Answered: 6. Calculate the wetted perimeter of a…

6. Calculate the wetted perimeter of a triangular channel section having a depth of 5m and the side slope is equal to tan 30°. a) 9.54m b) 10.54m c) 11.54m d) 12.54m

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter15: Slope Stability

Section: Chapter Questions

Problem 15.3P

See similar textbooks

Related questions

Q: 3. 2. .. s) What is the size of the outlet rock protection needed for at 96" pipe with the velocity…

A: Where the energy at the outlets of culverts or chutes is sufficient to erode the receiving channel…

Q: In an open channel, Wetted perimeter (P) means: The perimeter that with contact with water only True…

Q: Classify the channel bed slopes. Write the methods of calculating length of GVF profile and explain…

A: Flow profiles are classified by the slope of the channel S0, critical slope Sc, normal depth of the…

Q: 1. A partially open sluice gate in a 5-m-wide rectangular channel carries water at 10 m/s. The…

A: Given y1 = 2.5 m Q= 10m3/s b= 5 m

Q: For a wide open rectangular channel with a critical velocity of 6 m/s, compute the critical depth.…

Q: Water flows in a trapezoidal channel at a depth of 40cm and with a velocity of 10m/s. An obstruction…

A: Given : Water flows in a trapezoidal channel at a depth of 40cm and with a velocity of 10m/s. An…

Q: calculate the top width if the total wetted area of the channel is 24m?.

A: To find : Total wetted area.

Q: Determine the depth in m of the trapezoidal channel with sides inclined 45 deg with the horizontal…

Q: Determine the hydraulic depth D (average depth) of a triangular channel with right angle corner…

A: Y=3m

Q: Determine the critical depth in meters for rectangular channel. Base width = 9m Discharge = 180…

Q: section

A: Discharge Q = 2.0 m³/s Roughness Coefficient n = 0.030 Longitudinal Slope S = 0.05 To determine -…

Q: A rectangular channel width 3 m, Q 25 m /sec and depth of flow is 0.5 m. At a certain section width…

A: solution Given at section 1 width of the rectangular channel B1=3 mts Q=25 m3sec and depth…

Q: A clay-tile surfaced (n=0.014) triangular channel has sides sloping at 60 degrees. If it carries…

A: Q = 10m3/s n = 0.014

Q: A rectangular channel 4 m wide with critical depth of 2.5 m. Compute the Froude Number

Q: A trapezoidal channel section having base 8m, depth 4m and the hydraulic radius is 2.36m. the side…

Q: Water flows uniformly at a depth y1= 40 cm in the concrete channel, which is 10 m wide. Estimate the…

Q: Water flows with a velocity of 3m/s, and a depth of 3 m in a rectangular channel of 2 m. Then there…

Q: 2. For a trapezoidal channel with a bottom with of 6 m, side slope of 3 horizontal to 1 vertical,…

Q: 6m, calculate the hydraulic depth of the channel.

A: To find : Hydraulic depth.

Q: Compute the hydraulic radius and hydraulic mean depth for a smooth concrete-lined channel 6m 1.0…

A: Hydraulic Radius Hydraulic radius is defined as the ratio of the cross-sectional area of a pipe in…

Q: A trapezoidal channel with brick lining has a bottom slope of 0.001 and a base width of 4 m, and the…

Q: Determine the section factor (Z) of a triangular channel with right angle corner (900) with a depth…

Q: 1. What is the hydraulic radius for a wide rectangular channel section? а) Зу b) 2y с) у d) y/2

Q: 0.2 m The wall shown in figure has failed. The cause of failure or the error made in the design of…

A: Vertical compression causes normal dip-slip faults when the Earth's crust lengthens. In relation to…

Q: Design a straight trapezoidal erodible channel that can carry a discharge of 12.5m^3/s using…

A: Solution: Given: Mannings constant, n = 0.024 slope so = 0.0015 Q=12 m3/s

Q: 40. A sand layer having the cross section area as shown has been determined to exist for 350m length…

Q: 4. The hydraulic radius of a triangular section is 0.45m and the normal depth of the channel is 2m,…

Q: What flow can be expected in a 1.2m wide rectangular, cement-lined channel (n=0.015) laid on a slope…

A: Given data width of channel (B) = 1.2 m depth of flow (y) = 0.6 m Slope (S) = 4m in 10km n = 0.015…

Q: 3. What is the size of the outlet rock protection needed for at 96" pipe with the velocity designed…

A: The size, depth and length of outlet rock protection according to USDA NCRS standardisation has been…

Q: 1. Calculate the normal depth in a concrete trapezoidal channel with side slope of 1 to 3, a bed…

A: Using the Mannings equation to calculate the depth of flow through the trapezoidal channel section,…

Q: Consider a trapezoidal channel conveys water with bottom width of 7 m and side slope of 2:1. The bed…

A: As per rule I can give only one answer because in the second part more than two or three sub parts…

Q: Red line in confined aquifer called إختر أحد الخيارات cone of depression A O Static water level BO…

A: A multiple choice questions have been given and it has been asked to select correct option. Please…

Q: trapezoidal channel section having base 8m, depth 4m and the hydraulic radius is 2.36m. the side…

Q: A half-full circular open channel is shown below. The diameter of the channel is D=2 m. (2)…

A: Answer We are given Half full circular open channel Diameter of the channel D = 2 m We know that the…

