230 V de is shunt motor that has an armature resistance of 0.25 2. What resistance ing systems used in Transformer. must be added in series with the armature circuit to limit the starting current 90 A? With this starting resistance in the circuit, what would be the back emf when the armature current decreases to 30 A? e) Explain the inrush current of the transformar dunia

Consider the following statements regarding the design of the distributed armature winding in a three-phasealternator:1. It reduces the phase belt harmonics.2. It increases utilization of armature iron and copper.3. It increases rigidity and mechanical strength of the winding.4. It reduces copper in the overhand of the winding. Which of the statements are correct? a. 1,3 and 4b. 2,3 and 4c. 1,2 and 3d. 1,2,3 and 4

Armature winding of an alternator can also be described as

What is the difference between transformer and 3ph asynchronous motor...

1.Two identical shunt generators running in parallel, each with armature resistance of 0.02 ohms and field resistance of 50 ohms. The combined load current is 5000A. The field are so excited that the generated voltages of one machine is 610V and the other is 600V. The terminal voltage of this parallel combination will be. www Ish1 Rh1 a.350-360 V b.450-460 V c. 550-560V Rat www az G₂ Raz 5000 A Ish2

T-a. The direction of rotation of a single-phase split-phase motor can be change by........ a) reversing the connection of the start winding b) reversing the connection of the run winding c) reversing the connection of the start and run winding at the same time d) "a" or "b", not "c" T-b. Single-phase split-phase motors using an electrolytic capacitor in the start winding circuit should not be cycled more than about__________ time per hour. a) 8 b) 12 c) 24 d) none of the above T-c. When replacing the capacitor in a capacitor-start induction-run motor, one must be sure to replace the bad capacitor with__________ . a) a smaller one b) one of the same size c) a larger one d) none of the above

Untitled Section Jalis 6 In d.c. generators armature reaction is produced by field current O armature current commutating winding current none of the mentioned compensating winding current *.The use of d.c. generators eliminated the use of rectifiers and ac supplies True False O

A thicker wire is used in the DC series field winding than DC shunt field winding in DC machines. * O because it carries the load current. O to prevent mechanical vibrations. O to provide strength. O to produce large flux. The speed of a DC motor can be changed by varying - armature resistance circuit O flux per pole O voltage source O all of above

A four-pole, wave-wound generator has 220 coils of 10 turns each. The resistance of each turn is 0.02 2. Find the resistance of the armature winding.

State the Method of connection of different field coils. ( In DC Machines )