edule, draw the anode plete the table entries
Q: 8.a. Four electricians are discussing transformer installations. Electrician A says that there's no…
A: 8 (a) Electrician A is incorrect. This is because there is a size requirement for the door sill of…
Q: A tape has a standard length at 20°C. A line was measured at a temperature of 3°C. If the…
A: Tempewrature correction is given by:Ct=αTo-TsLTo=3°CTS=20°CL=865.47m.α= 0.0000116m/m- °C
Q: Pipe Water Ah SG = 2.6 D = 30 mm Figure Q2 (a)
A:
Q: A Totalstation encompasses: Spirit Level Theodolite EDM
A: Total station encompasses?
Q: 12 mm
A:
Q: Differentiate between (with example): () Eueran and Lagrangian approach of mation (1). Streak lines…
A: (i) The eulerian approach of motion: In the eulerian approach of motion, the properties of fluid…
Q: What do you do to show that you have inspected the land area of the valve to ensure that the gasket…
A: Note- We’ll answer the first question since the exact one wasn’t specified. Please submit a new…
Q: Depth of wall ype of support Dewatering/Piping
A: From the given question it is required to make following recommendations regarding excavation sites-…
Q: 1200 ib 600 16 D 20' 15' 15' 15' E 10' 400 lb 200 lb Figure P-4-3.8
A: We can solve the member force of a truss by 2 methods Method of joints method of sections Sign…
Q: Differential Leveling Prepare and complete the differential level notes for the information shown…
A: To Prepare and complete the differential level notes for the information shown. And to Do the…
Q: Determine the y-coordinate of the centroid of the cross section of the underground runnel lining…
A:
Q: What are Vaneaxial axial fans?
A:
Q: What are the different types of lamps in building construction. Draw and describe it also.
A: lamp is the artificial source of the light. from the last 100 year nd its become the integral part…
Q: If a layer is set to plot but is currently frozen -1 .. or turned off, the layer is Plotted Not…
A: Plot command: Controls whether visible layers are plotted. If a layer is set to plot but is…
Q: Define Vacuum Dewatering.
A: The method of vacuum dewatering effectively enhances concrete strength , durability and other…
Q: Start yourtrial nowl Firstweek only$4.991 Question 9. A 50m steel tape is of standard length at…
A:
Q: -36"-
A: Solution:- Neutral axis without compression steel, xu=0.87fy×Ast0.36fc×b…
Q: In a 5.00m x 7.00m room, compute the number of tiles necessary to cover the floor if the tiles to be…
A: Size if room=5*7m Size of tile=30*30cm
Q: The main water service is a(n) a-8"polyvinyl chloride pipe b-10"round concrete pipe…
A: Polyvinyl chloride (PVC) pipe: - It is a white plastic pipe which is use for plumbing and other…
Q: Write a shot notes on i) Wire drawing and ii) Tube drawing.
A: We have to give a short notes on wire drawing and tube drawing.
Q: 4 in 2 in 4 in 8 in -12 in- -16 in-
A:
Q: 05/ In the plan below there is a conventional L shape stair, the distance between slabs is 2.9m.…
A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…
Q: hoose the letter of the correct answer. Pipe fittings are attached to the end of pipes to allow it…
A: The part which is attached to pipe is known as pipe fitting.
Q: Please answer part a b c
A: We will consider the UDL all over the beam. and draw ILD and take area under ILD.
Q: R30 30 10 15- 030-
A:
Q: Pin G 3- 1.5 2D Roller 5EN 5N 5LN
A:
Q: Describe the equipments below, Wooden peg,Hammer,Total station,Tripod,Target and Tape measure
A: Answer Wooden Peg-Wooden peg is the Dowel of wood which consists of a thin pointed shape. Wooden…
Q: D) Figure below shows an incomplete vertical sectional view of an open-eaves roof construction.…
A:
Q: 4. Internal Plaster area of a room of Size 4m*3m and height of 3m with a door of 1mx2m and two…
A: Given data: Dimensions of the room L×B×H=4m ×3m ×3m Dimensions of the door = 1m × 2m Dimensions of…
Q: Define Vibrocompaction.
A: Vibrocompaction is a method in which the density of granular soils is increased to the appropriate…
Q: s inciudes primary, secondary and worKing control on the jobsite. Referencing Control Vertical…
A: Referencing controls the primary secondary and working control on jobsite
Q: A piece of ducting must be custom-made. It must fill a gap 257⁄16 inches long.One end of the duct…
A: Given:- a gap 257⁄16 inches long.One end of the duct must also fit into the next piece of ducting…
Q: The rectangular cistern (storage tank for rainwater) shown has its top 15 ft below ground level. The…
A: Length of cistern(L) = 14 ftWidth of cistern (B) = 21 ftWater level = 15 ft to 35 fty1 = 15 fty2 =…
Q: Quo: Find the mament at Co) to hold the gate, shown in figure belaey closed. Negleet gate weight.…
A:
Q: THE SHOWN HOSPITAL, THE USE OF EACH FLOOR AS INDICATED. THE BUILDWG FLOOR AND ROOF COMPONENTS ARE…
A:
Q: e reading of the dial gauge
A: Calculate the measurement. If your small gauge shows revolutions or does not provide a clear…
Q: Pipe the Compu
A: Given data Re=105 Given equation 1Cf=-0.4+1.74lnReCf
Q: 33. Draw three views of the shalt guide. 22 -55 57 30 20R 15- 22 45 -85- 40 Bore 70-- PROB. 33…
A: We can represent any 3D figure in 2D by 3 views Top view Front view Right / Left side view
Q: A fuel line must pass through this wall. Find in inches the length of the holethrough the wall.
