A capacitor has two dielectrics 2 mm and 3 mm thick. The relative permittivities of these dielectrics are 2 and 4 respectively. Calculate the potential gradient along the dielectrics if a p.d of 1000 V is applied between the plates.

A capacitor has two dielectrics 2 mm and 3 mm thick. The relative permittivities of these dielectrics are 2 and 4 respectively. Calculate the potential gradient along the dielectrics if a p.d of 1000 V is applied between the plates.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Related questions

Q: A lead acid battery fitted in a truck develops 29V and has an internal resistance of 0.04 ohm.. It…

A: We have an Lead acid battery fitted in a truck witn, Generated Voltage (Eg) = 29 V Internal…

Q: Can an induced electric field create a current in the loop?

A: Current:- It is a passive electric element. In any circuit sum of incoming current should be equal…

Q: 5. What is static synchronous compensator (STATCOM)? What is the main advantages/disadvantages of…

A: STATCOM and SVC: STATCOM is also known as a static synchronous compensator which is a controlled…

Q: 4. Find Vo and lo in the circuit. 18 V (+) 2K0 3K 4K6 Vo X ΓΧΩ ска Io

A: Given data: A network of voltage supply and resistors DC voltage supply, V = 18 V 5 resistors, 2…

Q: Find the upper and lower limits for the system shown below. (Show me your work in details)

A: The heater input voltage and the corresponding temperature waveforms of the system are shown below,

Q: a) A 50 Hz, 4-pole turbogenerator rated 500 MVA, 22 kV has an inertia constant of 7.5 MJ/MVA. Find:…

A: Given- 4-Pole turbogenerator. P=4. G=500 MVA, 22 kV. Inertia constant H=7.5 MJ/MVA. To Find- (i)…

Q: The two wattmeter method is used to measure the power in a three-phase load. The wattmeter readings…

A: Given- Three phase load-Wattmeter readings=400W & (-35) WTo Find-The total active power Pactive

Q: 4. An emf e₁ = 100 sin 2л60t is in series with an emf e₂ = 120 sin 2л60t. a. Sketch the waveform of…

A: The emf connected in series can be added to form a single emf source. The given sinusoidal…

Q: A daily load curve which exhibited a 15-minute peak of 3000 kW is drawn to scale of 1 cm = 2 hours…

Q: An alternating voltage is represented by V = 100 sin (2nt/0.01667). (1) Maximum value of voltage (2)…

Q: 1. Find voltages V₁, V2, and V3. SA ← 20 4.2 Mr t V₂ 62 10 A

A: We need to find out node voltage for given circuit

Q: Compensator function as

A: Compensator function as specialized filters.

Q: The voltage across an inductor with inductance of 18 mH is given by t<0 (V) t≥0 v₁ (t) = {e-st (V)…

A: Given: Voltage across inductor : vLt=0 t<0e-5t V t⩾0 where L=18 mH and iL=0 for…

Q: Vs R₂ R32 R4 B RL VTH RTH RL B Figure 1a) Simple circuit to be analyzed Figure 1b) Thevenin's…

Q: Determine the efficiency of a high frequency induction furnace which takes 10 minutes to melt 1.815…

A: Given- Mass of aluminium m=1.815 kgInitial temperature t1=15oCtime t=10 minutesinput power Pi=5 KWTo…

Q: Q: Draw output voltage waveform for this circuit if ß=50. +10v +5v -1vF Vi 2 3 4 t(ms) 50k +10v 10k…

Q: Q2: Using Nyquist criterion, study the closed loop stability of the system, whose open loop transfer…

A: Given data: Open loop transfer function, GsHs = s +1s-2s+2 To find: The closed-loop stability of…

Q: find it at t20 s. 12ucts Y. 1 kr. ikn. HEM 1ª MF 1kr zuc-t, mA. (S. 1 ke. PUSHE

Q: Using 2’s complements, find the following sum: −4 −11

A: Determining the 2's complement equivalent number. -4:+4=00100changing into 1's complement:…

Q: Calculate the theoretical barrier height, built-in potential barrier and Schottky barrier width in a…

A: SOLUTION Given--> Si/Cr Junction Diode…

Q: Find the equivalent inductance of the circuit shown in Fig. 6.31. Leg 4 H m m 8 H 7 H 20 H m m 10 H…

A: Given circuit,

Q: A 4 pole d.c. motor takes a 38.6 A armature current. The armature has lap connected 350 conductors.…

A: We have an DC motor with, Poles = 4 Also P = A so, A = 4 Armature current (Ia) = 38.6 A Armature…

Q: Solve the output voltage Vo of the given circuit below. ID1 32 V Ge Si ID2 Vo

A: Diode is unidirectional device. When P side of diode is at higher potential than N side the diode is…

Q: A separately excited DC motor rated at 200 V, 900 rpm, 160 A, has an armature resistance of 0.065 ,…

A: We have been given an separately excited DC motor, Rated Voltage = 200 V Speed (N) = 900 rpm Current…

Q: 2. A current of 6 A flows for 10 minutes. What charge [3600 C] is transferred?

