Answered: 4. The molar ratio between a weak acid…

4. The molar ratio between a weak acid and its base conjugate was (3:2). Calculate the Ka of the weak acid if the pH of the buffer was 6.0.

General, Organic, and Biological Chemistry

7th Edition

ISBN:9781285853918

Author:H. Stephen Stoker

Publisher:H. Stephen Stoker

Chapter10: Acids, Bases, And Salts

Section: Chapter Questions

Problem 10.125EP: What is the pH of a buffer that is 0.150 M in a weak acid and 0.150 M in the acids conjugate base?...

See similar textbooks

Related questions

Q: Explain what happens when acid is added to a buffer and the pH does not change very much.

A: A buffer is a solution that can resists changes in pH upon adding of a little amount of strong acid…

Q: Suppose a buffer solution contains Z moles of NaOH and 0.025 moles of its salt. The pH of the…

A: Given: Moles of salt = 0.025 mol pH of solution = 9.034 Kb = 1.8 × 10-5

Q: What is an acid–base indicator? Define the equivalence (stoichiometric) point and the end point of a…

A: An acid-base indicator is either a weak acid or weak base that exhibits a colour change as the…

Q: What is the pH of a hydrocyanic acid/sodium cyanide buffer in which the concentration of the weak…

A: we have to calculate pH of the given buffer solution

Q: Calculate the pH of a buffer solution that is 0.339 M in NH3 (ammonia) and 0.143 M in NH4CI. pH =

A: Here we are required to find the pH of the buffer solution.

Q: What must be the minimum concentration of hypoiodous acid in 1.00L buffer solution of a pH=10.72…

Q: What is the approximate pH at the equivalence point?

A: Equivalence point is point in titration at which the amount of titrant added is just enough to…

Q: What is the pH of a buffer solution that contains 20.0mL of 0.10M H2CO3 and 50.0mL of 0.10M NaHCO3?

A: We would use Henderson Hasselbalch equation to calculate the pH of buffer solution.

Q: buffer

Q: The pK, value for HF is 3.14. Would a buffer prepared from HF and NaF with a pH of 1.14 be…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: What will happen to the pH of a buffer if i increase the acid/base ratio by 100? Calculate it.

Q: An acid has a Ka= 1x10^-6 at what pH would this acid and it's corresponding salt make a good buffer?

A: Acidic buffer is mixture of weak acid and its conjugate base. Whereas basic buffer is mixture of…

Q: A solution made from 100 mL of 0.1 M NaOH and 100 mL of 0.2 M HC2H3O2 will act as a buffer solution.…

Q: How many moles of sodium hydroxide would have to be added to 225 mL of a 0.404 M nitrous acid…

Q: What is the general rule in preparing a buffer with a high buffering capacity?

A: In the preparation of buffer (acidic buffer), a weak acid, such as acetic acid, and its salts, such…

Q: A buffer solution is 0.080 M in lactic acid (Ka = 1.8 × 10−4) and 0.070 M in sodium lactate. The pH…

A: This is actually a buffer mixture of weak acid (lactic acid) and it's salt(sodium lactate).…

Q: low is the assigned buffer prepared? Write your computations and encircle the amount of solute…

A: Solution: Here we have phosphate buffer solution with pKa 2.12. So from this value we can find the…

Q: Describe a buffer with a low capacity and the same buffer with a greater capacity .

Q: calculate the pH of the buffer 0.15 M NH3/0.35 M NH4Cl without using the Kb value

A: Base ionization constant (Kb) of NH3 = 1.8×10-5 Conjugate acid of NH3 base is NH4+ the ionization…

Q: What are the criteria for buffer system?

A: Buffer system - - > Buffer system is defined as a solution which resist the change in pH when…

Q: If a buffer solution is 0.200 M in a weak base (Kb=7.4×10−5) and 0.450 M in its conjugate acid, what…

A: Calculate the pOH value of the given buffer solution, pKb = - log Kb = -log (7.4 × 10-5)…

Q: What is buffer solution?give the application of buffer with proper solution.

A: To find: The definition for buffer solution Application of buffer

Q: Match each weak acid with the pH value at which it would buffer.

A: Weak acids are the acids that do not dissociate completely in aqueous solution. There exists an…

Q: Is it possible to prepare a buffer solution using a strong acid and a salt of its conjugate base?…

A: Buffers are solutions that help to nullify the changes brought in a solution in terms of pH. They…

Q: weak base/strong acid titration, the pH at equivalence point is , or equal to 7?

A: Firstly we will take a weak base and a strong acid and after titration only Acid remains which will…

Q: The maximum buffering capacity is nearest to the pKa of the buffer. Explain why?

A: A buffer solution is capable of resisting a pH change on addition of small amounts of acid or base…

Q: Explain how does a solution butanoic acid and potassium butanoate can function as a buffer solution?…

Q: Importance of buffers based on your understanding. 2. Give the components of a buffer system and…

Q: For biological buffer systems, buffer acids capacity is usually greater than buffer bases capacity.…

A: A biological buffer is an organic substance in our body that helps in maintaining the body at the…

Q: What must be the minimum concentration of hydrocyanic acid in 1.00L buffer solution of a pH 9.8…

A: Answer: Buffer solution is a type of solution in which on adding small quantity of acid or base, it…

Q: When is Buffer most effective?

