Please answer asap and show all of your work Head, m; power, kW10Problem 10The pump used in the system shown has the characteristics given in the figure below. What discharge willoccur under conditions shown, and what power is required?Diameter 35.6 cmElevation= 20 mWaterHead1 m60 mSteel pipe50 cmElevation= 21 m2 moldo100on bebluort 2014 A80EfficiencyPowerN = 690 rpmn = 11.5 rpsD= 35.6 cm00.050.100.150.200.25Discharge, m³/s604077020TEfficiency, percentad sugit sit vd nevig 20020.30 bins mo 02 al exiz qmuq stfancitibn03 929d 1abu (1.0=5009bliud

all the data assume for given diagram. i hope its helpfull.thank you.

Answered: Head, m; power, kW 10 Problem 10 The…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

What is the required pump power (Pa) for the system below? The source reservoir is on the right side of the figure The outflow is released as a water jet to the atmosphere (on the left) Discharge rate is 0.11 m3/s Pipe total length is 180 m Pipe diameter is 0.2 m Friction factor (f) is 0.01 Minor losses are negligibleCHOOSE ONE: 25 KiloWatt 169 KiloWatt 269 KiloWatt 112 KiloWatt
The 250-ft-long hose is made of a material having a roughness of e=0.0005 ft. (Figure 1) Figure 80 ft Part A Determine the power the pump must supply in order to discharge 45 ft³/min Express your answer using three significant figures. -9.583 W₂= Submit A vec Provide Feedback 6 Previous Answers Request Answer * Incorrect; Try Again; 4 attempts remaining ? Review f water at T = 60°F at from the 3-in.-diameter hose. hp Next >
The table below gives the pump curve data for a pump operating at 1000 rpm and has 3-in. impeller. The available pumps had different impeller diameter D and rotation speed N as shown below, X = 62
The pump draws water at 30 liters per second from reservoir A and lifts it to reservoir B as shown. The head loss from A to 1 is three times the velocity head in the 150mm diameter pipe and the head loss from 2 to B is twenty times the velocity head in the 100mm diameter pipe. Which of the following most nearly gives the powet delivered by the pump? Choices: 59.38 kW 75.14 kW 44.82 kW 53.96 kW
Water is to be moved from one large reservoir to another at a higher elevation as indicated in figure shown The loss of available energy associated with 2.5 ft^3/s being pumped from sections 1 to 2 is 120 times of the velocity head. Determine the amount of shaft power required. Section (2) Bn inside diarmeter pipe 3D I 500 Section (1) Pump Select the correct response 1.14 hp 1.28 hp 1.07 hp 1.56 hp
Question 5: For system shown below, estimate: 1. The head, flow rate, and efficiency in case of combined pumps in parallel and series 2. At which configuration should the system be operated? 3. In case pump 2 is turned-off, estimate the shut-off head and free delivery flow rate in the system 20 Hp (m) 40 100 80 60 -Pump 2 Pump 1 Efficiency curve 100 200 Combined in series Combined in parallel 300 Eff. 90% 80% 70% 60% 50% 40% 30% 400 Q(L/min)
Non-positive displacement pump is the type of pump whose size is lesser for a given discharge räte. Select one O True O False
2. ROTARY PUMP Given: Discharge weight = 25.3 kg Current = 0.50 amp Duration = 1 minute Required: Pump Efficiency TDH Transm Eff = 90% = 26.3 ft Phase Motor Eff = three = 85%
A wastewater pump of 30 cm impeller has a characteristics curve defined by the formula: H= 13.6-0.83g Where H in meters, Q in m'/min, It is designed to operate at 705 rpm, It will operate at the best efficiency point with flooded suction (water at the top of pump volute). The system head capacity curve can be described as follows: H- 5+0.43Q parabola Where H: in meters, Q in m'/min. The head losses in the suction pipe amount to 0.8m and the cavitation constant is 0.2. Check for cavitation assuming the pump is located at sea level, the vapor pressure is 3.17 kpa
Q5: As shown in figure (5). What is the water horsepower of the pump? The pipes characteristics are as follows. Pipe 1 2 3 EL.0.0m D (mm) 200 300 250 L (m) 900 300 1500 0.135 m²/sec f 0.023 0.018 0.02 EL 120m EL.30m
In the simple hydraulic circuit shown in Figure 1 below, why is the counterbalancing pressure valve required? Sol A Sol B Ci u s 1
Choose the letter of the correct answer. Please answer honestly and do not just guess. | A pump that creating pressure difference between the intake and discharge point. a. Dynamic pump c. Displacement pump b. Pressure pump d. None of the above Maximum velocity happens at crank angle of 180°. a. True b. False JA pump must move a discharge of 1.1 cfs against a head of 30 ft. if the pump is driven J by a 5 kW motor with an efficiency of 75%, what is the brake horsepower? a. 5.025 hp c. 4.992 hp b. 4.83 hp d. None of the above 4 Which of the following is not correct? a. Pressure acts uniformly in all directions on a small volume of a c. When the fluid is static, pressure varies only with depth. fluid. In a fluid confined by solid boundaries, pressure acts perpendicular to the boundary. d. None of the above 5In the analysis of a fluid inside an accelerating container the assumption is that a. There is still no shear force acting on the fluid particle b. The hydrostatic equation can still…

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS