A circuit whose resistance is 20 Ω and inductance of 10 H has a steady voltage of 100 V suddenly applied to it. For the instant of 0.5 second after the voltage is applied, determine the total power input to the circuit.

A circuit whose resistance is 20 Ω and inductance of 10 H has a steady voltage of 100 V suddenly applied to it. For the instant of 0.5 second after the voltage is applied, determine the total power input to the circuit.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 51.31-ohm resistor,…

Q: Consider the electric circuit consists of two coils, as shown. The self inductances of coils are…

A: The given circuit is excited with the current i(t) = I0 Sin(wt) from the primary side. The secondary…

Q: Part A R = 1020 N, L = 150 mH, C = 190 µF, and i, = 10 cos 5000t A in the circuit shown for t in…

Q: A circuit has a resistance of 12 Q and capacitive reactance of 16 Q in series. If the applied…

A: Kirchhoff's voltage law: It states that in any closed circuit or loop, the total voltage around the…

Q: 1.5kQ 50mH 20µF Vin 5 Vpk 50 Hz 0° Figure 2 Discussion: Q2\ For the circuit in fig. (2) Change the…

A: Given circuit consists of resistor, inductor and capacitor in series. The frequency of supply is…

Q: Problem 10. A coil consists of a resistance of 100 2 and an inductance of 200 mH. If an alternating…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A 40 Ω resistor and a 50 μ F capacitor are connected in series and supplied with an alternating…

A: It is given that:R=40ΩC=50μFV=283sin314t

Q: 1 H 26 cos 31 V

Q: 2 A voltage e(t) = 100sin 314t is applied to a series circuit consisting of 10ohms resistance, 0.0…

A: In this question series RLC circuit is given....We have to find out expression for current , phase…

Q: . For the circuit shown, what is the reactance of the capacitor? (Ohms) 2. What is the real power…

Q: Determine the steady state voltage, v(t) in the form A cos(wt + 0) V 2.5H 20 N 10 mF wHE 5 mF + 10…

A: In this question, Determine the steady state voltage, v(t) in the form Acos⁡(ωt+θ) V We know XL =…

Q: 3. A voltage e(t) = 100 sin 314 t is applied to a series circuit consisting of 10 ohms resistance,…

A: Given e(t)=10sin314t R=10 ohms L=0.0318H C=63.6uF

Q: Short Problem: Given a parallel RLC circuit comprised of the following element 69.73-ohm resistor,…

Q: Determine the capacitor voltage in Volts (V), power in milliwatts (mW), and stored energy in…

A: In this question, At time t= 0 switch is open. Find the voltage across the capacitor and power and…

Q: Problem: Given a parallel RLC circuit comprised of the following element 00.73-ohm resistor, ideal…

A: True power will be power dissipated in resistor .

Q: In a single graph, sketch v=100 cos(ωt+ϕ) versus ωt for ϕ=−60∘, −30∘, 0∘, 30∘, and 60∘.1. State…

A: (a) Referring to the given signal, the graph of the function with respect to the frequency component…

Q: 3. Find the expression for the instantaneous values of the voltages across the resistance (VR),…

A: Given series RL circuit shown i=414sin2πft Af=50 HzR=100 ΩL=0.31831 H

Q: PROBLEM 4: In the circuit shown, 2.5 N b + 4.5 V| a 6.2 V+ Determine the following: A. Magnitude and…

Q: A source of angular frequency 1 rad/sec has a source impedance consisting of 1ohms resistance in…

Q: 3- The charge on the capacitor in the network of Fig. is 2 coulombs. If the switch K is closed at…

A: (a) E = 100 V The initial charge is q(0) = 2 C The initial voltage across the capacitor, VC(0) =…

Q: Assume that steady state DC conditions exist. A. Determine the energy stored in each capacitor and…

A: For the DC conditions, the capacitor acts as an open circuit which opposes the change in the…

Q: 5. In the circuit shown, a Determine the following: 2 v+ A. Magnitude and direction of the current…

Q: 1Ω + Vs +. 1 F v(t) 1 H ?For the circuit shown above, what is the amplitude of the voltage v(t)…

Q: What is the maximum current delivered to a circuit containing a 2.80 µF capacitor when it is…

A: Given: Circuit capacitance, C=2.80 μF

Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 50.31-ohm resistor,…

A: In this question we will find reactive power..

