A. What length is the Active tension the smallest B. At what length is the Active tension the greatest
Q: 1- What are the Lacrigian equations for the particle in the given figure? A) L=mR6-mgRcos@ B) L=mR6 ...
A: We have to first find kinetic energy of the ball. For that we have to find speed of ball in polar co...
Q: A force (3.2x10^6) is tangentially applied to the top surface of an aluminum cube of side (3.400x10^...
A: Given: The force applied tangentially to the aluminum cube is F = 3.2 x 106 N The length of the alum...
Q: A car's engine generates 80000 W of power as it exerts a force of 6000 N. How long does it take the ...
A: Given that:-Power generated by Car's engine, P=8000 WattExerted force, F=6000 NLet the velcoity of t...
Q: C. 20 200 kg 259 N
A: Given:
Q: Question A plane element is subjected to the stresses as shown. Determine a) the principal stresses ...
A: Answer..
Q: A thin long cylinder of radius 1 cm carrying a charge 5µC/m kept in water. Find the electric intensi...
A:
Q: When the temperature of a metal cylinder is raised from 0.0°C to 95.7°C, its length increases by 0.2...
A:
Q: 1. When the same amount of water and acetone were allowed to flow on a slope, it was observed that a...
A: 1) Acetone is a substance that has the least amount of intermolecular force of attraction whereas wa...
Q: An RL circuit with a 5-2 resistor and a 0.05-H inductor carries a current of 1 A att= 0, at which ti...
A: Given data, R = 5 ohm L = 0.05 H At t = 0, current (I) = 1 A
Q: When the object is in motion, the kinetic friction force on the object is the maximum of the static ...
A: Kinetic friction is the friction acting on the body when it is in motion Static friction is the fric...
Q: Each plate of a parallel-plate air-filled capacitor has an area of 0.0020 m2, and the separation of ...
A: Given, Area A = 0.0020 m2 separation d = 0.020 mm = 0.020 × 10-3 m Electric fi...
Q: 2. Two identically charged one-peso coins are 2 meters apart on a table. What is the charge of one o...
A:
Q: 20- If it is an equation for a particular system, as follows: What are the equations of motion for t...
A: The Lagrange equation of motion is given by
Q: st intensity K- Why? J0+1) = JU +1) = ; hE
A: A diatomic molecule's rotational spectrum is made up of a sequence of evenly spaced absorption lines...
Q: 4. Which is the reference point of a boy leaving from home to school? A. canteen B. classroom C. hom...
A: Given Which is the reference point of a boy leaving from home to school, as following below.
Q: A coil resistance is wound with 45m of 0.12mm diameter wire resistivity 12x10“ 2.m. Calculate the le...
A:
Q: Q1) A 5 kg block initially at rest is pulled to the right along a horizontal surface by a constant h...
A: 1. Given, Mass, m=5kg Force, F=12N A. The friction force act in the opposite direction of the force ...
Q: Ina certain solar house, energy from the Sun is stored in barrels filled with water. In a particular...
A: Specific heat and heat capacities.
Q: 3 Figure 2 is used in questions 3 A Stress Strain Figure 2 Graphs of stress versus strain for 4 mate...
A: The Stiffness of an object is the degree to which it resists deformation in response to an applied f...
Q: With a force of zero to 217 N, an archer can pull her bowstring back 0.390 m. What is the bow's spr...
A: Given Data The intial force is:f1=0 N The force increases is :f2=217 N The length of bowstring pull...
Q: A car's engine generates 80000 W of power as it exerts a force of 6000 N. How long does it take the ...
A:
Q: The distance between two consecutive bright bands in biprism experiment is 0.32 mm, when red light o...
A: Distance between two consecutive bright or dark bands is called fringewidth β. It is given by the eq...
Q: Detemine the distance y (m) of the centroid C of the trapezoidal area. Take b1-2 m, b2=29 m, and h-2...
A:
Q: Two condenser of capacity 5µF and 10µF are charged respectively to 24 V and 18 y respectively. What ...
A: To find- Common potential when they are connected in parallel=? Given- C1=5 μFC2=10 μFV1=24 VV2=18 V...
Q: An object is at rest in a given frame S. Describe the characteristics of a frame S' in which this ob...
A:
Q: Figure 1 (right): Find the degree(s) of freedom and the type of constraint. Show using the principal...
A: As per rule, allowed to answer first question and post the remaining in the next submission.
Q: Use the following constants if necessary. Coulomb constant, k=8.987×10^9N-m2/C2. Vacuum permittivity...
A: The charges are q1=36 eat, r→1=(-38i-32j-15k)×10-9 mq2=15eat, r→2=(16/3 i-12/3 j-13 k)×10-9ma) The r...
Q: A square steel plate has area Im² and thickness 5 cm. The bottom edge is fixed. A tangential force a...
A: Shear modulus, also known as Modulus of rigidity, is the ratio of shear stress to shear strain that ...
Q: What is the hole diffusion constant (cm2/s) in a piece of silicon doped with 3x1015cm-3 of donors an...
A: Given that:-Temperature, T=350 KMobility, μp=310 cm2/V.sWe know that:-Hole diffusion constant, D=kTe...
Q: What is the binding energy per nucleon (in MeV) for 239Pu ?
A: We know that- Mass of 239Pu nucleus, 239.05216 amu=3.9695541583 x 10-25 kg Mass of each neutron=1.00...
Q: 3. A flywheel is rotating at an angular velocity of 100 rad/s. A brake is applied to the flywheel an...
A:
Q: 6. Consider a qubit used as a clock. The Hamiltonian for the system is H= hw 1)(1, where w is some c...
A: The Hamiltonian of the system is given as H = ℏω |1><1| Where ω = Constant frequency
Q: (b) Coherent light is diffracted by a single slit which is 15 um wide. The central maximum of the di...
A: Answer..
Q: 1. A particle is projected vertically upward in a constant gravitational field with an initial speed...
A: Now if we consider the motion the particle goes up in a retarding potential and comes back to its in...
Q: and Eg 58 x 10-6 is, energies are expressed in electron vol ers. EN is just the sum of the two expre...
A: Given: EA=-1.436r ER=5.8×10-6r9
Q: first minin e central m
A: Given as, , , ,
Q: A 150 lb machine is supported by five springs. Assume that each spring carries one- fifth of he load...
A:
Q: sa wavelength lo e visible light reg
A: The given region as,
Q: For a particle with a mass of 2 1029 kg, the positional uncertainty is 10. Determine the smallest am...
A:
Q: 13) If 0.5 mm of lead attenuates an x-ray beam by 91%, 0.25 mm of lead will be expected to attenuate...
A:
Q: Identify Xin the following nuclear reactions: (a)H+Be-X+n; (b)12c + ?+ -- X: [c}15N+ ?H-4He+X. (a) N...
A: According to the guidelines of Bartleby, we are allowed to solve only 1 question, so if you want oth...
Q: 4. For the potential V(x) = { if 0 a. calculate the product of the uncertainties O„ơ, for the secon...
A:
Q: A metal with body centered cubic (bcc) structure show the first (i.e. smallest angle) diffraction pe...
A:
Q: Question 05: observer S1 along its x-axis. A positron passes by the electron moving at 0.9c in the o...
A:
Q: The mass m in the given figure is attached to a rigid rod with an inertia /about the pivot and negli...
A: Consider the spring is at its free length when z=0 and θ=0. The modified functional diagram of pendu...
Q: 2. What will be formed when a protium and a deuterium fuse together?
A: In question 2 it is asked what happens when we fuse protium and deuterium together By bartleby pol...
Q: For al order reaction with half life period of 50 min, find conversion after 21 min. O a. 0.3535 b. ...
A: Given that:A first order reaction, n=1Half life, t1/2=50 minTime t=21 min
Q: In order to stop a 15.0 kilogram block from sliding down a frictionless 40.0° incline, a powerful sp...
A:
Q: A capacitor is charged to a potential of 12.0 V and is then connected to a voltmeter having a total ...
A: Given that,The potential : V = 12 (V)Total internal resistance : r = 3.40 (MOhm)Time : t = 4 (sec)Vo...
Q: ation is found n= ts, compute the i
A: Given as, Nd=2.6×1014cm-3,Na=1.4×1014cm-3,no=1.3×1014cm-3.
A. What length is the Active tension the smallest
B. At what length is the Active tension the greatest
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
