A solution has a concentration of 10^-4 x 1.54 with respect to X and has a permeability of 0.0874 when measured with a cell with a path length of 2 cm. What concentration of X is needed for the permeability to increase by a factor of 3 When a cell with a path length of 1 cm is used

A solution has a concentration of 10^-4 x 1.54 with respect to X and has a permeability of 0.0874 when measured with a cell with a path length of 2 cm. What concentration of X is needed for the permeability to increase by a factor of 3 When a cell with a path length of 1 cm is used

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter18: Introduction To Electrochemistry

Section: Chapter Questions

Problem 18.14QAP

See similar textbooks

Related questions

Q: Methanol is known to be the simplest alcohol, and is used as an antifreeze agent, a solvent, a fuel…

Q: Five grams of ethane are confined in a bulb of one liter capacity. The bulb is so weak that it will…

Q: same volume of ethyl ether vapor to pass through the same hole? b) What volume of chlorine will…

A: Molar mass of O2(M1) = 32 g Molar mass of ethyl ether(M2) = 74 Rate of effusion = Volume…

Q: NaOH (aq) + Ni(NO3)2 (aq) Complete ionic equation : Net ionic equation

A: NaOH + Ni(NO3)2

Q: A two-liter sample of mineral water was evaporated to a small volume, following which the potassium…

Q: Chemistry Compound CS2 has a dipole moment u=0 1.Write the type of compound that CS2 is (ionic,…

A: Ionic compound is generated by two opposite ions where covalent molecule is formed by sharing of…

Q: Calculate the pH at the equivalence point for the titration of 0.210 M methylamine (CH3NH2) with…

Q: Given the following balanced chemical equation: Zn + 2 HCl → ZnCl2 + H2…

A: Given :- Zn + 2 HCl → ZnCl2 + H2 Mass of Zn = 25.0 g Mass of HCl = 17.5 g To calculate :- Mass…

Q: What is the molar concentration of a 27% acetone (CH3COCH3) solution?

A: Given: (w/v)% of acetone = 27%

Q: Standardization of a KSCN solution against 0.3341-g of primary standard AGNO, required 21.55-mL…

Q: Which of the following is a secondary alcohol اختبار سري O 3-Methl-1-pentanol 1-Butanol 2-chloro…

Q: Briefly identify a few characteristics of ionic bond, covalent bond, and hydrogen bonds?

Q: A bottle contains 905 grams of chloroform, CHCI3, with a specific heat capacity of 0.96 J/(g.°C).…

A: Given :- m = 905 g Specific heat capacity (c) = 0.96 J/(goC) T1 = 21.0 oC T2 = 30.0 oC To…

Q: Which one of the following forms of radiation has th highest energy? A A = 395 nm B A = 5.70 × 107 m…

A: When a radiation occurs then it is associated to a certain amount of energy.Here different values of…

Q: draw the major product formed from nitration of the following compound

Q: Determine the K, for Cug(PO)>(s) Part A An electrochemical cell is set up in the following…

Q: (b) A 2.000 g of an organic compound X was dissolved in 50.00 mL of dichloromethane. This organic…

Q: Na2SO4 (aq) + BaCI2 (aq)

A: According to the Law of conservation of mass " all atoms of different elements must be equal on both…

Q: Chemistry Rank the following in order of decreasing rate of effusion. F2 SF6 H2 CO CO > H2 > SF6 >…

Q: One mole of photons at wavelength 650. nm has of energy. 184 kI

Q: Compute the standard entropy change for the following reaction: 3N2H4(1) + 403(g) → 6NO(g) + 6H20(1)…

Q: Use standard enthalpies of formation to determine AHºreaction for the following reaction: HCN(g) +…

A: Given- HCN(g)+2H2O(g)->NH3(g)+CO2(g)+H2(g) ∆H°reaction=? ->Answer may be differ slightly…

Q: What volume of 0.05015N potassium thiocyanate solution would be required to titrate the excess from…

A: Solution - Normality and molarity are used to estimate the given problem - So , first we know that -…

Q: Standardization of a sodium hydroxide solution against potassium hydrogen phthalate yielded the…

A: First we would write a reaction between KHP and NaOH. Then Calculate moles of KHP from given mass…

Q: What is the molarity of 30g of table salt in 120ml of water. Density of table salt is 2.17 g/ml.

A: Molarity is the amount of moles of any substance present per liter volume. Molarity = moles of…

Q: Freon-113, C2Cl3F3, has an enthalpy of vaporization of 27.04 kJ/mol and a normal boiling point of 48…

A: Given - - > P1 = 1 atm P2 = 0.1 atm T2 =? T1 = 48°C = (48 + 273.15) K = 321.15 K R = 8.314…

Q: Use standard entropies found in Appendix D of the textbook to do the following calculations. X…

A: Formula for absolute entropy S = S0 - R ln (xP/Ptotal) Where R is gas constant = 8.314 J/K/mole; x…

Q: nb: ilibri e equilibrium law for e

Q: What is the electron domain geometry? Circle a. linear b. trigonal planar c. tetrahedral Number of…

A: Geometry of SCl2

Q: When a ving organism dies, the amount of Carbon-14 in ks system begins to decrease exponentially.…

Q: 2. Convert moles of white and brown sugar to grams and fhen to cups using the conversion, cup of…

Q: NH, cat H он OH cat. H,SO, 2) H,O* 1) LAH 2) H,0

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 1. Determine the structure of the compound with a molecular formula of CAH5CI. The molecule is…

A: IR spectroscopy is an important tool for the determination of the functional group in the compound.…

Q: •Example: A 0.040 M solution of an acid, HA, has a pH of 3.02 at 25 °C. What is the pK, for this…

A: Given that, Concentration of acid, HA (C) = 0.040 M pH of acid = 3.02 We need to find the pKa…

Q: A buffer is prepared by mixing 48.9 g of NH3 and 48.9 g of NH¼CI in 0.683 L of solution. What is the…

A: Given- Weight of NH3= 48.9 gram Weight of NH4Cl=48.9 gram Volume of solution =0.683 L Weight of…

Q: Write a balanced equation for the formation reaction of each of the following substances: (a)…

Q: = -255 kJ/mol and AS°rxn 211 J/mol at 55°C. Do you expect the °rxn to confirm your prediction. 2. A…

A: Spontaneous reaction :- A reaction which takes place on its own without the need of any external…

Q: Calculate the pH of a buffer system containing 1.0 M CH3COOH and 1.0 M CH3COONa

A: Given- Molarity of CH3COOH = 1.0M Molarity of CH3COONa = 1.0 M

Q: 3. Consider the electrophilic aromatic substitution reaction below. Draw three resonance structures…

A: Here we have to explain the cause major product formed in the bromination of anisole in the…

Q: Table 3 Molecules with Multiple Central Atoms Molecule C2H4 H2O2.…

A: Molecular Structure of the molecule can be predicted according to VSEPR rules depending upon the…

Q: 2. Mg dispersion force dipole-dipole hydrogen bond ion-dipole 3.* 3. N-CI------N-Ci O dispersion…

A: Given that, We have to identify the weak forces in the given molecules.

Q: What is the rate law for the following reaction, given the data below? 2 NO + H2 N20 + H20…

Q: N. Chemist mixes 125.0 mL of 0.0250 M sodium phosphate (aq) with 75.0 mL of 0.0500 M calcium…

Q: The molecule carbon tetrachloride (CCl4) has three Raman-active absorptions that occur at 218, 314…

Q: d Po undergoes four decay reactions: B, a, B, a. Step 1. 218 Po undergoes B decay to give 218 At 85…

A: Detail solution is given below

Q: What is the relationship between an atoms number of electrons and its relative stability

A: The electrons of the outermost energy level determine the energetic stability of the atom and its…

Q: Bond H-O H-S H-Te i Energy (kJ/mol) 458.9 i 363 238 There is a trend + : moving down the column, the…

A: Bond energy: It is the amount of energy require to break the bond.

Q: Draw the major product of the reaction. H3PO4 он heat Draw ALL of the beta hydrogens on the…

Q: The radioactive isotope tritium decays with a first-order rate constant k of 0.056 year 1. What…

A: First order reaction is defined as the chemical reactions whose rate only depends on the reactant…

Q: Using information in the figure above, calculate the total world energy consumption in 1975. i x 10…

Question

i need the answer quickly

* A solution has a concentration
of 10^-4 x 1.54 with respect to
X and has a permeability of
0.0874 when measured with a
cell with a path length of 2
cm. What concentration of X
is needed for the permeability
to increase by a factor of 3
When a cell with a path length
of 1 cm is used

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Solution

VIEW

Answer

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The measurement of pH using a glass electrode obeys the Nernst equation. The typical response of a pH meter at 25 00C is given by the equation where contains the potential of the reference electrode and all other potentials that arise in the cell that are not related to the hydrogen ion concentration. Assume that = 0.250 V and that a. What is the uncertainty in the values of pH and [H+] if the uncertainty in the measured potential is 1 m V ( 0.001 V)? b. To what precision must the potential be measured for the uncertainty in pH to be 0.02 pH unit?
Halide ions can he deposited at a silver anode, the reaction being Ag(s) + X- AgX(s) +e- Suppose that a cell was formed by immersing a silver anode in an analyte solution that was 0.0250 M Cl-,Br-, and I -ions and connecting the half-cell to a saturated calomel cathode via a salt bridge. (a) Which halide would form first and at what potential? Is the cell galvanic or electrolytic? (b) Could I- and Br- be separated quantitatively? (Take 1.00 l0-5 M as the criterion for quantitative removal of an ion.) If a separation is feasible, what range of cell potential could he used? (c) Repeat part (b) for I- and Cl-. (d) Repeat part (b) for Br- and Cl-.
Consider the following reaction at 25°C: O2(g)+4H+(aq)+4Cl(aq)2H2O+2Cl2(g) The [H+] is adjusted by adding a buffer that is 0.125 M in lactic acid (HLac) and 0.125 M in sodium lactate (NaLac). The pressure of both gases is 1.00 atm and [Cl-] is 0.200 M. (Kafor HLac is 1.4104 .) Will the cell function as a voltaic cell?
Atomic masses can be determined by electrolysis. In one hour, a current of 0.600 A deposits 2.42 g of a certain metal, M, which is present in solution as M+ ions. What is the atomic mass of the metal?
Using data from Table 17-1, place the following in order of increasing strength as reducing agents (all under standard conditions). Cu+,F,H,H2O,I2,K
A 0.0712-g sample of a purified organic acid was dissolved in an alcohol-water mixture and titrated with coulometrically generated hydroxide ions. With a current of 0.0392 A, 241 s was required to reach aphenolphthalein end point. Calculate the equivalent mass of the acid.
An aqueous solution of an unknown salt of vanadium is electrolyzed by a current of 2.50 amps for 1.90 hours. The electroplating is carried out with an efficiency of 95.0%, resulting in a deposit of 2.850 g of vanadium. a How many faradays are required to deposit the vanadium? b What is the charge on the vanadium ions (based on your calculations)?
The cell Ag|AgCl(sat’d)||H+(a = x)|glass electrode has a potential of —0.2094 V when the solution in the right-hand compartment is a buffer of pH 4.006. The following potentials are obtained when the buffer is replaced with unknowns: (a) —0.2806 V and (b) —0.2132 V. Calculate the pH and the hydrogen ion activity of each unknown. (c) Assuming anuncertainty of 0.001 Vin the junction potential, what is the range of hydrogen ion activities withinwhich the true value might be expected to lie?