A chemist fills a reaction vessel with 2.90 atm nitrogen monoxide (NO) gas, 6.95 atm chlorine (Cl,) gas, and 7.94 atm nitrosyl chloride (NOCI) gas at a temperature of 25.0°C. Under these conditions, calculate the reaction free energy AG for the following chemical reaction: 2NO (g)+ Cl,(g) -2NOCI (g) Use the thermodynamic information in the ALEKS Data tab. Round your answer to the nearest kilojoule.

Q: Principal ingredient of an antacid is Al(OH)3 (76.98). The concentration of 0.00400 M Al(OH)3…

A: Given, Molarity of Al(OH)3 = 0.00400 M

Q: A suzuki reaction using 4-methyl-phenyl boronic acid and 4nitrobromobenzene was ran and then…

A: In simple column chromatography, stationary phase is polar and mobile phase is non-polar. Polar…

Q: 5. Predict the ESR spectrum of pentafluorooxovanadium(IV), VOF,. For $v, I=7/2 with explanation.

A:

Q: How was the precipitate obtained after filtration? (A By scraping from the filter paper and…

A: Filtration- the process in which solid particles in a liquid are removed by the use of a filter…

Q: Give the name of the missing organic reactant in the following reaction. CH3- ? + 2 Ag(NH3)2* + З…

A:

Q: Which among the variables is NOT part of the distillation process?     Polarity     Vapor…

A: the variables that is NOT part of the distillation process is

Q: 1.Ca metal is produced by electrolysis of __________. a.CaCl2 b.CaSO4 c.CaF2 d.CaCO3 2.Which…

A: The correct answer is given below

Q: Which of the following statements is correct about polarography? I. It is the earliest voltammetric…

A: The earliest voltammetric technique is polarography, developed by Jaroslav Heyrovsky.  Polarography…

Q: Liquid mercury has a density of 13.69 g cm-3, and solid mercury has a density of 14.690 g cm-3 both…

A:

Q: The rate of the given reaction is 0.480 M/s. A + 3 B → 2C What is the relative rate of change of…

A: Given: Rate of the reaction = 0.480 M/s

Q: How many grams of H+ are needed to replace 1 g NH4+?

A: Given::  Mass of NH4+ = 1g molar mass of NH4+= 18 g mol-1 Grams of H+ = ? molar mass of H+=1 g mol-1…

Q: A solution contains a mixture of NazCO3 and NaOH. Using phenolphthalein indicator 25 mL of mixture…

A: In the titration of Na2CO3, and NaOH mixture with HCl in phenolphthalein, half of the Na2CO3 will be…

Q: The colligative property is influence by the amount of solute that are present. The amount of solute…

A: Colligative properties are the physical changes that result from adding solute to a solvent.…

Q: A certain reaction has an activation energy of 57.33 kJ/mol. At what Kelvin temperature will the…

A:

Q: Q6. Predict the major product(s) of the following reactions. Show stereochemistry applicable. H3C-…

A: Given reactions are :  Predict the major products of the following reactions . Show stereochemistry…

Q: For each chemical reaction listed in the first column of the table below, predict the sign (positive…

A:

Q: 2. Arrange the following electron deficient species in the decreasing of their stability. Your…

A: The carbocations given are,

Q: either SN1 or SN2 mechanisms.

A:

Q: The reaction between iron and thiocyanate ions involves this equation: Fe3+ (aq) + SCN" (aq) =…

A: A question based on equilibrium concept that is to be accomplished.

Q: Which will make a good substitute for bromocresol green in a double indicator titration? (A…

A: In acid-base titration the indicator indicates the equivalence point by changing its color at  end…

Q: how much does the cell potential change when Q is decreased by a factor of 10 for a reaction in…

A: Given , valence factro(v) = 2 T = 298 K Q is decreased by 10 Using Nernst's equation,  E1 = E° -…

Q: . The flotation process used in metallurgy involves __________. a.chemical reduction b.the roasting…

A: 1) The flotation process used in metallurgy involves

Q: Given the volume of 0.3482 M NaOH used determine the concentration of 15 ml sample each from…

A: Given that, 15 mL sample of each from aqueous layer and the organic layer. The concentration of the…

