A dc generator consists of 100 wires connected in seri and lying in a radius of 10 cm. the effective length of each conductor is 15 cm. The radial field has a strengtl of 0.8 T. If the armature rotates at 1,200 rpm, solve the voltage generated. Draw the diagram. Thanks

Q: Determine the lower cutoff frequency of this network.

A: Small-signal modeling of the amplifier will be Cutoff frequency due to…

Q: (a) The flow of water in a river measured to be 16000 m3 / hour. A 24m waterfall found close to a…

A: Given data, Flow rate  Q=16000 m3/h=160003600=4.44 m3/sec Head is given h = 24 m Density of water…

Q: Evaluate F(2). f(t)%3sin(2t)sin(3t) round-off to 4 decimal places Answer: 0.1655

A:

Q: The transform F(s) given below describes the response of a system to a unit step input: F(-) -s+5…

A: Given data, Frequency response is given as, Fs=-s+5ss+1s+4 For finding the time domain response…

Q: Q. Using Mesh analysis find the voltage across the indicated capacitance. R2 100 0 80 mH 50 mH 200 0…

A:

Q: The switch in the following circuit is closed at t= 0. Find v(t) and i(t) at any time. Note that…

A:

Q: 10–1. A 120-V, %-hp. 60-Hz, four-pole, split-phase induction motor has the following impedances: R =…

A: Note: As per the policy we can solve only 3 sub-parts of a question, please re-upload the remaining…

Q: 8- Explain the difference of B values between three regions (forward, reverse and saturation).…

A: BJT is a bipolar junction transistor, it is a three-terminal device consisting of a base, emitter,…

Q: For the ALU circuit shown below, what should be the control word (S251SO) to perform the (sl A)…

A: According to the question, for the given circuit as shown below We need to find the condition for…

Q: Describe how attenuators are used to adjust TV signals power and also reduce interference.

A: According to the question, we need to describe how attenuators are used to adjust TV signal power…

Q: tv. 10 V 5 V 15 V 10 2 R1 1 A 0.25 A 12

A:

Q: Q/ For the below system, if you know that the input is r(t) = A sin(wt) explain and draw the…

A:

Q: The current in a load impedance of Z = 15215° Q is I = 2440° A. Calculate the voltage drop over the…

A: Given, Current in al load, I=2∠40° A Load impedance, Z=15∠15° Ω

Q: the conduck ing Eriangular below carres Loop in figuve Hat current of YOA, Find t of the Loop P…

A:

Q: Determine Vo1 and Vo2 for the network shown. Ge Si 1.2 k2 -10 Vo Voz 3.3 k2

A: The solution is given below

Q: A battery with a terminal voltage of 12V is connected to a circuit consisting of four 10 and one 5…

A:

Q: t= 0 12Ω 60 V Vc 50µF (†) 3A L Assume that the switch has been in its previous position for a very…

A: We know that when inductors and capacitors are connected in a DC circuit for a long time, they act…

Q: A piece of conductor 11.2 cm long moves across a magnetic field of 12,200 gauss at a velocity of…

A: To find the voltage that appears across the conductor when it is moved in the magnetic field of…

Q: Q2)) Find the equivalent resistance between A & B in the given network. A - 82 42 B

A: Given here a circuit and asked to find the equivalent resistance between the terminals A and B.

Q: Find the individual currents using the following methods. Show your complete solution. Mesh…

A: P

Q: How is this directly coupled- output of stage 1 directly connected to input of stage 2. Explain with…

A: Types of coupling  RC Coupling  Direct coupling  Transformer coupling  Impedence coupling

Q: J= -SoSin (Wh+75) +2o Sin (wt-85)

A:

Q: (a) Complete the timing diagram shown in Figure 3 for an SR latch. Assume Q begins at 1.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: the damping factor of a control system is 0.42, the settling time is elect one: a. 8.52sec b.…

A:

Q: The characteristics equation for a closed loop discrete time system is given by: Q(Z)-z -1.8Z…

A: In this question we need to choose a correct option

Q: Calculate the current i1(t) when t > 0, steady state at t = 0. 4A ) 1)10e u(t) A 3F HE

A:

Q: 6. Consider the given circuit. Determine Ip, IE +5 RE=2 k2 Ry = 100 k2 ww oVE=+4 V ERc=8 k2 --5 V

A:

Q: 2. The resistance of a certain conductor , 300 mil diameter and 20 ft long is 200 x10^-3 Q.…

A:

Q: 1. Determine the output voltage for the circuit 300 k2 150 k2 Vz = 2 V 741 V. 10 k2 Vị = 1 - 10 k2

A:

Q: Q2)) Find the equivalent resistance between A & B in the given network. A 42 42 B.

A: Given circuit,

Q: Find the current l in the circuit shown in Figure 1 by applying Thevenin's theorem. 100 202 100 24P

A: The solution is given below

Q: Refer to Figure below. Determine the output voltage -4 Vo VOUT 3 v 7V O -7 V O +Vsat O -Vsat O

A:

Q: Vp DD Rp2 Vo Rp1 V12 M2 M1 ViI Rs Vss 0 V SS

A: Types of differential amplifier  Dual input balanced output  Dual input unbalanced output  Single…

Q: A metallic wire is stretched from original length of 3 m to 6 m. If the original cross-sectional…

A: The solution is given below

Q: Nortons resistance is 56.8182 using simulator. Determine the current passing through the 25 ohm…

A: In this question,   We need to determine the current in the 25ohm resistance?  If Norton resistance…

Q: 2,500 kVA, three-phase, 60-Hz, 6.6 kV delta-connected alternator has a field resistance of 0.45 Ω…

A: The solution is given below

Q: In closed loop unity feedback control system, the feedforward transfer function consists of a ZOH…

A: Digital control systems :

Q: Find the fourier transorm for the following signals a) f(t) = 5 cos20t b) v(t) = e'u(-t) + u(t) f(t)…

A:

Q: the given Boolean functions below and express in Sum of Product (SOP) Form.  F1 (A,B,C,D) =…

A: According to Bartleby question answer rules I have to solve only one question both are different…

Q: Tutorial VDD • The differential amplifier of shown below includes identical JFETS with Ipss = 10 mA…

A:

Q: x (п) %3D{1,2, 1, 1, 1} h(n) = {1,–1,-2, 2}

A:

Q: Determine Id and Vo for the network shown. -5 V V. Si 2.2 k2

A:

Q: In the figure below a code to show the * :output of 7-segment is

A: The Seven segment LED used in the design is a common cathode type. If the value is 1 then the…

Q: Q1)) Determine voltage across R2 and R4 using voltage division rule. Assume that: Vi= 220V, R1=1002,…

A:

Q: Evaluate F(4). f(t)=sin(2t)cos(2t) Round-off to 4 decimal places. Answer: 0.0625

A: The solution is given below

Q: 7) For the circuit in below, find v(t) for t > 0. (10(1-e02t ) u(t)V) t= 0 6Ω 12 V 30 Ω 8) Find the…

A:

Q: In the following RLC circuit, the switch was in position 'a’ for t0 9 kN ró 80 n 5 mH | 80 V 315 kN…

A:

Q: signal transmission line which has a source impedance of 75Ω is to be connected to a signal strength…

A:

Q: Permanent magnets are magnets

A: What are permanent magnets?

Q: (b) Consider the magnetic circuit shown in Figure Q1 (c). The circuit parameters are shown in the…

A:

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.