A: To find:- The length of the hole through the wall.
Q: Answer only letter D, E, F
A: Given data in question Structural beams To find out Indeterminacy Note Ds= total Indeterminacy…
Q: Define tremie pipe
A: Tremie Pipe: It is a pipe that is used to pour the concrete especially for underwater construction.…
Q: 25' - 6" "wide 6 -8" Figure 2.5.1 - Question 1 Inside perimeter Outside perimeter Centreline 12-7
A: The explanation as under estimation and costing of buildings plans is as follows -
Q: 200 kN 25 kN/m A B Hinge Hinge |3 m+3 m+-6 m+ 6m 6 m-
A:
Q: An is a heavy metal door used to regulate the water discharge through a reservoir outlet. Outlet…
A: Dam Axis is the line of the upstream edge of the crown of the dam. Parapet wall In dam is the Wall…
Q: TONTO Problem No.1 Determine the maximum mass of the lamp that the cord system can support so that…
A: To find maximum mass of lamp,m?
Q: ng data: Aluminum A = 2.6 sq. in Osi L = 17.3 in 1 °F E = 10519262 psi a = 12.73 x 106°F
A: To find the force in each bars -
Q: 50- 50 100 MPa
A: 1. principle stress increased with depth, as point B has higher normal stress as compare to A thus…
Step by step
Solved in 2 steps with 2 images
- Q2: Determine the resultant about the point O of the four forces and one couple which act on the plate shown in the Figure below. Note : for the resutant of 3osihys Forc es, You should computy the magnitude Kdirechion 30N 5 m- 3 ocos4s 25N 2 m 70 N-m 20N 40N o 30A metallic cube of 30 cm side and weighing 500 N is lowered into a tank containing two fluid layers of water and mercury. Top edge of the cube is at water surface. Determine the position of block, at Water-Mercury interface when it has reached equilibrium. (30-1) Water Interface MercuryIR R. 220 2 c.1 Determine the range of values of Vi that will maintain the Zener diode in the "on" state. Refer to the figure in the right. Vz = 20 V IZM = 60 mA RL 1.2 k2 V %3D
- (2) lakai * In fig. below i2= A 5V 100 10V 10v 3A 1091. When the force of 3 mN is applied to the plate the line AB in the liquid remains straight and has a velocity of 0.6x103 m/s. If the surface area of the plate in contact with the liquid is 0.6 m2, determine the approximate viscosity of the liquid. В в B B' 3 mN 4 mm Aet Insert Design ion - 3' Transitions Animation D * Ω BIUAS X² A & Determine: Slide Show A A & E E EE ab A v Review MLSS = 2500 mg/l Mean cell residence time = 10 d View Return sludge from SST = 8000 mg/l Yield coefficient = 0.8 kg/kg Endogenous decay rate constant = 0.06 d-¹ ** ====12111 (0) - Tools Q1: A conventional ASP is to be used for treatment of 10,000 m³/d of municipal wastewater. The influent BOD to the ASP is 160 mg/l. As per requirements, the effluent from the ASP should have a soluble BOD of not more than 10 mg/l. Assuming: i. The volume of aeration tank ii. The mass and volume of sludge to be wasted per day iii. The recycle ratio iv. Food to microorganism ratio Notes- a Comment Y Shapes Picture A TextBox Arrange - 4 Question Sign in 26°C Light rain Q Find Sele 80%
- Solv this pleasefactor of safety is 3A capillary tube of diameter 2 mm is placed in a reservoir of water, and a similar capillary tube is placed in a reservoir of methanol. If both tubes are made of clean glass and the water-glass and methanol-glass contact angles are both approximately equal to 0°. Surface tension of water is 0.073 N/m. Surface tension and density of methanol are 0.0225 N/m and 791 kg/m3, respectively. 8.0 Determine the rise of methanol. a.) 7.4 mm b.) 5.8 mm c.) 14.9 mm d.) 2.9 mm e.) 9.0 Determine the rise of water. a.) 7.4 mm b.) 5.8 mm c.) 14.9 mm d.) 2.9 mm e.).
- Solve( b) part only in 2 hour plz solve this perfectly this id mecahnical emgeering question so plz don't reject it.Pls solv fast and correct۹:1 ص السبت ۲۷ آذار Lectures 6-7 Ceramics 2020-21.pdf USED SUSOURCE Senior Lecture - Department of Materials Eng. - College of Engineering - University of Qadisiyah EUSOURCE Here Qfr is the energy required for the formation of each Frenkel defect, and N is the total number of lattice sites. (Also, as in previous discussions, k and T represent Boltzmann's constant and the absolute temperature, respectively.) The factor 2 is present in the denominator of the exponential because two defects (a missing cation and an interstitial cation) are associated with each Frenkel defect. Similarly, for Schottky defects, in an AX-type compound, the equilibrium number (Ns) is a function of temperature as N, = N exp Qs ... (2) Where Qs represents the Schottky defect energy of formation. Example 1 Calculate the number of Schottky defects per cubic meter in potassium chloride at 500 °C The energy required to form each Schottky defect is 2.6 eV, while the density for KCI (at 500 °C) is 1.955 g/cm³. Atomic…