A 50 V voltage generator at 20 MHz is connected to the plates of an air dielectric parallelplate capacitor with a plate area of 2.8 cm2 and a separation distance of 0.2 mm. Find the maximum value of displacement current density and displacement current.

A 50 V voltage generator at 20 MHz is connected to the plates of an air dielectric parallelplate capacitor with a plate area of 2.8 cm2 and a separation distance of 0.2 mm. Find the maximum value of displacement current density and displacement current.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter25: Surge, Spike, And Lightning Protection

Section: Chapter Questions

Problem 10RQ: In reference to the load, how are capacitors connected to help prevent voltage spikes and surges?...

See similar textbooks

Related questions

Q: A generating station distributes the following loads. 3000 kW ,8000 kW,14000 KW and 4000 kW. The…

Q: Given:μ = 1200 The core has square cross section and all dimension are in cm. 10 A 1² N₁ 500 turns…

Q: (a) What type is the active filter shown in the following figure? (b) Determine the roll-off rate.…

A: Given, Damping factor DF=1.414 Cut-off frequency fc=15KHz Resistors R2=10KΩ, RA=10KΩ Here, we have…

Q: Problem-3 A 220V dc machine supplies 20A at 200 V as a generator. The armature resistance is 0.2. If…

A: Given- Terminal voltage- V=220 V, Armature resistance- R=0.2 Ω. Armature current-Ia=20 A, Flux-…

Q: SS 18-21 The input in Figure P18-21 is v₁(t) = 3u(- t) V. Use Fourier transforms to find Ug(t). (0)…

Q: Q- A 30 KVA, 2500/230 transformers has leakage impedance of 8%. Find the voltage to be applied on hV…

Q: 4) A system has a zero-input response as shown in the figure below. What were the eigenvalue(s) of…

Q: Assume that dry soil has σ = 10−4 S/m, ε = 3εo, and μ = μo. Determine the frequency at which the…

A: Given data, σ=10-4 S/mε=3ε0μ=μ0

Q: Consider the unity feedback system shown with proportional controller and find the angles of…

Q: Q- Electrical machines A single-phase 100 kVA, 1000 V/100 V, 50 Hz transformer has a voltage drop of…

A: Given- Single-phase 100 kVA, 1000 V/100 V, 50 Hz transformer. Voltage drop across series impedance…

Q: Q2. a. Calculate the total resistance due to the arrangement of resistors in diagram (a) below. (a)…

A: Circuit is given as:

Q: An inductive coil draws 10 A current and consumes 1 kW power from a 200 V, 50 Hz ac supply.…

Q: SS 18-23 The input in Eigure P18-23 is i, (t) = 10e-5 mA. Use Fourier transforms to find i, (t).…

Q: Q2/(1101101) Ex-3+(3F.6)16-(157.2)8=( O None of them O 0110 0111.0011 0001 0111 O 0100 1101.0010…

A: Given:- 1101101EX-3+3F.616-157.28 We have to convert the given function into BCD 3321

Q: Consider that the phase shift of an RC coupled CE amplifier is 260°. Find the low frequency gain…

A: As per the question, it is given that Phase shift = 260° Voltage gain = -150 We have to find out the…

Q: (1) Determin the output resistance 12 in Put resistance

A: The required parameters can be calculated by using the DC and AC analysis of the given amplifier…

Q: 5. Identify the following Conductors a) THWN b) XHHW c) RHW-2 d) XHH e) THHW

Q: 2. A reservoir of carbon tetrachloride (CCI) has a mass of 700 kg and a volume of 0.415 m³. Find the…

Q: Wouldnt it be fusion due to the ITER project?

A: As we know in today's era solar energy is used at a very low level. Surely, some countries are way…

Q: 4. Consider the 1-D rect function: rect(x) = What is its Fourier transform? 1 0 for |x|≤ 1/ 2 for x>…

Q: 5. Consider the closed loop system given below. r(t) e(t) G(S) G(S) = K(S+1) S(S+2)(S+ 3) a)…

A: Given G(s) = k(s+1)s(s+2)(s+3) Unity feedback system H(s) = 1 Asked to find the following CLTF…

Q: Using MATLAB. Generate a square wave signal whose peak amplitude is 1 V, frequency of 1000 Hz, and…

A: Given an electrical signal with following information, Type: Square wave Amplitude = 1 Signal…

Q: The loop as shown exists in a magnetic field B = 4cos(20t)az Wb/m2, where az is directed out of the…

A: Given data: The magnetic field B=4cos20taz Wbm2 The area enclosed by the circuit A=2 cm2=2×10-4 m2…

Q: For the following system, if the input X[k]- 8(k+ 1) + 2.4* and output Y[k]- 20)u[k]. the impulse…

Q: What is the market for electricity?

A: ANSWER MARKET FOR ELECTRICITY Electricity market is…

Q: Find up and U2 32 V + 4Ω +91- + 2 Ω −8 V

A: The given circuit is,

Q: Determine whether or not each of the following signals is periodic. If a signal is periodic,…

Q: PROBLEM 6 Find the time domain signal of the spectrum given in Fig -2 IX(e)| E (b) beitraume if h(t)…

Q: Q1/Find( (90)10/(36)8)* (F1)16+(1100111)2=( )Gray O 1000101100 O110100111 O None of them O…

Q: 2:27 aug E PORELISSADY A student constructed the simple DC motor using insulated wire, a battery and…

A: Given data: Simple DC motor component, Insulated wire A battery A small strong disc magnet Safety…

Q: 2. For the given first order system compute a) The time constant T and the system gain k b) The…

Q: 1 A 480 V, 2-poles, 60 Hz, Y-connected induction motor has an inductive reactance of 4 22 and the…

A: The induced field increases with the size or number of turns of the coil. This condition is referred…

Q: What is the mesh equation for the supermesh below?

