A 0.450 M solution of KCI needs to be prepared through dilution. A 2.00 M stock solution will be added to a 0.250 L volumetric flask and then water will be added to the 0.250 L mark. Determine the volume (in mL) of the 2.00 M stock solution of KCI needed to produce this solution.

A 0.450 M solution of KCI needs to be prepared through dilution. A 2.00 M stock solution will be added to a 0.250 L volumetric flask and then water will be added to the 0.250 L mark. Determine the volume (in mL) of the 2.00 M stock solution of KCI needed to produce this solution.

Chemical Principles in the Laboratory

11th Edition

ISBN:9781305264434

Author:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Publisher:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Chapter28: Determination Of The Hardness Of Water

Section: Chapter Questions

Problem 1ASA

See similar textbooks

Similar questions

68. Aluminum ion may be precipitated from aqueous solution by addition of hydroxide ion, forming Al(OH)3. A large excess of hydroxide ion must not be added, however, because the precipitate of Al(OH)3 will redissolve as a soluble compound containing aluminum ions and hydroxide ions begins to form. How many grains of solid NaOH should be added to 10.0 mL of 0.250 M A1Cl3 to just precipitate all the aluminum?
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
A sample of solid calcium hydroxide, Ca(OH)2, is allowed to stand in water until a saturated solution is formed. A titration of 75.00 mL of this solution with 5.00102M HCl requires 36.6 mL of the acid to reach the end point. Ca(OH)2(aq)+2HCl(aq)CaCl2(aq)+2H2O(l) What is the molarity?
Lead poisoning has been a hazard for centuries. Some scholars believe that the decline of the Roman Empire can be traced, in part, to high levels of lead in water from containers and pipes, and from wine that was stored in leadglazed containers. If we presume that the typical Roman water supply was saturated with lead carbonate, PbCO3 (Ksp = 7.4 1014), how much lead will a Roman ingest in a year if he or she drinks 1 L/day from the container?
A student tries to determine experimentally the molar mass of aspirin (HAsp). She takes 1.00 g of aspirin, dissolves it in water, and neutralizes it with 17.6 mL of 0.315 M KOH. The equation for the reaction is HAsp(aq)+OH(aq)Asp(aq)+H2OWhat is the molar mass of aspirin?
Twenty-five milliliters of a solution (d=1.107g/mL)containing 15.25% by mass of sulfuric acid is added to 50.0 mL of 2.45 M barium chloride. (a) What is the expected precipitate? (b) How many grams of precipitate are obtained? (c) What is the chloride concentration after precipitation is complete?
On the basis of the general solubility rules given in Table 7.1, predict which of the following substances are not likely to be soluble in water. Indicate which specific rule(s) led to your conclusion. :math>PbSe. BaCO3 :math>Mg(OH)2f. AlPO4 :math>Na2SO4g. PbCl2 :math>(NH4)2Sh. CaSO4
A 300.0-g sample of a solid is made up of a uniform mixture of NaNO3, MgCl2, and BaCl2. A 100.0-g sample of the mixture is dissolved in water and treated with an excess of KOH. The precipitate from the reaction has a mass of 13.47 g. The remaining 200.0-g sample is also dissolved in water and treated with an aqueous solution of AgNO3. The resulting precipitate has a mass of 195.8 g. What are the masses of NaNO3, MgCl2, and BaCl2 in the 300.0-g sample?
42. a. Fill in the following table as if it is a well plate and you are mixing two aqueous compounds at a time to see if a precipitate forms. If a precipitate is expected to form, indicate that by writing the correct formula for the precipitate in the corresponding box in the table. If no precipitate is expected to form, write “NO” in the box. CaCI2 Pb(NO3)2 (NH4)3PO4 Na2CO3 AgNO3 K2SO4 b. How do you prepare 300.0 mL of a 0.250 M CaCl2 solution using an available 2(X) M solution? Support your answer with calculations, but also make sure you describe how to prepare the solution.
On the basis of the general solubility rules given in Table 7.1, predict which of the following substances are likely to be appreciably soluble in water. Indicate which specific rule(s) led to your conclusion. :math>Ba(NO3)2e. KCl :math>K2SO4f. Hg2Cl2 :math>PbSO4g. (NH4)2CO3 :math>Cu(OH)2h. Cr2S3
Magnesium metal (a component of alloys used in aircraft and a reducing agent used in the production of uranium, titanium, and other active metals) is isolated from sea water by the following sequence of reactions: Mg2+(aq)+Ca(OH)2(aq)Mg(OH)2(s)+Ca2+(aq)Mg(OH)2(s)+2HCl(aq)MgCl2(s)+2H2O(l)MgCl2(l)electrolysisMg(s)+Cl2+Cl2(g) Sea water has a density of 1.026 g/cm3 and contains 1272 parts per million of magnesium a5 Mg2+(aq) by mass. What mass, in kilograms, of Ca(OH)2; is required to precipitate 99.9% of the magnesium in 1.00103 L of sea water?
ssume a highly magnified view of a solution of HCI that allows you to “see” the HCl. Draw this magnified view. If you dropped in a piece of magnesium, the magnesium would disappear, and hydrogen gas would he released. Represent this change using symbols for the elements, and write the balanced equation.