Power System,, 4. The incremental costs (in Rupees/M Wh) of operating two generating units arefunctions of their respective powers P₁ and P2 in MW, and are given bydC₁dC₂-= 0.2P₁ + 50;= 0.24P2 + 40;dP₂dP₁Where20 MW ≤ P₁ ≤ 150 MW20 MW ≤ P₂ ≤ 150 MWFor a certain load demand, P₁ and P2 have been chosen such that dC₁ /dP₁ = 76Rs/MWh and dC2/dP2 = 68.8 Rs/MWh. If the generations are rescheduled tominimize the total cost, then P2 is.

Incremental costs- dC1dP1=0.2P1+50,dC2dP2=0.24P2+40, where, 20 MW≤P1≤150 MW20 MW≤P2≤150 MW dC1dP1=76…

4. The incremental costs (in Rupees/M Wh) of operating two generating units are functions of their respective powers P₁ and P2 in MW, and are given by dC₁ dC₂ -= 0.2P₁1+ 50;= 0.24P2 + 40; dP2 dP₁ Where 20 MW ≤ P₁ ≤ 150 MW 20 MW ≤ P₂ ≤ 150 MW For a certain load demand, P₁ and P2 have been chosen such that dC₁ /dP₁ = 76 Rs/MWh and dC2/dP2 = 68.8 Rs/MWh. If the generations are rescheduled to minimize the total cost, then P2 is

4. The incremental costs (in Rupees/M Wh) of operating two generating units are functions of their respective powers P₁ and P2 in MW, and are given by dC₁ dC₂ -= 0.2P₁1+ 50;= 0.24P2 + 40; dP2 dP₁ Where 20 MW ≤ P₁ ≤ 150 MW 20 MW ≤ P₂ ≤ 150 MW For a certain load demand, P₁ and P2 have been chosen such that dC₁ /dP₁ = 76 Rs/MWh and dC2/dP2 = 68.8 Rs/MWh. If the generations are rescheduled to minimize the total cost, then P2 is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
A generating station has a connected load of (45MW) and a maximum demand is (15MW). with average demand of (6300KW), the value of demand * factor and load factor are 0.55, 1.5 0.33 ,0.42 O 3,0.14 O
Driving-point admittance The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is of O 6000 VA O 8000 VA O2000 VA 4000 VA Jump to ncements MacBook Air DD DII F10 F9 F8 000 F7 F6
two generators supplying a load. Generator I has a no-load frequency of 62.5 Hz and a slope Sp1 of I MW/Hz. Generator 2 has a no-load frequency of 62.0 Hz and a slope sp2 of I MW/Hz. The two generators are supplying a real load totaling 2.5 MW at 0.8 PF lagging. (a) At what frequency is this system operating, and how much power is supplied by each of the two generators? (b) Suppose an additional I-MW load were attached to this power system. What would the new system frequency be, and how much power would Gl and G2 supply now? Generator 1 VT V2 Generator 2 VTí KVAR KVAR
The peak load on a 50 MW power station is 39 MW. It supplies power through for transformers whose connected loads are 17, 12,9 and 10 MW. The maximum demands on these transformers are 15, 10, 8 and 9 MW respectively. The annual load factor is 50% and the plant is operating for 65% of the period in a year. 102. The average load on the station is (A) 50000 kW (C) 39000 kW (B) 19500 kW (D) 48000 kW. 103. The energy supplied per year is (A) 438 x 106 kWh (C) 170.82 x 106 kWh (B) 341.64 x 106 kWh (D) 420.48 x 106 kWh.
Q.3 (a) The short circuit MVA at the terminal of generating Station A and B are 1100 MVA and 1200 MVA respectively. The generated voltage at each station is 33 kV. If these stations are interconnected through a line having a reactance of 1.5 2 and negligible resistance, calculate the possible short-circuit MVA at both station. Choose 100 MVA as base. (b) A power system is represented by one line diagram in Figure Q.3(b). Each bus is rated at line voltage of 66 kV. The reactance of each component is given in per unit, based 100 MVA and rated voltage of the component. Assume that the prefault voltage of each generator is to be 1.0 per unit. Bus impedance matrix with all elements in per unit for the system is given below: j0.138 j0.112 j0.130 j0.138 j0.121 Zj0.112 jo.130 j0.121 j0.160 A solid three phase fault occurs at bus 1. Determine: (i) Fault current (in Ampere) and fault level (in MVA) at Bus 1. (ii) Transmission lines current (in Ampere) during fault. If line L23 is connected in…
A generator operating at 50 Hz delivers 1 p.u. power to an infinite bus through a transmission circuit in which resistance is ignored. A fault takes place reducing the maximum power transferable to 0.5 p.u. Where as before the fault, this power was 2.5 p.u. and after the clearance of the fault, it is 2 p.u. The value of 8 is max
Borduria Generation owns three generating units that have the following cost functions: Unit A: 15 + 1.4 PA + 0.04 P2 A $/h Unit B: 25 + 1.6 PB + 0.05 P2 B $/h Unit C: 20 + 1.8 PC + 0.02 P2 C $/h How should these units be dispatched if Borduria Generation must supply a load of 350 MW at minimum cost?
A synchronous generator has been synchronized to an infinite grid of 13.8 kV and 60 Hz. The generator prime mover C/C is such that the no-load frequency is 62.5 Hz and the power slope is 1 MW/Hz. The AVR C/C (The reactive power against the terminal voltage C/C) is such that the zero reactive power voltage is 14.6 kV, while the slope is 0.4 MVAR/kV. Calculate: (a) the kVA loading of the generator and its power factor. (b) the settings of the prime mover and AVR such that the generator delivers 3 MW at 0.85 lagging power factor.
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
6. If a power system has 10,000 kVA capacity, operating at 0.7 lagging power factor and cost of synchronous capacitors to correct the p.f is $10.5/kVA.Determine the cost involved and also required leading reactive power to increase the power factor to (a) 0.85 lagging p.f
A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 250 MVA rating, R1 = 0.02 pu (on the 250 MVA base), initial output P1 = 200 MW. G2: 350 MVA rating, R2 = 0.015 pu (on the 350 MVA base), initial output P2 = 300 MW. 0.03 pu (on the 300 MVA base), initial output P3 = 150 MW. G3: 300 MVA rating, R3 = The frequency of the system is 60 Hz. Assuming D = 1 pu on a common base of 1000 MVA, what is the new generation output for G3 for a load increase of 75 MW? Select one: O a. 190.55 MW O b. None of these O c. 203.38 MW d. 166.01 MW