152130 222 Ⓒ520° Fj² Find voltage drop Mutual induetanee • do # + = Majt SIR V. 12 resistance Nex (the same for all)
Q: An amplifier has a slew rate of 14 V/ us. Find the full-power bandwidth for signals having an…
A: Given, An amplifier is having Slew rate,S = 14 V/μs Amplitude of signal, Vp = 26 V we need to find…
Q: For an end condenser transmission line representation, transmission parameter A is
A: Given, An end condenser transmission line. The transmission parameter A is ?
Q: Vsi + loncapailb.cec.sc.edu/uploaded/engrsc/9X166216053c86372engrscpl1/default_1548631106.page#21 R₁…
A:
Q: Identify the Boolean equation of an XOR function if A and B are the inputs, and Y is the output.…
A: Answer: given that To find the expression for an XOR function for then inputs A and B
Q: Fibre optic cables and coaxial cables are not identical.
A: Fiber optic cables: Fiber optic cables are thin strands of glass or plastic that are used to…
Q: Two particles, a and b, are moving perpendicular to a magnetic field of 10 mT with paths shown…
A: The given question deals with magnetic force experienced by a charged particle moving in a magnetic…
Q: Question No.6 The time constant for the circuit shown below is: ਲਈ ਮਿਲ ਗਿਆ ਵਿਖਮ ਕਲਾਵਾਂ 200 20H - 20…
A: Given circuit- R=20 ΩL=20 HC=20 mF To find- The time constant for a given circuit.
Q: This should be a structural code. Can you write a sturctural Verilog code for the image given?
A:
Q: 5. Consider a system with input x(.) and output y(t) = etx(et) + 2x(2). Determine whether this…
A: it is asked to justify whether the given system is time in variant or not, linear or not
Q: 1. Choose which basic filter response suit the signal output criteria in the figure 2. State your…
A: Given: Here, the given figure is, 1. We have to choose which basic filter response suit the signal…
Q: Practice 5.17 (THE CONVOLUTION PROPERTY) Determine the convolution of the following signal that is…
A: It is given that: xt=sinc2t*sinct
Q: 7. The switch in the figure below moves from position A to position B at t = 0. Determine i(t) for t…
A: In this question we need to find the current I(t) for t>0
Q: If C 45 µF, determine the equivalent capacitance for the combination shown. a) 17.0 µF, b) 30.0 µF,…
A:
Q: 5. In a mechanical translational system, what is the relationship between the displacement of (a) a…
A: 5. Answer: given that a mechanical translational system To find the relation ship between…
Q: 2.11 The following input-output pairs have been observed during the operation of a linear system: x₁…
A: Given data x1n=-1 ,2↑, 1↔τ y1n=1, 2↑, -1,0,1 x2n=1 ,-1↑, -1↔τ y2n=-1, 1↑, 0,2 x3n=0 ,1↑, 1↔τ y3n=…
Q: Exercise 3.4 Topic: Fourier series - exponential function Find the coefficients cn of the 2π…
A:
Q: A 200V shunt motor develops 23hp, when taking 20.2 kW. The field resistance is 50 ohms and the…
A:
Q: A single-phase 5hp 3540 RPM motor is operating at rated power on a 240 VAC @ 60 Hz line with a power…
A:
Q: Simplify each of the statments below using boolean laws and identites. Identify the law or identity…
A: In this question We need to simplify the given boolean expression. We know A+A' = 1 AA'= 0 1+A= 1
Q: (c) A single-phase transformer, 30 kVA, 450 V/ 220 V, 50 Hz has the following test results:…
A: Given data Open-circuit test; 450 V, 2 A, 400 W Short circuit test; 22 V, 67 A, 800 W We need to…
Q: When a mobile node moves further from a base station, what are two precautions the latter might take…
A: Answer: given that To know the precautions that latter might take to ensure that the probability of…
Q: PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATIONS NEEDED. ANSWER IN 2 DECIMAL…
A: Given that current I = (120-j150) Voltage V = (8 + j12) V Impedance z = V/I
Q: At t = 0, a charged capacitor with capacitance C = 500μF is connected in series to an inductor with…
A: Given data, Capacitor is given C=500 μF. Inductance L=200 mH. Rate of change of current didt=20 A/s.
Q: 1. A three-phase, 120 slots, six poles, whole-coiled winding each of which spans from 1 to 16.…
A:
Q: What is the power factor angle? a. -12 degrees b. 45 degrees c. -30 degrees d. -18 degrees
A: It is given that: p=4Pop=75 kWf=50 HzVl=440 V%η=95%Xs=2.5 ΩPin=78950 W
Q: 1) Discuss principle of Conductivity Modulation. 2) Discuss the influence of Conductivity Modulation…
A: 1. Conductivity modulation is a principle used in electronic devices to control the flow of…
Q: Assume the op amps used in the circuit below are maximum Vo = Lt = Vcc - 2 V₁ ideal, except they…
A: According to the question, for the given circuit as shown below We need to plot the the waveform…
Q: Consider the circuit below, where the independent current source is 4.4 mA. Find the current through…
A:
Q: Code ASCII 1058 Table Q.1: ASCII characters for the given codes 7816 011000012 155g 4E16 1578 119 10…
A:
Q: What effect do you think the ability to use living batteries will have on the future development of…
A: Batteries are practical, transportable energy sources that allow for wire- and cable-free operation.…
Q: (b) Given x(t) = e-tu(t) and X(ao) = F(x()]= of: (i) GO x(t-4) r(-2t-4)
A:
Q: 2. In the circuit below, switch has been connected to point A for a long time. At t = 0, the switch…
A:
Q: A 25 kVA, 2 kV(rms)/100 V(rms) single phase transformer is connected between a 120 V(rms) utility…
A:
Q: From the circuit shown, find the total resistance at terminal CD
A: In this question we need to find the total resistance of the given circuit at terminal CD.
Q: 2. Consider a system with input x[.] and output y[n] = ex[n+1](2+sin(n)). Determine whether the…
A: Whether the system is stable or invertible:
Q: 6. Suppose that Ha(s) is an analog_bandpass filter whose half-power frequencies are ₁ and 2. (That…
A: Introduction Analog bandpass filters Analog bandpass filters are electronic devices used to filter…
Q: Consider the circuit in the figure below. Find i(t) for t 0 80 V 40 Ω Μ t=0 Ο 3F= 30 Ω 0.5/ 50 Ω
A: The given circuit diagram is shown below,
Q: 1. Find i, for t> 0 if the circuit is in a steady state at t = 0. R₁ 8 Ohm -24 V t=0 4 Ohm ww R2 L…
A:
Q: Given: Vi= 10 V R1 = 20 R2 = 30 R3=70 R4 = 50 R5 = 60 Ra R₂ 1. Solve the following: a. Using KVL and…
A:
Q: (11 +12/2). The high resistance ground fault has occurred near the grounded neutral end of The…
A:
Q: 10. To what value must R be adjusted in Figure 3-75 to make /₂ = 40 mA? Assume V₂ = 12 V at 30 mA…
A: Answer: given that Zener current IZ = 40 mA Zener breakdown voltage VZ = 12 V at 30 ma of…
Q: Q3: Consider the following DT signal: y[n] = sin(n − 1)u[-n + 2] + u[n − 1] Find the convolution sum…
A:
Q: A 50 Hz, 3 phase alternator, has rated voltage 14 kV, connected to breaker, inductive reactance 4…
A:
Q: 1.9 Calculate the rate of attenuation increase in dB/ octave and in dB/decade as f approaches zero…
A: Given Transfer function is T(s) = [3s2(s2+36)] / [ s4+2.344s3+ 1.824s2+1.267s+0.987] We need to find…
Q: What current is drawn from the power supply? (5.53 A How much power is dissipated in the 42…
A:
Q: AIB IBC ED E X
A:
Q: (e) If the LPC1768 microcontroller is clocked at 100 MHz, determine the value in the PR register if…
A: Given, LP1768 microcontroller is clocked at 100MHz. i.e CCLK = 100MHz & PCLK = CCLK/2 Counter…
Q: 17. Statements An engineer wants to design an ATES system for a large office building in a moderate…
A: an ATES (Aquifer Thermal Energy Storage) system:
Q: Introduction Q1 As the result of an energy balance on an energy system you find the following data:…
A: Efficiency of the system is defined as It is the ratio of output parameter to the input parameter.…
Q: Use mesh analysis to find vab and i, in the circuit in Fig. 3.78. 80 V 80 V (+1) 20 Ω 20 Ω 30 Ω 30 Ω…
A: Given: In this question, the given details are, To find Vab and io in the circuit by using the mesh…
Step by step
Solved in 2 steps with 3 images
- A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
- An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
- Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.List the five capacitor replacement rules.You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
- Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450From the given circuit, what is the inductive reactance for the given inductance L (pick the value that is closes to given options). V-15 Vac R-1.5k L-50mH -3.183 kHz 100 ohms 1000 ohms 100,000 ohms 1000,000 ohmsDetermine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH cele rele Figure Q4 rele celer L3 6.6 mH L4 2.8 mH reler L5 7 mH