Q: A resistance R, an inductance L, and a capacitance 10 µF are connected in series as shown in the…

A: We need to find out the value of resistance and inductance for given circuit

Q: Course: Electrical Engineering Subject: Electrical Apparatus Instructions: • Write the GIVEN with…

A: In this question we will find complex power , apparent power , real power , reactive power and power…

Q: Q3(a) A pure inductive coil allows a current 40 A to flow from a 230 V, 50 Hz supply, Calculate the…

A: Impedance of coil =voltage across coilcurrent flowing through coil. inductive reactance=2×π×f×L.…

Q: On a really cold day (prior to COVID), the University of Calgary campus was consuming 10.3 MVA of…

A: The given information is: Apparent Power, S=10.3MVA Power factor of the load, pf=cosϕ=0.94lagging…

Q: 2. The coil having a resistance of 10 N and an inductance of 0.2 H is connected to a 100-V, 50-Hz…

Q: ure inductance of L = 144 mH 118 V, 50 Hz supply. The cure ctor is given by

Q: Given a parallel RLC circuit comprised of the following element: 78.38-ohm resistor, ideal inductor…

Q: 2. Refer to the circuit depicted in Fig. below. Find theaverage power absorbed by each element.…

A: The solution is given below

Q: Q3:- An industrial process has an output of 5 Kw, an efficiency of 85% and a power factor of 0.75…

Q: Course: Electrical Engineering Subject: Electrical Apparatus Instructions: • Write the GIVEN with…

Q: 29. A telephone circuit has a capacitance of 6 microfarads. What current flows through it when 15 V…

Q: Q1/ Determine the value of the capacitance, C for the circuit shown in Fig.(1) The network function…

A: The circuit is shown below: The output voltage is given the voltage division rule,…

Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 87.48-ohm resistor,…

A: In this question we will find true power in circuit...

Q: b) Evaluate the voltage v(t) for t = 0.25 sec, t = 0.50 sec, and t = 0.75 sec and use your results…

A: Given data: i(t) = 50 e-5t mA and Capacitor value = 1000 microfarads (a) To find V(t) i(t) =…

Q: Electrical Engineering In the circuit shown, the voltage source has the form V. (t)=9 cos(400t)…

Q: 4. Ine current drawn in a series circuit consisting of a 150 uF, a resistance of 10 Q and an…

Q: 5 cos 400t A V1 2 5 mH 1/800 F -(¹/8)U1

A: Average power: Average power is the total useful power of the circuit that is utilized by the ac…

Q: A certain circuit element is known to be a resistance, an inductance, or a capacitance. Part C…

A: Given, voltage across the element is: v(t) = 200 cos(100t+50o) V And, the current across the element…

Q: A coil, with 100 mH of inductance and 10 Q of resistance, has been connected to an C power supply…

Q: 4. Many engineers are working to develop photovoltaic power plants that provide ac power. A model of…

A: Average of the instantaneous power in one cycle is called average power. The complex power is…

Q: For the circuit given below, find the value of V, at steady state condition. 4 kfl 2H 16 V O A. V =…

A: At steady state condition all inductor behave as short circuit.

Q: Example: A 47µF capacitor is connected to a voltage which varies in time as v(t) = 20sin(200xt)…

A: Given circuit is - Given values are -

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(Basic Electrical Engineering) A series circuit consisting of a 13-ohm resistor, 0.05 H inductor and a 10-microfarad capacitor is connected across a 100V. Determine the frequency of the supply if the current flowing is 5A. Show complete solution and limit your answer jnto three decimal places.
Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R2 R3 www 552 R1 ww 3022 1022 =1pF 2 =.04μF Hii 1H
A Capacitance of 40 micro-Farad is connected across a 230 V (RMS), 60 cycles supply. What will be the value of the RMS current. 1.256 A 2.363 A 3.468 A 5.367 A
The circuit in the figure is fed by a sinusoidal alternating voltage with a frequency of 50 Hz. The circuit consists of a resistor and a capacitor with the capacitance C= 300 μ Q. The power supplied to the circuit is P=100 W and the voltage across capacitor is UC=120 V. a) Calculate the current I. b) Calculate the resistance R. c) Calculate the voltage U (amount). d) Calculate the phase angle of the circuit
Direct current (DC): * Alternating current is that varies sinusoidally with time It is a current that remains constant with time. difference in electric potential energy A branch is: * is any closed path in a circuit a single element such as voltage source or current source or a resistor. the point of connection between two or more branches
A certain circuit is in steady state. It is composed of a resistor R = 40kΩ in series with an inductor L = 1mH connected across a dc source voltage of 24V. If the switch is turned off, determine the time it takes for the voltage across each element is equal and determine the rate of change in current at this time.
A resistance of 10 ohms is connected in series with an inductance of 0.05 H and a capacitance of 300 µF to a 100 V supply. Calculate the power factor of the circuit when the frequency is 25 Hz?
Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100t) volt R3 R1 R2 ww 1052 552 3002 .04µF 1H =1pF
A resistance of 10 Ω and an unknown inductance are connected in parallel to a 110-Vac, variable frequency source. When the frequency is 50 Hz, the current drawn by the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.
A 70 capacitor is connected in series with a coil with an ohmic (effective) resistance of 4 Q and an inductive reactance of 10 Q. A voltage of volts was applied to the circuit . What is the effective (active) power of the circuit? v 250v2. sin 27 ft %3D 10 kW O 1000W O 5 kW O 100000W O 10 MW
2) What is the equivalent inductance of the following circuit?