1. Convert from decimal number to binary number (-20.75)10 (----) Your answer

Q: Aid Quiz 81/quizzes/2268496/take il O digital O both digital and analog Question 9 Digital Systems…

A: Digital signal uses only two bits i e 0 or 1 to transmit the signal whereas Analog signal are those…

Q: * ?a variable is a memory location True O False O

A: A variable is a memory location?

Q: Convert the binary NUMBER 10100111 000.10111 to decimal number (Show the steps in paper , scan and…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Jon 2: 1. Which TTL level closes the analog switch and which opens it?

A: Transistor - Transistor is abbreviated as TTL It has two states low and high

Q: condition in writing of a How avoid race the verification Code given specification-

A: To verify a design we write verification module and  test bench to check that it meet specification.…

Q: -No value can be moved directly into which registers? Your answer

A: No value can be moved directly into General Purpose Register, but

Q: Design an encoder to perform number conversion between two different numbering systems.

A: Encoder: An encoder is  a logic device which converts digits, characters in to a coded…

Q: Build a 2 bit up/down grey code counter.

A: 2 bit up/down grey code counter will either count the loop in the ascending or the descending order.…

Q: The subject is: Smart Grid Please send the answer by typing ONLY. I don't want any handwritten.…

A: Encoder:it is a combination al circuit which is used to convert the any form of data to binary. Like…

Q: Convert the following to Octal, Decimal and Hexadecimal 1. 121213

A:

Q: What is the total range of decimal values that can be represented in 9 bits?

A:

Q: Draw the constellation Diagrams for 16point PSK  using Gray code. Assume a minimum distance of 1…

A: signal constellation diagram for a 16-per signal The above requirements can be shown in figure :

Q: Question 20 The Timer-Timing (TT) bit is true whenever the accumulated value of the timer is…

A: Timer timing bit is true if accumulated value of timer is less than preset value.

Q: For this question, you're given the following information: . Instruction fetch is taking 1.5ns •…

A: 5-stage pipeline is five clock cycle it is used ARM pipeline in generic pipeline four stages fetch,…

Q: Compare 5 different PLC brands/models and 5 HMI brands/models? Note: Sir, if you write on the…

A: Given: Compare 5 different PLC brands/models and 5 HMI brands/models.

Q: how to convert 257 to Octal numbering system

A: Step 1 Divide the given decimal number successively by 8 until the ‘0’ quotient

Q: Match the following terms. Flag A. contains temporary information Register B. contains status…

A:

Q: 1- Is the Gray code arithmetic code? Why? Where this code used?

A:

Q: The general purpose registers are located inside the __________. EU INSTRUCTION QUEUE ALU BLU OR…

A: General-purpose registers are used to store the data temporarily within the microprocessor

Q: Question 6: Answer the following questions: a. What does the pinMode() command do? b. What is the…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: A person is recording measurements from an analog data reader. During the first reading, he was not…

A: Since we are allowed to solve only up to first three parts of a question the below answer contains…

Q: d) How many symbols are required if the system is an octal system? e) How many symbols or digits are…

A: (d) every symbol in octal system can be represented by its three bit binary equivalent. Hence 24-bit…

Q: Convert the number 123 from Octal to the Binary number system.

A: The solution is provided in the following section:

Q: Convert the decimal NUMBER 1938.4375 to binary number showing the steps (Note : The problem should…

A:

Q: Give the name of an 8088 pin used to signal an interrupt request. [Type the name as it is shown on…

A: Pins of 8088 microprocessor

Q: Convert the binary NUMBER 10111110010.11010 to decimal number (Show the steps in paper, scan and…

A: We will multiply 20, 21, 22.....to the binary digit from left side of decimal point and right side…

Q: Report: Answer the following 1- What is meant by Registers? Do they have names?

A: According to our guidelines, we can answer only one question at a time. Kindly, repost the remaining…

Q: Q1) List the procedural steps taken by the microcontroller when a call to service routine was…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 2. Explain all the addressing modes with one example for each. Note: Please do not handwritten.

A: Addressing modes are only the various manners by which the area of an operand can be indicated in a…

Q: What is the max error of sampling with 10 bits with supply voltage of 5 volts?

A: We need to calculate max error for given sampling .

Q: Based from your own words, Describe what is meant by error control?

A: In the networking or communication, whenever there is transfer in data occurring from the sender end…

Q: The data recording space on magnetic tape between the blank intervals is known as a/ an: Block…

A: Magnetic tape- The magnetic tape is coated with a material (iron Oxide or Chromium diode) that…

Q: QUESTION 19 The program which handles an interrupt is called the: O BIOS Int ox ISR IRQ QUESTION 20…

A: Dear student as per guidelines we are allowed to answer only first 3 MCQ, but for you I have…

Q: Show the status of PSW (Program status word) after addition of two 8bit numbers 26H and 3FH. Also…

A: Show the status of PSW (Program status word) after addition of two 8bit numbers 26H and 3FH. Also…

Q: QUESTION 44 The 8259 is a O Low priority interrupt O Tristate buffer Programmable Peripheral…

A: Intel 8259 is a very important device and very commonly with 8085/8086 systems.

Q: Discuss the three essential elements of a Date Acquisition System

A: The three essential elements of Data Acquisition System (DAS) are- Analog-to-Digital Converter…

Q: Choose the correct answer Determine the address mode for the following operations MOV AL,[2000 H] *…

A: determine the address mode for the following operations: MOV AL,[2000H] immediate addressing mode…

Q: Compare between the status and control flags? Explain the status flags for the operation AEH+37H ?

A: As per Bartleby guidelines we are allowed to solve only one question please ask the rest again. The…

Q: 14.3.6 - What field is sent in period 8 of an I2C message? ACK The read/write bit The STOP condition…

A:

Q: Write a program using interrupts to simultaneously create 6KHZ and 300 HZ

A: first square wave :6 kHz  second square wave : 300 Hz  Assumption: assumed 8051 micro controller…

Q: Question 4) which data shift register does each of the following illustration represent?

A: In this question there interested in the identification of shift registers    Shift registers are…

Q: Convert (198)decimal number to binary by using the sum-of-weights * method

A: A Binary Number System is shown below:

Q: Determine the single error correcting code (hamming code ) for 110110 for odd parity

A:

Q: Q1. Convert the last four digit of your student number into a binary number.

A: Decimal number system contains digits 0 to 9. It is conventional number system. Binary number system…

Q: Can you tell me how many potential digits there are in the Hexadecimal System?

A:

Q: Question No.4 Convert following numbers to binary numbers i. (784)10 ii. 78A

A: In this question,  Convert the given number to binary number  78410 78A

Q: 4. What is the function of FVC (Forward Voice Channel)? a) Voice transmission from base station to…

A: According to the question we have to discuss about FVC.

Q: What is the "overhead" cost (in % to a single decimal place) for a [21,16, Hamming code?

A: Hamming Codes In telecommunication, hamming codes are a family of linear error-correcting codes that…