line.
Discuss the methods used to minimize inductance in transmission lines and their effects on signal transmission.
Assume that a single-conductor belted cable has a conductor diameterof 0.681 in., inside diameter of sheath of 1.7025 in., and a length of8000 ft. The cable is to be operated at 12.47 kV. The dielectricconstant is 4.5, and the power factor of the dielectric at a ratedfrequency and temperature is 0.05. Calculate the following:(a) Capacitance of cable.(b) Charging current.(c) Dielectric loss of cable.(d) Equivalent resistance of insulation.
I need help with the MATLAB section, please.
Does r=e14r=0.788r, which comes in calculation of inductance, play a role in capacitance computations? Yes No
One thousand circular mils or 1 kcmil is sometimes designated by the abbreviation MCM75C. Data for commercial bare-aluminum electrical conductors lists a 60 Hz resistance of 0.0080 ohm per kilometer at for a 793-MCM AAC conductor. Determine the cross-sectional conducting area of this conductor in square meters. Find the 60 Hz resistance of this conductor in ohms per kilometer at 50C.
A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.8 F/m, and 8.5 H inductance per meter. Assume the diameter of the inner conductor as 0.8m, and the dielectric constant of the insulation as 2.9. Find the diameter of the outer conductor in cm?
Radio interference can be reduced by employing DC transmission as it reduces the ... at the .. conductor surface. O voltage stress O temperature O pressure O current
3. Coaxial cable is used in applications requiring the propagation of high-frequency signal. Such cable consists of a solid conducting cylinder as the inner conductor and a solid conducting cylindrical shell as the outer conductor. A dielectric fills the region between these conductors. Consider the RG-59/U coaxial cable that is commonly used to connect a television/internet equipment. It has an inner conductor with a diameter of 0.584 mm, dielectric filler with a dielectric constant of K = 1.20, and an outer conductor with an inner diameter of 3.7084 mm. Assuming that these conductors are very long, calculate the capacitance per metre of the RG-59/U coaxial cable. Include a derivation of an equation for the capacitance per unit length of the coaxial cable and then use this equation to calculate your answer. (As discussed in class, assign a charge +Q and voltage V to the inner conductor and a charge -Q and 0 V to the outer conductor, solve for the voltage V, and then compute the…