A capacitor C is charged by a constant voltage source (U= 1 V). Source and capacitor areconnected by a resistor R with 10 k. The voltage at the capacitor is denoted as Uc.10 kQ1 VThe charging characteristics is shown in the following graph.Uc/U in a.u.0.80.60.40.20.20.4 0.6time in s0.8U₁×10-7a) Please determine the time constant . If necessary, add information to the diagramabove.b) Please calculate the capacitance C.c) When the constant voltage source is replaced by an alternating voltage source with asinusoidal output, please derive the magnitude of the transfer function H(jw)=Uout/Uinwhen yout is the voltage at the capacitor for w→ 0 and w →∞.What kind of filter is obtained?How can the filter characteristics be inverted?

The given circuit diagram is shown below. Volts..

Answered: A capacitor C is charged by a constant…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PA: You are an electrician working in an industrial plant. You discover that the problem with a certain...

See similar textbooks

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
A 10-9.F capacitor (1 nanofarad) is charged to 50 V and then disconnected. One can model the charge leakage of the capacitor with a RC circuit with no voltage source and the resistance of the air between the capacitor plates. On a cold dry day, the resistance of the air gap is 3× 1018 2, on a humid day, the resistance is 6 × 10° 2. How long will it take the capacitor voltage to dissipate to half its original value on each day? ... On the dry day, it will take seconds.
To measure the capacitance C of a capacitor, you attach the capacitor to a battery and wait until it is fully charged. You then disconnect the capacitor from the battery and let it discharge through a resistor of resistance RR. You measure the time T1/2 that it takes the voltage across the resistor to decrease to half its initial value at the instant that the connection to the capacitor is first completed. You repeat this for several different resistors. You plot the data as T1/2 versus R and find that they lie close to a straight line that has slope 9.00 μF. What is the capacitance C of the capacitor?
Two capacitors A and B having capacitance of 20uF and 30uF respectively are connected in series to a 600v supply. Determine the p.d across each other. If a third capacitor C is connected in parallel with A and it is found that p.d across B is 400v, calculate the capacitance of C and energy stored in it
a. Show how you would connect all five capacitors to get a maximum capacitance and find the maximum capacitance in terms of C. b. Show how you would connect all five capacitors to get a minimum capacitance and find the minimum capacitance in terms of C.
A parallel plate capacitor has an electrode area of 100 mm2 , with spacing of 0.1 mm between the electrodes. The dielectric between the plates is air with a permittivity of 8.85*10-12 F/m. The voltage on the capacitor is 100 V. The stored energy in the capacitor is ?
Three capacitors each of the capacitance C are given. The resultant capacitance 2/3 C Can be obtained by using them ? a)Two in parallel and third in series with this combination b)All in parallel c)All in series d)Two in series and third in parallel across this combination
Please help will upvote for sureFor the circuit below:a) What is the maximum current at any time in the circuit?b) Write Equation of capacitor voltage in any time and find the capacitor voltage at t=1msec, t=10msec, t=1sec and t=10sec?d) Draw the capacitor voltage and current signal versus time axis and sign four different time values in (c) on it?
Two capacitors give an equivalent capacitance of 9.00 pF when connected in parallel and an equivalent capacitance of 2.00 pF when connected in series. a.) What is the capacitance of each capacitor? b.) John was asked to design a capacitor in which small size and large capacitance were required. He said that he can achieve that by inserting a piece of paper between the plates. Do you agree with him? Why? Is there anything else that could be done to increase the capacitance?
The figure below shows a simple RC circuit with a 3.50-µF capacitor, a 3.60-MQ resistor, a 9.00-V emf, and a switch. What are the following exactly 6.50 s after the switch is closed? S C R (a) the charge on the capacitor (b) the current in the resistor µA (c) the rate at which the capacitor is storing energy (d) the rate at which the battery is delivering energy
Please show you detailed solution Number 44 A capacitor passes a current of 12.6 mA when supplied with 20-V AC with a frequency of 1000 Hz. The capacitance will A. 10 µF C. 10 nF B. 100 µF D. 100 nF

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS