Basic Electrical Engineering) An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Basic Electrical Engineering) An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: A car battery has gone dead and it needs to be replaced with a large capacitor. The old car battery…

A: To solve above problem, one should know capacitors and capacitance offered by a capacitor. A…

Q: A coil induces 500 mV when the current changes at the rate of 0.2 A/sec, then the value of…

A: The value of inductance is 2.5 Henry. The detailed solution is provided below.

Q: Solve for the value of the capacitance (in nF unit) if R2 = 1035 ohms and Xc = 2132 ohms. Round…

Q: 14. At what frequency will a 2-μH inductor have a reactance of 300ohm? 15. A 2.5-μH inductor has a…

A: L=2uHXL=300Ω

Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…

Q: "If a current of 5A flowing in a coil of inductance 0.1H is reversed in 10ms, emf induced in it is…

A: In this question we will find emf induced in coil...

Q: 14 Calculate the value of stored energy in an inductor if the value of inductance is 10 mH and 2 mA…

A: Given data, Inductance L= 10 mH =10×10-3 H Current flowing through it i=2 mA

Q: equivalent

A: Here,

Q: To what circuit element does a very large (ideally, infinite) inductance having an initial current…

A: Given that circuit element has large inductance and initial current of 10 A.

Q: How much energy is stored by a 100 mH inductance with a current of 1 A?

A: It is given that: L=100 mHI=1 A

Q: A suspension string has 3 units. Each unit can withstand a maximum peak voltage of 11kV. The…

A: Parameters given are: Maximum Peak Voltage=11kV, Number of Insulator Discs,n=3, The capacitance of…

Q: The energy stored in 2000 turns inductor is 20 Joules, if the inductance value is 3 H. Find, (a)…

A: Inductive coil,

Q: Question 5 An inductive coil has a resistance of 9.5 ohms. A battery of 115V is suddenly connected…

A: Given a inductive coil has, Resistance, R=9.5 Ω Battery voltage, V=115 V Rise current, I = 10 A…

Q: voltage v = 120 sin 377t V is applied across a pure capacitance of 100μF, Determine the energy in…

A: We need to find out energy stored by capacitor

Q: Given L1 6µH, L2 6µH and the equivalent inductance of the circuit Leg = 9.6000µH, then L = μΗ Note:…

Q: The switch (SW) in the circuit is opened for a long time shown Figure 2. A. Calculate the expression…

Q: 100 V 50 8mH 600 200 A The switch is initially open in the circuit diagrammed above. A) What current…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Basic Electrical Engineering 1. Derive the formula for the energy stored in an inductor

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find the mathematical expression for current İ2(t) b) Calculate the complex power on the inductance

Q: When the capacitor is fully charged, how much energy does it store (in Joules, 2 sig figs)? How…

A: The circuit mentioned above employs a capacitor and resistor network in the first loop while the…

Q: Figure shows the waveform of the current passing through an inductor of resistance 1 N and…

A: Inductor is a passive component used in electric circuits. When current flows through an inductor it…

Q: 23. It is desired to operate a 100 W, 120 V lamp at its current rating from a 240 V, 50 Hz supply by…

Q: A circuit possesses an inductance of 1 H when a current through coil is changing uniformly at the…

A: Given: A circuit possesses an, Inductance, L = 1 H Rate of change of current, didt=1 As Opposing emf…

Q: The energy stored in 1000 turns inductor is 15 Joules, if the inductance value is 4 H. Find, (a)…

A: In this question , we will find current flowing through coil and flux linking with coil with given…

Q: Solve for the value of the capacitance (in nF unit) if R2 = 1057 ohms and Xc = 2365 ohms. Round your…

Q: Complete the table below by computing for the equivalent resistance, capacitance or inductance:…

A: We need to calculate the equivalent capacitance for given circuit .we will use series and parallel…

Q: Question 3 (a) Briefly describe the capacitance of a capacitor. i. When area between the plates of a…

Q: W =Cv? The equation above describes the amount of energy stored in a capacitor in joules, W, in…

Q: May you please help me to find equivalent inductance Lab

A: Inductor impedances can be combined in the same as we combine resistances. When two inductors are…

Q: 1. A resistor of resistance 20 ohms is in series with an inductor of inductance 2H. At t = 0, it is…

A: Given data, The value of resistance is R = 20 Ω. The value of inductor is L = 2 H. The value of…

Q: What is the reactance (in Ohms) of a 0.15H inductor at 198rad/sec? (Give answer in 2 decimal places.

A: Here we are given, L= 0.15 H. ω= 198 rad/sec. The reactance(opposition) offered by inductor to flow…

Q: (a) The energy stored in 1400 turns inductor is 10 Joules. If the inductance value is 2 H, Find the…

A: To find the current through the coil And flux linking with the coil in mwb Average induced emf

Q: 1. What is an inductor and what consist of inside?

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: 14 Calculate the value of stored energy in an inductor if the value of inductance is 10 mH and 2 mA…

A: Given data, Inductance L=10 mH. Current flowing through inductor i=2 mA.

Q: 29. A telephone circuit has a capacitance of 6 microfarads. What current flows through it when 15 V…

Q: 10.A 100-µf capacitor is connected in series with a 150-volt voltmeter that has a resistance of…

A: In this question, we need to determine the reading of the voltmeter V, Where sensitivity of the…

Q: Complete the table below by computing for the equivalent resistance, capacitance or inductance. L,…

A: Given circuit,

Q: Draw the phasor diagram, also write the voltage and current relation statements for the following…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 37 ohms R2 = 46…

Q: (1) Find equation of current if charge q(t) = 5t2+10t+10. Also find value of current at t = 1sec.…

A: (1) Given values are - qt=5t2+10t+10

Q: In your solution, follow the sequence: Given, unknown, solution, and final answer. BOX your final…

A: Use ac network analysis Impedance for ac circuits

Q: An inductor has an inductance of 0.025 H and a wire resistance of 3 . How long will it take the…

Q: n a minimum of 10 sentences: 1. Define resistance, inductance, and capacitance. 2. Describe how…

A: Resistance : Resistance of any circuit is the opposition of current flow in the circuit it resists…

Q: Determine the equivalent inductance of the figure.

A: Brief description: For the given circuit by the clear identification of the placing of the dots we…

Q: Suppose that the equivalent circuit shown in Figure 3.24 accurately represents a real inductor. A…

A: The circuit diagram is,

Question

(Basic Electrical Engineering)

An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.
Electrical Engineering I'm reading about the electronics in touch screen. It says when i touch the panel it distorts the electrostatic field and thus will have a change in capacitance. This is how it detects My question is the electrostatic field same as electric field? Please explain in details How did the capacitance change when i just touch the panel
Givens are V1 = 950V, R1 = 44 ohms, R2 = 54 ohms, R3 = 81 ohms, L = 1 Henries. What is the current through the inductor at time t = 0.0074074 seconds?
Find the total inductance at the terminals a-b, for the circuit shown in FigureQ2(b). 25 µH 18 μΗ " a 60 μΗ 20 µH 30 μΗ 75 μΗ 12 μΗ 15 μΗ 38 μΗ Figure Q2 (b)
Here you see a circuit with a battery, fully uncharged capacitor, C and a bulb. What would happen to that electric bulb in the circuit when you switch on the circuit? Moreover, what would be the consequences if you switch off the circuit when capacitor is fully charged? Answer step by step .answer must be correct. Do all calculation follow image.
A 100mH pure inductance is connected in a parallel with a 40ohms resistor. What is the power drawn if the voltage is 220volts and 60hz?
Three 20uF capacitors are connected in series with each other. A 1k ohm resistor and an LED connected in series to each other as well, but branched in parallel to all three capacitors. How long would the LED stay lit after power is removed? What current would flow through it during the charge cycle if VT=9v?
Determine the total inductance in the below figure. L1 L3=6 mH, and L2 = L 4 = 2 mH. The result should be in mH Calculate Answers to 2 decimal points m m ell L2 illl LA
An R-C series circuit has a supply voltage of 100 V. The resistance is 200 ohms and the capacitance is 0.0001 Farad. Solve for the current "i" at any time "t". Solve for the charge "q" at any time "t".
A capacitor of 1µF is charged to 100 volts and then disconnected from the power supply. A second but uncharged capacitor of 3µF is then connected across the first capacitor. What is the voltage across the parallel combination? O a. 110 volts O b. 45 volts O c. 66 volts O d. 25 volts