Q: The Stokes theorem uses which of the following operation O a. Laplacian O b. Divergence O c.…

A: Stokes theorem: According to stokes theorem, the close line integral of any vector function is equal…

Q: Find the equivalent resistance RabRab for the circuit shown in (Figure 2). be 1.2 ΚΩ 4 kΩΣ 30 kΩΣ…

Q: A signal is sampled at 384 000 samples per second. The samples are encoded as 32-bit words a)…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find the average value of the voltage in the figure m 5V ov+ O 1.59 V O 63.7 V O 6.37 V O 10.5 V

A: Given a waveform Asked to find average value of the voltage Maximum value(Vm) = 5V

Q: A 440/110 V single phase transformer when operated at no load has 6 A No current takes at 0.25…

A: solution: Given data; single phase transformer: 440/110 V, no load current Io=6 A, cosϕo=0.25,…

Q: Define amplitude-modulated signal

A: Given: Define amplitude-modulated signal.

Q: 3 Ampere current is flowing in a circuit having resistance 40 ohms. Find the woltage applied to the…

A: Given: In a circuit, Current I=3 A. Resistance R=40 Ω.

Q: Calculate the seg based on the following information. Weight of carrier = 1.57 kg./m. diameter of…

Q: Q3:-Using superposition, determine the current through the (6 ) resistor for network of Fig.2.…

A: It is given that:

Q: Consider the sine curve shown below: V Time The time it takes to trace the wave pattern from the…

A: Given- Time to trace wave from peak of a wave to second trough = 8msec Peak voltage = 10 Volts To…

Q: Vo below. the given cir ID1 Ge 31.3 V 17.6 V 39.3 V 32 V 31.7 V Si ID2 6.8 kohms 4 V Vo

Q: A three phase line 30 km long delivers 2000 KVA at 33 kV voltage, 0.707 lagging power factor. If…

Q: Q1/ To Design 20-bit BCD adder can using 5 (4-bit binary adder), 10 F.A and 2 H.A O 2 (8-bit binary…

Q: 1.You are synthesizing a chip composed of some logic with an average activity factor of 0.1. You are…

Q: Plot the following signals: 1. (a) y(t) = f 8(x)dx (b) 92 (t) = f(x-t)dx (c) ys(t)= (t(u(t)-…

Q: IF apc = 0.99, Ic = 6 mA and IcBo = 15 μA, what is the value of Ig? 1. 45 μα 2. 55 ΜΑ 3. 50 μα 4. 60…

A: Given: In a transistor, αDC=0.99,IC=6 mA,ICB0=15 μA.

Q: If the power absorbed by the 4-k02 resistor in the circuit shown is 36 mW, find VS. Vs +1 Μ 9 ΚΩ 12…

A: Given data, Power absorbed by 4 kΩ resistor is 36 mW Circuit diagram is given as,

Q: Find the current through the diode in the circuit shown in Fig. 6.10 (i). Assume the diode to be…

Q: Keep the Diagram neat. Thanks Build a 4*16 decoder using only 2*4 decoders

A: In the given questions we need to find that hiw many 2*4 decoder required to design 4*16 decoder.

Q: Ry ASAR ABDUR RASURAREN AZIN ASIA ASIO R₂ 120 R120 R120 Fig. (2) R20 Fig. (3)

Q: An interconnection reactor system is shown in fig.. The base values for the given percent reactances…

Q: Transmission with bit rate = 4096Mbps with role off factor = 0.4 No = 6 x 10-12 The .... (Watt) 700…

A: Given data, Bit rate Rb=4096 Mbps Role of factor α=0.4 N0=6×10-12 W/Hz Bandwidth B.W=700 kHz

Q: What is RG rating of coaxial cable. Please give me detailed information. Don't copy previously given…

Q: Question 1 The unit of magnetic flux density B is; 1. a) Tesla per sq. m. 2. b) Tesla 3. c) Weber 4.…

Q: Discussion of power quality aspects that need to be considered before installing the power factor…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
4. In what form is the energy of a capacitor stored?
Which of the statements below are correct I. Capacitors use electric field to store current. II. Inductance is increased with permeability of the core material. III. Capacitance of a capacitor decreases with the increasing permittivity of the dielectric. IV. Current of an inductor can not change abruptly. a. Il and IV b. I and || C. None d. III and IV e. Il and II
C) A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad. The full scale deflection is 110°. Determine the inductance of the instrument while measuring a current of 20 A. The mutual inductance at 0° deflection is 4 u H and the change in mutual inductance is linear with the deflection.
Qno.3 If the equivalent capacitance between a and b is 10„F for the combination of capacitors shown in Figure 2. Calculate the value of capacitance "x" All capaci- tances shown in figure are in pico farads. 4.0 10.0 X 2.0 Figure 2
Web/Home F4 Search F8 F9 c) Some capacitors are marked 45micro farad save working voltage 25V. On a circuit diagram show how a number of these capacitors may be connected to show a capacitor of capacitance; 45 micro farads safe working voltage of 50 volts. 75 micro farads safe working voltage of 25 volts. 1. I.
6 6 - A dielectric is a material that is: A) a semiconducting B) a nonconducting C) a superconducting D) none of them E) a conducting