Answered: Determine the frequency where the…

Determine the frequency where the stated component has the given reactance at 20 μF Capacitor with a reactance of 350 ohms and a 20 mH Inductor with a reactance of 2.5 kohms

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 2PP: What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?

See similar textbooks

Related questions

Q: (2) Find Va(t) given Vs(t) = 2√2 cos (4t+45°) V, and Is(t) = 0 A. 2 ww Va 0.25 H Vb (1/8) F Is(t)…

Q: A satellite is located at the 35,000 Km above the earth surface. It radiates a 10 W of power from…

A: If you are having doubt in any step please comment here. Thank you

Q: Fill out the missing values frequency, f (kHz) Results from in-Lab measurements Calculated…

A: Step 1: Step 2: Step 3: Step 4:

Q: Q6/ A motor is receiving 30% of the power that it is capable of receiving from an infinite bus if…

Q: The entity declaration for the counter is: entity binary_counter is generic (n: integer := 4); port…

A: Here are the design descriptions: Unsigned Variable Architecture: library IEEE; use…

Q: For the circuit below: (a) Find impedance Zt at resonance (b) Circuit voltage at resonance (c)…

A: The objective of the question is to find the total impedance at resonance, the circuit voltage at…

Q: QUESTION 2 Identify which safety equipment was used when you soldered the PCB (choose all which…

A: Typically, the following safety gear is utilised when soldering a PCB:• A. Safety glasses: They…

Q: Suppose we have the following discrete time signal: x[n] = 2(0.8)¹u[n - 1] Let X10 [k] represent the…

A: Given:we need to find:now consider, we need to find:

Q: please dont use AI, solve on paper

A: Value of ri after running LDR r1, [2017(2)]:When we're dealing with endianness, we're essentially…

Q: Hello, I am very confused what is a hyrbrid pi model. Can you please make a hypbrid pi model from…

Q: None

A: A balanced load refers to a condition in an electrical system where the power consumed by each phase…

Q: make a protection circuit with a UMW SI2301A pchannel mosfet

A: To design a protection circuit using the UMW SI2301A P-channel MOSFET, let's consider a simple…

Q: Consider a regulator system with a plant given by: 0 1 0 x = Ax+ Bu, A = 0 0 1 B = 0 L-1 -5 -6] The…

A: To design a state feedback controller for the given system, we need to compute the gain matrix ( K )…

Q: Question #3 A resistor, denoted as R,, is added in series with the inductor in the circuit in Fig.…

A: Step 1: Step 2: Step 3: Step 4: Step 5:

Q: 4. For the following problem v(t) = 5 sin(200πt). If the RC time constant in the following circuit…

A: Step 1:Step 2:

Q: The diodes are identical, they have the same reverse saturation current. Find the value of R for…

A: Step 1:Step 2:

Q: Question #7 DESIGN 15.3 a) Using the circuit in Fig. 15.1, design a low-pass filter with a passband…

Q: A source-free RC circuit contains a 1 ohm resistor and a 10 mH inductor initially charged to 1…

A: The given data is shown below:

Q: this question is provided with answer. I just need to some details and explanation.

A: The image shows an electronic circuit that includes an operational amplifier (op-amp), resistors R1…

Q: 1. A DC Wheatstone bridge contains three resistors whose resistance values are constant at 300 2,…

A: Step 1:Step 2:Step 3: Step 4:

Q: Please provide the truth table and circuit design for the following: Use D flip-flops to design a…

A: Step 1:Step 2:

Q: no ai, answer step by step

A: Step 1:IF YOU HAVE ANY DOUBT YOU CAN COMMENT HERE

Q: M1: 4) This circuit employs negative feedback near-zero frequencies to prevent "latch-up" and has…

A: The question is asking whether a given circuit is oscillating. The circuit employs negative feedback…

Q: please help i will like

A: Hope this helps

Q: 6. Test for complex roots in solution to the following quadratic equation: ax2 + bx + c=0 The…

A: Detailed explanation:The above assembly is designed to calculate the discriminant of a quadratic…

Q: Please answer in typing format

A: System DescriptionThe system consists of two masses, labeled as m1 and m2.Springs (k1) and (k2)…

Q: Two capacitors (25 and 75 F) are connected to a 100-V source. Find the energy_lin mJ stored in the…

A: Capacitor:Voltage,

Q: please have step by step solution and explain

A: please give helpful rating and thank you so much....

Q: What is the algebraic sum of the voltages and the currents around the loop in a circuit ?

A: In this question, we need to determine the algebraic sum of the voltages and the currents around the…

Q: Example1: Consider the following RLC circuits, Find minimum and maximum resonant frequency using PSO…

A: The objective of the question is to find the minimum and maximum resonant frequency of an RLC…

Q: A digital combination lock has four states: closed, 1/3 open, 2/3 open, andopen. It is opened using…

A: a) Here's the State Machine diagram for the described digital combination lock:- Explanation:The…

Q: We have a band-pass filter, where the system has a sampling rate of 48 ksps, the filter will allow…

A: Given information:A system that works with a sampling rate of 48 kpsp and requires a bandpass filter…

Q: 3) Case 1: After a sufficiently long time, the switch moved from position o to position 1 @ t=0.…

Q: In the figure below, R₁ = 9.00R, the ammeter resistance is zero, and the battery is ideal. What…

A: Step 1:Step 2:

Q: A 400V three-phase, four wire dystem has the following loads connected: Phase 1: Load impedance Z1=…

Q: 02: Using the following discrete sequence definitions -2 n = 0,1,2 x(n) = 1 n = 3,4 0 elsewhere and…

Q: 1) Make use of Maxwell's equations to find the relative permeability of a material, which has σ = 0…

A: Step 1: Step 2: Step 3: Step 4:

Q: Given a function f(t) that has a fouriertransform from image. Find f(t) Hint: Calculate f(-t) first

Q: please solve on paper

Q: Please do not rely too much on chatgpt, because its answer may be wrong. Please consider it…

A: Let's check Option 3Option 1:Option 2:Option 4: If you are having doubt in any step please…

Q: 15) 63 (a) Determine the Fourier transform of the signal x(t) = exp(−t) sin(20лt) u(t), where u(t)…

A: Step 1:Step 2: Step 3: UP VOTE IF YOU LIKE THE SOLUTION.

Q: Fill the blank A) 2.000 sin (5t - 9°) at t= 0, 0.01, and 0.1 s. (Round the final answer to four…

Q: None

A: The objective of the question is to design a lead compensator for a given open loop transfer…

Q: Develop a flowchart for the digital compensator below. Gc(Z) = (X(Z)/E(Z)=(Z+0.5)/(Z2 - 0.5Z + 0.7)

Q: 3. Use superposition to determine the current I in the circuit shown. 20 V Z0° R www 102 ↑ 4 AZ0° XL…

A: Step 1:Step 2:Step 3:Step 4: The current I=5.367∠−26.565 , I=4.8−2.4J

Q: Q1: Given the joint 'discrete' probability density function (pdf) of X and Y in the following table:…

Q: note: use article 220 NEC , APPLY STANDARD METHOD 1. A house has a floor area of 1000 ft2, The…

A: Step 1Step 2Step 3

Q: Figure x + 3.0 nC 5.0 cm 10 cm -6.0 nC What is the strength of the electric field at the position…

A: Step 1:Step 2:Step 3:

Q: Please answer in typing format

A: Derivation of the above steps clearly:The final answer is:

Q: Q: A 3 phase 10 MVA, HI KV Y connected alternator is protected by Merz-Price -circulating current…

Question

Determine the frequency where the stated component has the given reactance at 20 μF Capacitor with a reactance of 350 ohms and a 20 mH Inductor with a reactance of 2.5 kohms

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

List the five capacitor replacement rules.
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Through a capacitor of capacitance 15 micro-farad with a frequency of 50 hz. Compute its reactance 212 ohms O 4,712 ohms O 0.0047 ohm O 0.0002 ohm
Assume all capacitors = 10 µF. Find total capacitance %3D Ans. 5.45 µF
Problem 6: w- Calculate the voltage across the capacitor every 15 0.1 ms for one complete period of the input waveform. Then, use Multisim to sketch the 25 V (n capacitor waveform. Repeat the calculation and the simulation for a frequency of 2 kHz