A balanced twelve-phase star connected load has a phase voltage of magnitude 180 volts. What is the magnitude of the voltages between alternate lines (across every other line) of this load in volts?

Q: Balanced 3-Phase Circuit) 1-What is the relationship between phase and line quantities in balanced…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 3- What was the effect of neutral wire removal in three phase circuit balanced ?

A: Let's consider a balance 3 phase circuit as shown below.

Q: The recommended limit of voltage drop on a power circuit for a single-phase supply as per IEE Wiring…

A: The explanation is as follows.

Q: What is the most important 2 reasons for using 3 phase electrical power systems

A: 1.power to weigh ratio of 3 phase is high as compared to 1 phase.

Q: The desired secondary voltage is 115 volts l, 3-phase, to monitor the voltage of 230 kV line and…

A:

Q: a wye connected load as 480v applied to it what is the volatage drop across each phase?

A:

Q: A balanced twelve-phase star-connected load has a phase voltage of magnitude 120 volts.  What is the…

A:

Q: What are the three types of equipment that may require three-phase power

A: Three-phase electricity is the most common method of alternating current power generation,…

Q: A 3-phase, 1,200 kVA, 2,400 volts alternator is short circuited and open circuited and is operated…

A: Given 3-ϕ alternator1200kVA, 2400 VS.C. current=1200×1033×2400=288.67 AOpen circuit voltage for same…

Q: A 3-phase, 1,200 kVA, 2,300 volts alternator is short circuited and open circuited and is operated…

A: The solution is given below

Q: What was the effect of neutral wire removal in balanced and unbalanced 3-phase circuit?

A:

Q: Why Generation Voltage Levels are low in the range of 11 kV/ 33 kV etc?

A: It is cheaper to produce at a lower voltage because insulation requirement at low voltage level is…

Q: DRAW AND LABEL THE TWO TYPES CONNECTION OF A THREE-PHASE ALTERNATOR PRODUCING THREE-PHASE VOLTAGES?

A: In this question we will draw three phase alternator which has two types of star type and delta…

Q: The line-to-line voltages of a three-phase, four-wire system are the following: Van = 300cis(-25);…

A: In this question we need to find a positive sequence component of Vab in volts

Q: Three equal resistors are connected in delta across 240 volts, 3-phase lines. To what value should…

A: In delta connection Vline = Vphase

Q: In a 3-phase balanced star or delta system, the least number of wattmeter essential to measure the…

A: In the three phase balanced star of delta system, the least number of wattmeter essential to measure…

Q: For three phase motor control the type of wire used for control wiring Select one: O 2.5 mm square,…

A: This question is related to Control wire size of the three phase motor.

Q: Referring to Figure 9.3, if the generator phase voltage is 400 volts and the load is balanced with…

A: A three-phase AC generator generates three-phase AC electricity by encircling the rotor with extra…

Q: Four single-phase circuits. Each circuit is rated 50A and 230 Volts. The length of the circuits is…

A:

Q: A three phase system have a sending end voltage 410 volts and receiving end voltage 365 volts. The…

A: From the lossless transmission line power equation

Q: In the circuit below, determine the currents /,?

A:

Q: When connecting a multiwire (3-wire) circuit to a single phase panel, one ungrounded conductor must…

A: This is related to 3 wire system. Fill the blank    When connecting a multi wire (3-wire) circuit to…

Q: 5. In a solidly grounded electrical system with a phase-to-phase voltage of 4160 volts and a…

A: Given that : Phase to phase voltage =4160 volts phase to ground voltage of 2400 volts voltage level…

Q: Which type of trap is used for hot and cold water pipe line in a system? a.) Stop cock b.) 2 or 3 in…

A: There is one mistake in question instead of trap, tap should come. We find to find which of the tap…

Q: Question 2: Wny does the phase difference between la (main winding current) and ly (auxilary winding…

A: Since you have posted multiple different question. we will solve the first question for you. To get…

Q: What is a three phase balanced star connected load? Its phase power measurement and total supply…

A:

Q: pose type of supply is used by suburban Railways? Option 1: 1500 volt dc Option 2: 3.3 kilo volt…

A: The explanation is as follows.

Q: The PTs are to be connected delta-wye, to monitor the voltage of a 250 kV line, PTs are to be…

A:

Q: What is the significance of a negative indication of a wattmeter reading using the two-wattmeter…

A: In this question we will write significance of a negative indication of a wattmeter reading using…

Q: State two advantages of a three phase Ac supply over a single phase Ac supply

A: Single phase supply: The power is supplied through two wires called Phase and neutral and the…

Q: What is a single and three phase power systems with resistive, inductive and capacitive loads?

A: Generally, we use two types of power supply in our application. It can be a single-phase power…

Q: A balanced four-phase star connected load has a phase voltage of magnitude 150 volts. What is the…

A: Answer shown below.

Q: Determine the following based on the wiring diagram illustrated in figure 8 on worksheet 5 if it is…

A: Number of poles P=6, Electrical output frequency f=60 Hz, EMF in each coil EC=10 Volt.

Q: A balanced twelve-phase star connected load has a phase voltage of magnitude 200 volts.  What is the…

A:

Q: Referring to the wye-delta system of Figure 9.3, if the generator phase voltage is 120 volts and the…

A: As the load and source are balance three phase system,we will do all the calculations on per phase…

Q: ネレ E. Ja, 19

A: From this phasor diagram, we can understand there is a voltage V and two current Ia1 and Ia2. and a…

Q: In a three phase star connected system, the line voltage is 330.2 volt, find the R phase voltage?

A:

Q: Assuming that correction factor K-0.7 for all loads. From B to E, the size of cable per phase (S)…

A:

Q: How to compute for the impedance phase? using 360 deg. should I include degree symbol or not?

A: When two or more alternating quantities achieve their maximum or zero values, phase difference is…

Q: A motor has a full-load current rating of 74.8 amperes and the terminations are rated for 75°C. What…

A: Ans. 3 AWG 75°C CONDUCTOR,

Q: When the feeder ring is energized by two or more than two generating stations or substations, the…

A: We need to tell about the given statement is true or false.

Q: In a three phase -four wire star connected system, the three outer wires are called as lines and the…

A: Fig: Three phase four wire system In the above shown system the common wire (N) in the…

Q: 2-What is the relationship between phase and line quantities in balanced star and delta connections…

A: Let us consider a balance 3 phase system in which a balance 3 phase load connected in star and delta…

Q: Explain with an example and diagram of each, the following types of phase connection including…

A:

Q: III. Procedures: BLOCK DIAGRAM Interconnect the electrical components per set in a block diagram…

A: Given two sets with generators and transformers of different ratings. They are to be interconnected.

Q: A balanced twelve-phase star connected load has a phase voltage of magnitude 230 volts. What is the…

A:

Q: Three 1:10 transformers are connected delta-wye for stepping up the 2,300-volt three phase source.…

A:

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.