2) The form is used to cast a concrete wall having a width of 5 m. determine the equivalent resultant force the wet concrete exerts on the form AB if the pressure distribution due to the concrete can be approximated as shown. Specify the location of the resultant force, measured from point B. p=(42²) kPa 8 kPa 4 m

2) The form is used to cast a concrete wall having a width of 5 m. determine the equivalent resultant force the wet concrete exerts on the form AB if the pressure distribution due to the concrete can be approximated as shown. Specify the location of the resultant force, measured from point B. p=(42²) kPa 8 kPa 4 m

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.112P: The inside surface of each thin shell carries a uniform normal pressure of intensity p0. Compute R,...

See similar textbooks

Similar questions

Determine the resultant force acting on the elbow of the thin-walled pipe when the pipe carries a uniform internal pressure p0.
Calculate the magnitude of the resultant forceacting on the Tainter gate ABC as shown. The gateis 3 m wide. (b) Determine the line of action of theresultant force.R = _______________ kN Line of action = _______________ m from point “O”
The water pressure acting on the masonry dam varies as shown. If the dam is 20 ft wide, determine the resultant force of the water pressure acting on the dam.
Determine the resultant hydrostatic force the water exerts on a 1 ft width of the sloping upstream face of the gray dam. (Enter the magnitude in kips and direction in degrees below the horizontal.) 21 ft Dam 37 ft 41 ft magnitude kips direction ° below the horizontal Determine the location d in feet at which it acts along the back face of the dam. ft
4. Wet concrete exerts a pressure distribution along the wall of the form. Determine the resultant force of this distribution and specify the height h where the bracing strut should be placed so that it lies through the line of action of the resultant force. The wall has a width of 5 m. Cp = (4z) kPa
Find the magnitude of the horizontal component of the force and find the vertical component of the force exerted by the fluid on the surface. Next, find the magnitude of the resultant force and its direction. Show the resultant force acting on the curved surface. The surface is 4.5 ft long. Oil sg = 0.85 9.50 ft -7.50 ft
3.6 m R 1m 1.2 m 2.5 m Oa 3m The banner has a density of 670 kg/m and is 6mm-thick. The pipe has the linear weight of 9N/m. Which of the following completes the force diagram? A. Foy, Foz, Moy, Moz B. Fox. Foy, F oz, Mox, Moy, Moz C. Fox, Foy, Foz, Moy, Moz D. Foy, Foz, Mox, Moy, Moz Р 1.25 m 1.5 m WOR 1.25m Wanner Fo WpQ 3.6 m Oo 2.5 m R 1 m
The trough is filled to its top with carbon tetrachloride. Determine the magnitude of the resultant force acting on the semi-circular end plate, and the location of the center of pressure from the top.
Solve the Resultant Force at A
Q6/ A tank wall has the shape shown in Fig. Determine the horizontal and vertical Water Tank wall components of the force of the water on a4 -ft length of the curved section AB. 18 ft 6 ft
Pls. Show the complete solution
Solve the magnitude of the resultant force. Neglect the diameter of the post.