Q: • Q = 18 m^ 3 /s • Rectangular channel, 3 m wide • Unfinished form concrete channel • occurs at a…

Q: Compute the hydraulic radius and hydraulic mean depth for a smooth

Q: 4) A triangular channel has side slopes of (zH : 1V) of 3, a Manning roughness factor 0.015, and a…

Q: Evaluate the stability of the 3 m wide x 4 m deep (into the page) x 2 m tall block with a SG of 0.5…

Q: Q-6: Show that the relation between the alternate depths in a rectangular channel is 2hh h %3D h, +…

Q: 2. A trapezoidal canal section having side slope of 2H to 3V has a total depth of 1.5m. For a most…

A: Given data: Slope=2H to 3V Total depth=1.5 m It is asked find the bottom width of the most…

Q: The slide slope of a trapezoidal open channel are 1 horizontal to 1.75 vertical. The bottom width is…

A: Solution:-

Q: a) A trapezoidal weedy excavated earth channel has a bottom slope of 1°, base width of 5 m and a…

Q: The trapezoidal channel is to carry 18 m^3/s of flowrate with a bottom slope of 0.0009. Given that…

A: The discharge is Q=18 m3/s. Manning’s coefficient is n=0.026. The bottom slope is S=0.0009. Consider…

Q: Q33. Determine the economical cross-section for an open channel of trapezoidal section with side…

Q: Determine the critical depth in meters for Trapezoidal channel. Base width = 5m Side Slope 2H:3V…

A: Critical depth is as below:

Q: Question 5 Determine the section factor (Z) of a triangular channel with right angle corner (90°)…

Q: The rectangular channel below tapers gradually from 10 ft wide to 6 ft wide, with a transition as…

A: The formula to calculate the discharge is given by, Q=bdV ...1 Here, Q is discharge, b…

Q: This wood flume has a slope of 0.0015. What will be the discharge of water in it for a depth of 1 m?…

A: step 1-

Q: A trapezoidal channel of bed width 12.0 m, side slopes 2:1, longitudinal bed slope = 10 cm/km,…

A: The normal depth is the uniform depth of the channel when the slope of the channel and the water…

Concept explainers

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.

Question

I need the answer as soon as possible

6. Calculate the wetted perimeter of a
triangular channel section having a depth of
5m and the side slope is equal to tan 30°.
a) 9.54m
b) 10.54m
c) 11.54m
d) 12.54m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q-6: Show that the relation between the alternate depths in a rectangular channel is 2h; h h = %3D h, + h, where, h. = critical depth h, and h, are alternate depth
water flows at 12m^/s in a concrete trapezoidal channel n=0.015 bottom width 4m side slopes 2H:1V longitudinal slope = 0.0009.if the depth flow at a gauging station is measured as 0.8m use the direct step method to find the location where the depth is 1.0m
Determine the other alternated depth in meters of the rectangular channel section (width = 3 meters) with a different flow rate Section 1 depth = 3m %3D Section 1 flow rate = 10 m²/s Section 2 flow rate = - 15 m/s
Q3/ A Trapezoidal open channel. The following data are available:- 1- Cross -sectional area of flow in the channel A = 75 (m). 2- Wetted perimeter of the channel P = 100 (m). 3- Longitudinal slope of bed level of the channel S, = 0.0001 4- Bed width of the channel B = 10 (m). %3D 5- Width of channel at water level W = 2B (1/3) 6- n = 0.025 {S/mu/3)} Find:- 1- Flow rate in the channel Q. 2- Side Slope of the channel Z. 3- Fluids Number Fr. 4- Type of flow in the channel.
A rectangular channel has a width of 3.6m with a roughness coefficient of 0.013 Compute the critical slope Choices: 0.83 0.083 0.00308 0.38 NOTE: In the given question that is all that is given there is no discharge given please help this is the only information that is given i this question
A trapezoidal channel has a bottom section of 4.5m and a side slope of 1.5V:2H. Calculate the area.
Design a most economical trapezoidal section of a canal having the following data: Discharge of the canal = 20 cumec Permissible mean velocity = 0.85 m/sec. Bazin's constant, K = 1.30 Side slope = 1.5:1 Find also the allowable bed slope of the canal. %3D %3D
Q3/ Find bed width (B) and depth of flow (y) of a rectangular open channel, if, Flow rate in the channel Q = 250 (m³/s). Longitudinal slope of bed level of the channel S, = 0.0001, Manning's coefficient n = B = 20y. (1/3) 0.025 (s/m/3). %3D
H.W. 4 For a triangular channel having a side slope of Z horizontal: 1 vertical, Prove that: Vs 202 y. =
2. Determine the elevation of BM 100 from the given differential leveling notes below. Station BS HI FS ELEVATION |ВМ 99 1.53 1239.54 m |ТР 1 2.34 2.01 TP 2 2.06 2.35 |ТР 3 1.68 2.98 TP 4 1.97 1.78 BM 100 3.21
Design a channel section by Kennedy's theory given the following data : Discharge Q = 28 cumecs Kutter's N = 0.0225 Critical velocity ratio m = 1 Side slope : 1 %3D BID =7.6 Find also the bed slope of the channel.
Question 21 of 23 An open channel is to be designed to carry 1 m3/s at a slope of 0.0065. The channel material has n = 0.011. What is the optimum depth for a rectangular section? Select the correct response: 0.48 0.46 0.43 0.69