A: Buffer- Aqueous solution containing a week acid and its conjugate base or a week base and its…

Q: hat is buffer capacity, and when it is largest

A: The pH of the solution determines the concentration of H+ in the solution. A higher value of pH…

Q: What is the pH of a buffer prepared by combining 0.441 moles of trimethylamine (a weak base) with…

A: Here we are required to find the pH of buffer solution of weak base and it's salt of conjugate acid

Q: What is the pH of the solution at the equivalence point?

A: In case of titration of strong acid vs strong base At the equivalence point the acid will be…

Q: Estimate the Ka of the weak acid being titrated in this curve.

Q: Calculate the pH of a buffer that is 0.210 M in NaHCO3 and 0.320 M in Na2CO3. Calculate the pH of a…

Q: When the pH is below the pKa, is the buffer species more or less than 50% protonated? Explained in…

A: Given -> pH is below the pKa value.

Q: Which of the following three solutions has the largest buffer capacity? Ka values are all the same,…

A: Buffer capacity is the amount of H+ or OH- needed to change the pH of the solution by a factor of 1…

Q: What is the effect of concentration of the weak acid on pH of the buffer solution? Explain.

Q: Give the chemical composition of a buffer solution and explain the buffer action with appropriate…

A: Buffer Solutions are the solutions which resists the sharp change in pH on addition of an acid or…

Q: What must be the minimum concentration of cyanoacetic acid in 1.00L buffer solution of a pH 2.43…

A: Solution Given that Pka = 2.45 PH = 2.43 0.086 moles HCl is added Find…

Q: What must be the minimum concentration of hypobromous acid in 1.00L buffer solution of a pH 8.02…

Q: How does dilution with water affect the pH of a buffer solution?

A: The pH of a buffer solution is given by: where [A-] is the concentration of the salt and [HA] is…

Q: The capacity of buffer solution is defined as the amount of weak acid or weak base can be added…

A: A buffer is a solution which resist any change in pH on adding a small amount of acid or base . it…

Q: What is the effect of the ratio of conjugate base to acid on buffering capacity?

A: In essence buffer solutions resist changes in pH. A buffer contains appreciable amounts of a weak…

Q: Equal volumes of solutions of acids and their sodium salts are mixed to prepare a buffer. The…

A: A buffer solution (more precisely, pH buffer or hydrogen ion buffer) is an aqueous solution…

Q: Give the components of a buffer system and explain the requirements for a solution to be considered…

A: The question is based on the concept of buffer solution. We have to explain the concept of buffer…

Q: what is the pH?

A: Given :- Concentration of weak acid = 0.250 M Concentration of conjugate base = 0.450M Ka = 5.9 ×…

Concept explainers

Acid Base Titration

An acid-base titration is the method of quantitative analysis for determining the concentration of an acid and base by exactly neutralizing it with a standard solution of base or acid having known concentration.

Question

4. The molar ratio between a weak acid and its base conjugate was (3:2). Calculate
the Ka of the weak acid if the pH of the buffer was 6.0.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What is the pH of a buffer that is 0.150 M in a weak acid and 0.150 M in the acids conjugate base? The acids ionization constant is 6.8 106.
What is meant by the capacity of a buffer? Describe a buffer with low capacity and the same buffer with greater capacity.
A buffer solution is prepared by adding 5.50 g of ammonium chloride and 0.0188 mol of ammonia to enough water to make 155 mL of solution. (a) What is the pH of the buffer? (b) If enough water is added to double the volume, what is the pH of the solution?
Which of the following acids and its conjugate base would you use to make a buffer with a pH of 3.00? Explain your reasons: formic acid, lactic acid, nitrous acid.
Sketch the titration curve for a weak acid titrated by a strong base. When performing calculations concerning weak acidstrong base titrations, the general two-slep procedure is to solve a stoichiometry problem first, then to solve an equilibrium problem to determine the pH. What reaction takes place in the stoichiometry part of the problem? What is assumed about this reaction? At the various points in your titration curve, list the major species present after the strong base (NaOH, for example) reacts to completion with the weak acid, HA. What equilibrium problem would you solve at the various points in your titration curve to calculate the pH? Why is pH 7.0 at the equivalence point of a weak acid-strong base titration? Does the pH at the halfway point to equivalence have to be less than 7.0? What does the pH at the halfway point equal? Compare and contrast the titration curves for a strong acidstrong base titration and a weak acidstrong base titration.
Consider the titration of HF (K a=6.7104) with NaOH. What is the pH when a third of the acid has been neutralized?
Sulfanilic acid (NH2C6H4SO3H) is used in manufacturing dyes. It ionizes in water according to the equilibrium equation NH2C6H4SO3H(aq)+H2O(l)NH2C6H4SO3(aq)+H3O+(aq)Ka=5.9104 A buffer is prepared by dissolving 0.20 mol of sulfanilicacid and 0.13 mol of sodium sulfanilate (NaNH2C6H4SO3) in water and diluting to 1.00 L. Compute the pH of the solution. Suppose 0.040 mol of HCl is added to the buffer.Calculate the pH of the solution that results.
You have a solution of the weak acid HA and add some of the salt NaA to it. What are the major species in the solution? What do you need to know to calculate the pH of the solution, and how would you use this information? How does the pH of the solution of just the HA compare with that of the final mixture? Explain.