A: Given here a circuit and asked to write a supermesh equation.

Q: 3. A block diagram representation of a control system is given below R(S) a) Compute the closed loop…

Q: To Design the following functions must using F1= (0,1,3,5,7) F2={ * (1,2,4,6,12,14) F3=[(1.43) 2…

A: Given data: F1=∑0,1,3,5,7F2=∑1,2,4,6,12,14F3=∑1,4,3 Among F1, F2 and F3, the highest value of…

Q: Q5: A unity feedback system shown in Figure 5, operating with a damping ratio of 0.5, design a…

Q: Q4/ The decimal 793.251)= ( number O 1431.204 O 1431.200 O No one of them 1341.200 number ( O…

Q: Q5/Find the addition result for the following operation (66)8+ (1100)EX-3+(83)10- (F2.1)16 using 2's…

A: Given- F= F= 668+1100EX-3+8310-F2.116 To find- Using two's complement find given operation addition=…

Q: G (s) = K S H(S): Find 45-1 S² +25+1 Range of K for stability

A: Calculation of Range of K for the stability of the given control system : Where:Gs=ks…

Q: The reference node is shown in the figure. How many non-reference node are there? Blank 1 19 4Ω 20 Ω…

A: To find the number of non-reference nodes in the network given

Q: V+ 15V Vi 2V 2.000V 2 2.000V R1 100k 052 U1 V+ uA741 OST V- +-15.00 15V RF 500k 6 4 12.04V

Q: More five examples regarding this KCL method(with circuit figures and complete solution)

Q: Q2) a) Find the energy of the signals x(t) and y(t) below: TIP: use the trigonometric identity:…

Q: For each of the density functions of a continuous random variable X shown below, find (a) the mode.…

A: Here 3 density function with continuous random variable X is given. (1)The mode of x for continuous…

Q: Q5/Find the addition result for the following operation (66)8+ (1100)EX-3+(83)10- (F2.1)16 using 2's…

Q: Which of the following is/are a circuit with a supernode

A: To find the circuit with supernode

Q: Solve the given problem: 1. Convolve the two signals below. 1..... -1 0 1 2 3 ill 11

A: Here two signals are given: xn=∑k=-∞∞xk*δn-khn=∑k=-∞∞hk*δn-kand the convolution can be done…

Q: Ive the given problem: 1. Find the impulse response h [n] of the causal LTI discrete-time systems…

Q: At Node Vx, applying KCL gives:

Q: What is the value of RL for the maximum power transfer ? 4.7 Ω Μ 2 Ω www Α. 0.5 Ω Β. 2.82 Ω 6.7.7 Ω…

A: Given, The circuit is,

Question

A 50 V voltage generator at 20 MHz is connected to the plates of an air dielectric parallelplate capacitor with a plate area of 2.8 cm² and a separation distance of 0.2 mm. Find the maximum value of displacement current density and displacement current.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a rectangular ferromagnetic core 40 x 60 mm has a flux φ = 1.44 mwb. an air gap in the core is of length la = 2.5 mm. find the ni drop across the air gap.
Two identical air cored solenoids have 200 turns, length of 25 cm and cross-sectional area of 3 sq. cm. Each. The mutual inductance between them is 0.5 uH. Find the self-inductance of each coil and the coefficient of coupling.
L The thermoelectric effect is the direct conversion of tomperature differences to electric voitage and vice versa oloctric voltage to temperature differenc ii. The Seebeck offect is the build up of an electric potential across a temperature grodient. L. Tho Poltior offoct is tha prosonco of temmperaturo difforoncos at an oloctrifiod junction of two difforont conductors. Which of the definitions given abovo are correct about thermal properties of matorials?
6- Why an insulator is represented as a capacitor C? What are the assumption modes?
Q14. An air filled parallel plate capacitor is arranged such that the upper plate carries surface charge density 2C/m2 and lower plate carries surface charge density -2C/m as shown in figure. The electric field intensity under the bottom plate will be -2a/ɛ0 -a,/ɛ0 None of these ロロ

For 3-phase unsymmetrical spacing shown in figure (the diameter is 1 cm).: Find the capacitance per phase per km. 9m 12m
Find the capacitance if correct will upvote otherwise i will dislike...
What is specifice capacitance?
GENERAL RLC CIRCUITS: Solve and show your solution completely. Make sure your answers are in 4 decimals places. The ohmic resistance of a large magnetic contactor is measured to be 20 ohms. A 230 V 60 Hzis impressed upon the contactor and the current is taken as 3.2 amperes. Neglecting core loss,determine the inductance of the contactor in mH.
An inductor is constructed by winding a coil of 100 turns around a magnetic core. The core is a cylinder with radius 0.5 cm and the core material has relative permeability of 1000. The coil covers a length of 10 cm. Determine the resulting inductance. Enter your answer in mH rounded to two decimal places.
Find the inductance per unit length of a very long solenoid with a unit length of N windings. The permeability of the core is μ.
A coil that con sists of 450 windings is wound aroundabakelite ring. The mean diameter of the ring is 100 mm and the diameter of the bakelite core is 20 mm. The currentthrough the coil is 3 A. Determine: 1.1 a) the field stren gth b) the flux den sity c) the total flux A ringhas two halves. The onehalf is made from Cast iron, while the other is made from Cast steel. The two halves are held 1 mm apart with the aid of a paper disc. The cross-section al area and mean circumference of the ringis 345 mm? and0.6 m respectively. Therelative permeability of cast iron is 2400, while that of cast steel is 600. The ring has a coil with 200 win dings. The currentflow through the coil causes a flux den sity of 0.48T. 1.2 Calculate the: a) mmi b) currentflow Ignore the effects of fringing andleakage.