Q: . For the reaction, SO2 (g) + O2 (g) ↔ SO3 (g). If the concentration of SO2 (g) is increased, the…

A: Le Chatelier's principle states that when concentration, pressure or temperature of an equilibrium…

Q: Identify the type of reaction for the formation of (S)-2-butanol from (S)-2-bromobutane

A:

Q: C. Copper - Nickel N NI(NO,). (1.O M) || Cu Cucl, (1.0 M) 1. Draw the schematic of the…

A:

Q: Question 9 The phase rule describes the number of variances given the number of component present in…

A: Question 9  The phase rule states that for a heterogeneous system at equilibrium, the number of…

Q: The solubility of Ag,CrO, in water at 25 °C is measured to be 0.022 Use this information to…

A: Given-> Solubility = 0.022 g/L

Q: The reaction described by the equation 0,(g) + NO(g) 0,(g) + NO,(g) has, at 310 K, the rate law rate…

A:

Q: What is the name of this compound ? .CH2-C=C-CH3 a) 3-butyl-1,3-hexadiene-5-yne b)…

A:

Q: The compression ratio of an air-standard Otto cycle is 9.5. Prior to the isentropic compression…

A:

Q: 2a. Which of the following is a redox reaction? A. CO2(g) + Ca(OH)2(aq) → CaCO3(s) + H2O(l) B.…

A: Answer: 2/a . D , 2/b. B

Q: Balance the following in both acidic and Basic solutions. N2O4(2) + Br(aq) + Br (aq) NO2 (aq) + BrO3…

A: The given redox reaction is: N2O4g+Braq-⇌NO2aq-+BrO3aq-

Q: Na2S2O3 was standardized using primary standard KIO3. A 0.1000 g sample of KIO3 (FW=214.00 g/mol)…

A: Here we are required to find the molar concentration of sodium thiosulphate which was standardized…

Q: Which practice is NOT used to gauge accuracy? raw data and results from calibration checks B.…

A: Correct option is (e) sample rejection .

Q: Use Hess's Law to calculate the enthalpy for this reaction: 4SO3(g)→4S(s) + 602(g) AH°rxn = ??? kJ…

A: Given, a) SO2(g) ➝ S(s) + O2(g)   ∆H° = +296.8 kJ b) 2SO2(g) + O2(g) ➝ 2SO3(g)  ∆H° = -197.8 kJ…

Q: complexes do not favour B-elimination reaction. Explain citing example.

A: Ti4+ complexes do not favour β-elimination reaction because

Q: estion 24 19.04 g of an unknown compound decreased the freezing point of 421 g of benzene (Kf= 5.12…

A:

Q: In relation to the "primary structure" or "released structure" in the flexibility (force) method:…

A:

Q: The relationship between the diffusion current (ampere) and concentration ( _____ ) of the analyte…

A:

Q: The PH of 50 ml 0.1 mol/ L acetic acid is 4.8 when 50% titrated with 0.5 mol/L sodium hydroxide.…

A: When acetic acid is titrated with NaOH, following reaction occurs within the reaction mixture.…

Q: What is the stoichiometric ratio between the reaction of barium chloride and sulfate ions? (A 4…

A: Answer: D

Q: Problem Solving Directions: Solve the following problems. Write your complete solution. 1. A 60.00 g…

A:

Q: 1. (a) Determine the valence electron counts on the transition metals. Find out the formal oxidation…

A:

Q: Consider the mechanism. Step 1: 2A B + C equilibrium Step 2: B +D → E slow Overall: 2 A + D → C +E…

A: The given mechanism for the reaction is: Step 1: 2A⇌B+C equilibriumStep 2: B+D→E slowOverall:…

Q: 180.37 mL of 1.10 M organic salt was mixed with 185.23 mL of Ethanol (d= 0.789 g/mL, MW…

A:

Q: The chemicals A and B react as follows to produce C and D:                               A  +  B  ↔…

A:

Q: Do (b) (i)

A:

Q: There are 10 groups in your class. In the formulation of Concentrated Peppermint Water, you are…

A: Given: Volume of final solution = 800 mL. And volume of stock solution taken = 756.9 mL.

Q: In the space below, write the wave function W, for a one-dimensional quantum harmonic oscillator in…

A: