50 Hz, 11 kV Consider a three-core, three-phase, cable whose conductors are denoted as R, Y and B in the figure. The inter-phase capacitance (C₁) between each pair of conductors is 0.2 µF and the capacitance between each line conductor and the sheath is 0.4 μF. The per-phase charging current is C₁ (B) C₂ C₂ (R) C₁ C₂ Outer sheath

50 Hz, 11 kV Consider a three-core, three-phase, cable whose conductors are denoted as R, Y and B in the figure. The inter-phase capacitance (C₁) between each pair of conductors is 0.2 µF and the capacitance between each line conductor and the sheath is 0.4 μF. The per-phase charging current is C₁ (B) C₂ C₂ (R) C₁ C₂ Outer sheath

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.8MCQ: An ac resistance is higher than a dc resistance. True False

See similar textbooks

Similar questions

We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
1. Enumerate five formulas for five series connected inductances across Vt source and draw the circuit. 2. Enumerate five formulas for five parallel connected inductances across Vt source and draw the circuit.
1.Enumerate five formulas for four series connected capacitances across Vt source and draw the circuit. 1. Enumerate five formulas for four parallel connected capacitances across Vt source and draw the circuit.
The Subject is Basic Electrical Engineering Chapter 15. Conductance, Susceptance and Admittance of AC Circuit.
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
Q3: Two circuits are arrange as shown in figure (1), (a and b) each one of them has two identical conductors , the vertical distance between each conductor in the same circuit is 1 m, the distance horizontlly between circuits is 30 cm, take 1 cm as diamter for each conductors. Derermine the inductance per km of the double circuit ? a a' b' FIGURE (1)
Question A suspension type insulator has three units with self-capacitance C and ground capacitance 0.1C. What will be the string efficiency?
Which of the following is true about all series ac circuits?(a) The voltage across any circuit element is a maximumwhen the current is a maximum in that circuit element.(b) The current at any point in the circuit is always thesame as the current at any other point in the circuit.(c) The current in the circuit is a maximum when thesource ac voltage is a maximum.(d) Resistors, capacitors, and inductors can all change thephase of the current.
Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.
A thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small a relatively small surge limiting inductance B. A fixed capacitance and a relatively large surge limiting inducatance C. A variable capacitance and a relatively small surge limiting inductance D. A Variable capacitance and a relatively large surge limiting inducatnce